Accelerator Control System: Section
Accelerator Control System: Section
E
CONTENTS
PRECAUTION ............................................... 2 ON-VEHICLE REPAIR .................................. 3 F
ACC-1
PRECAUTIONS
< PRECAUTION >
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER" INFOID:0000000001094798
The Supplemental Restraint System such as AIR BAG and SEAT BELT PRE-TENSIONER, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRC and SB section of this Service Man-
ual.
WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SRC section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
ACC-2
ACCELERATOR CONTROL SYSTEM
< ON-VEHICLE REPAIR >
ON-VEHICLE REPAIR A
ACCELERATOR CONTROL SYSTEM
Exploded View INFOID:0000000000905754
ACC
JPBIA0303GB J
1. Accelerator pedal assembly (LHD models) 2. Accelerator pedal assembly (RHD models)
A. Locating pin
K
: Vehicle front
Refer to GI-4, "Components" for symbols in the figure.
L
Removal and Installation INFOID:0000000000905755
REMOVAL
M
1. Loosen mounting bolts, and remove accelerator pedal assembly.
CAUTION:
Never disassemble accelerator lever. Never remove accelerator pedal position sensor from
accelerator lever. N
Avoid impact from dropping etc. during handling.
Be careful to keep accelerator lever away from water.
2. Disconnect accelerator pedal position sensor harness connector. O
INSTALLATION
Note the following, and install in the reverse order of removal.
Insert locating pin into vehicle side to position accelerator pedal assembly. Install mounting bolt to accelera- P
tor pedal assembly.
Inspection INFOID:0000000000905756
ACC-3
ACCELERATOR CONTROL SYSTEM
< ON-VEHICLE REPAIR >
Make sure accelerator pedal securely returns to the fully released position.
For the electrical inspection of accelerator pedal position sensor. Refer to EC-280, "Description" (HR16DE),
EC-1158, "Description" (MR20DE) or EC-1358, "Description" (K9K).
ACC-4