Reveiw Arch-2010Board Exam - January 2009 - BT
Reveiw Arch-2010Board Exam - January 2009 - BT
Reveiw Arch-2010Board Exam - January 2009 - BT
JANUARY 2009
c. purlin
d. batten
c. side flange
d floor flange
c. effective depth
d. maximum height of column
TEE, ABIGAIL S.
21 a resot owner wants to renovate his resort at the beach front. He wanted the construction to be fast. What is the mo
to be fast. What is the most appropriate type of cladding should be used for his resort?
a. aluminum cladding
c. steel cladding
b. pre-cast concrete
d. regular CHB
22 What flooring is best for generator room where equipment already provided with a generator pad?
a. plain concrete with hardener
c. vitrified tiles
b. rubber flooring
d. acoustic flooring
23 Which is not a part of a lightning arrseter?
a. down conductor
b. transmitter
c. earthen material
d. lightnin rod
TEE, ABIGAIL S.
c. vinyl tiles
d. plane concrete
c. floor flange
g. lockset
TEE, ABIGAIL S.
44 when a beam is in its elastic limit, which among the situation below would most likely to happen?
a. beam will continue to deform with slight load
b. beam will continue to deform even without load
c. beam will break eventually after some time
d. beam will come back to its original state
45 It is also known as elastic limit.
a. deformation
b. elongation
c. buckling
d. cracking
c. polybutylene
d. vulca seal
c. quarter round
d. half round
48 which among the considerations will best increase the efficiency in airconditoning?
a. decrease floor area
c. increase mounting height of ACU
b. decrease ceiling height
d. decrease slope of roof
49 Which will best increase efficiency in passive cooling?
a. increase floor area
c. increase slope of roof
b. increase ceiling height
d. decrease slope of roof
50 What is produced on continuous process of cold roll and hot roll steel?
a. deformed bars
c. wide varieties of steel
b. wide flanges
d. steel channel
SITUATIONAL QUESTION:
Mr. Owner hired an electrician to prepare and install the electrical wiring for his house.
The electrician, with the consent of the owner, decided to use a larger size of wiring for
the circuit breaker to anticipate overloading. After some time, the house was on fire.
After the investigation, it was proven that the cause of fire was faulty wiring.
51 why did the circuit breaker did not detect the short circuit that happened?
a. the circuit breaker is defective
b. the capacity of the wire is too large to detect the short circuit
c. the circuit breaker is too far from where the short circuit happened
d. all of the above
52 who should be blamed for the fire?
a. the electrician, he used a larger capacity for the wiring
b. Mr. Owner, he did not hire a professional and master electrician for his house.
c. None, some people are just unfortunate
d. None. Short circuit happens all the time.
MONTES, MARIE CHARMAINE L.
TEE, ABIGAIL S.
53 What should have been the appropriate thing that the electrician should have done
to prevent the fire due to faulty wiring?
a. use the appropriate capacity of wiring for the computed load
b. none. His plan and actions were appropriate.
c. Studied more to become Master Electrician and do better electrical plans
d. none of the above
54 Why rags should not be left beside the can of paints at a job site especially during
night time when it is most likely to be unattended?
a. it will increase humidity
c. it will absorb moisture and affect the paint
b. it might ignite a fire
d. rags will be stolen when unattended
55 Which among in the given figures above will not absorb sound?
a. 7" concrete wall
c. 12" double brick wall
b. 9" brick wall
d. 9" CHB wall with ficemboard
56 Which is the most appropriate for a wall of a house in front of a busy highway?
a. figure A
c. Figure C
b. figure B
d. Figure D
57 Which will absorb heat faster?
a. 7" concrete wall
b. 9" brick wall
c. Figure C
d. Figure D
TEE, ABIGAIL S.
TEE, ABIGAIL S.