BGAS Level 2
BGAS Level 2
BGAS Level 2
1. Define viscosity.
12. What is the main difference between the rotathinner and Krebs Stomer?
17. Briefly describe how to do the volatile, non-volatile test to BS 3900 Pt B2.
18. Name the equipment used to determine the flash point of a solvent.
29. For which two reasons could a density cup be used on site?
33. How would the density be affected if solvent was added to paint?
40. What stage of the BK test would be recorded as the drying time?
44. Give one reason why an inspector would use a PIG gauge?
47. What is the reason for taking WFTs immediately after application?
48. Where could an inspector find information to determine if a 2 pack paint was mixed in the correct proportions, using a density cup?
58. What percent reading would be expected when measuring gloss on a glass panel?
60. If an aggregate size of 35 um was present in a paint of 30 um DFT what would be a likely result when using a gloss meter?
61. Name three common tests for determining adhesion of a paint film?
63. Inter coat adhesion and primer to substrate adhesion are two adhesion faults name the third?
66. What criterion is used when assessing a Cathodic Disbondment test panel?
73. What voltage would be used on a 250 um thick paint using a sponge type pinhole detector?
74. What voltage would be used on a 450 um thick coating with a sponge type pinhole detector?
75. When using a wet sponge, what other liquid is added to the water?
80. Other than the wet sponge, which other equipment could be used to determine the presence of pinholes/holidays?