Ref Math

10-1. A Carnot refrigeration cycle absorbs heat at -12 C and rejects it at 40 C.
(a) Calculate the coefficient

of performance of this refrigeration cycle. (b) If the cycle is absorbing 15 kW at the -12 C temperature,
how much power is required? (c) If a Carnot heat pump operates between the same temperatures as the
above refrigeration cycle, what is the performance factor? (d) What is the rate of heat rejection at the 40
C temperature if the heat pump absorbs 15 kW at the - 12 C temperature?
Solution:
(a) Coefficient of performance = T1 / (T2 - T1
Coefficient of performance = 261 / (261 + 313) Coefficient of performance = 5.02 - - - Ans. (b) Coefficient
of performance = useful refrigeration / net work 5.02 = 15 kw / net work net work = 2.988 kW - - - Ans. (c)
Performance factor = coefficient of performance + 1
Performance factor = 6.01 - - - Ans. (d) Performance factor=heat rejected from cycle/work required.
15kwrejectedheat rejectedheat
15kwrejectedheat rejectedheat
10-2. If in a standard vapor-compression cycle using refrigerant 2 the evaporating temperature is -5 C

and the condensing temperature is 30 C, sketch the cycle on pressure-enthalpy coordinates and calculate
(a) the work of compression, (b) the refrigerating effect, and (c) the heat rejected in the condenser, all in
kilojoules per kilograms , and (d) the coefficient of performance.
Solution.
At pont 1, Table A-6, -5 C, h1 = 403.496 kJ/kg s1 = 1.75928 kJ/kg.K
At point 2, 30 C condensing temperature, constant entropy, Table A-7.
CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE
Page 2 of 10 h2 = 429.438 kJ/kg
At point 3, Table A-6, 30 C h3 = 236.664 kJ/kg
= 236.664 kJ/kg
(a) Work of compression = h2 - h1
(b) Refrigerating effect = h1 - h4

(c) Heat rejected = h2 - h3
(d) Coefficient of performance h eperformancoftCoefficien
− =eperformancoftCoefficien
Coefficient of performance = 6.43 - - - Ans.
10-3. A refrigeration system using refrigerant 2 is to have a refrigerating capacity of 80 kw. The cycle is a
standard vapor-compression cycle in which the evaporating temperature is -8 C and the condensing
temperature is 42 C. (a) Determine the volume flow of refrigerant measured in cubic meter per second at
the inlet to the compressor. (b) Calculate the power required by the compressor. (c) At the entrance to the
evaporator what is the fraction of vapor in the mixture expressed both on a mass basis and a volume
basis? Solution:
Page 3 of 10
At 2, 42 C condensing temperature, constant entropy, Table A-7.
(a) Volume flow of refrigerant = wν g
(b) Power required by compressor = w(h2 - h1)
(c) Let xm = fraction of vapor by mass basis and xv = fraction of vapor by volume basis.
Mass Basis:
h x f1g1
10-4. Compare the coefficient of performance of a refrigeration cycle which uses wet compression with
that of one which uses dry compression. In both cases use ammonia as the refrigerant, a condensing
temperature of 30 C, and an evaporating temperature of -20 C; assume that the compressors are
isentropic and that the liquid leaving the condenser is saturated. In the wet-compression cycle the
refrigerant enters the compressor in such a condition that it is saturated vapor upon leaving the
compressor.
Solution:
Page 4 of 10
For Dry Compression:
At 2, 30 C Condensing Temperature, constant entropy, Fig. A-1.
s x h eperformancoftCoefficien
Coefficient of performance = 4.19
For Wet Compression:
Page 5 of 10
At 2, 30 C condensing temperature, saturated, Table A-3.
s x h1 = hf + x (hg - hf h eperformancoftCoefficien
Coefficient of performance = 4.53 Ans. 4.53 wet versus 4.19 dry.
10-5. In the vapor-compression cycle a throttling device is used almost universally to reduce the pressure
of the liquid refrigerant. (a) Determine the percent saving in net work of the cycle per kilograms of
refrigerant if an expansion engine would be used to expand saturated liquid refrigerant 2 isentropically
from 35 C to the evaporator temperature of 0 C. Assume that compression is isentropic from saturated
vapor at 0 C to a condenser pressure corresponding yo 35 C. (b) Calculate the increase in refrigerating
effect in kilojoules per kilograms resulting from use of expansion engine.
Solution:
Vapor-Compression Cycle:
At 2, 35 C, constant entropy, Table A-7.
At 3, Table A-6
Net Work = h2 - h1
Refrigerating Effect = h1 - h4
For expansion engine:
At a, 0 C, Table A-6.
At b, constant entropy, Table A-2
Page 7 of 10
At c, Table A-6.
At d, constant entropy.
s x faga hd = h fa + x(h ga - h fa )
Net Work = (hb - ha ) - (hc - hd
Refrigerating Effect = ha - hd
(a) Percent Saving

10-6. Since a refrigeration system operates more efficiently when the condensing temperature is low,
evaluate the possibility of cooling the condenser cooling water of the refrigeration system in question with
another refrigeration system. Will the compressor performance of the two systems be better, the same, or
worse than one individual system? Explain why.
Solution:
Page 8 of 10
Coefficient of performance of two system:
)h(hw)h(hw
)h(hw)h(hw COP
Coefficient of performance of each system
)h(hw
)h(hw COP
)h(hw
)h(hw COP aba daa
Substituting:
c COP )h(hwCOP
)h(hw
)h(hw)h(hw COP if COP1 = COP2 then:
COPc = COP1
Therefore it is the same COP as for individual system having equal COP and in between if COP is not the
same..Ans.
10-7. A refrigerant 2 vapor compression system includes a liquid-to-suction heat exchanger in the system.
The heat exchanger warms saturated vapor coming from the evaporator from -10 to 5 C with liquid which
comes from the condenser at 30 C. The compressions are isentropic in both cases listed below. (a)
Calculate the coefficient of performance of the system without the heat exchanger but with the
condensing temperature at 30 C and an evaporating temperature of -10 C. (b) Calculate the coefficient of
performance of the system with the heat exchanger? (c) If the compressor is capable of pumping 12.0 L/s
measured at the compressor suction, what is the
Page 9 of 10 refrigeration capacity of the system without the heat exchanger? (d) With the same
compressor capacity as in (c), what is the refrigerating capacity of the system with the heat exchanger?
Solution:
(a) Without heat exchanger At 1,6, -10 C, Table A-6.
At 2, 30 C, constant entropy, Table A-7 h eperformancoftcoefficien
coefficient of performance = 5.46Ans.

(b) With heat exchanger At 6, -10 C , Table A-6
At 1, -10 C evaporator temperature, 5 C, Table A-7
At 2, 30 C, constant entropy, Table A-7

Since no mention of subcooling.
h eperformancoftcoefficien coefficient of performance = 5.38 . . . Ans.
Page 10 of 10
(c) Refrigerating capacity without heat exchanger At 1, ν = 65.39 L/kg
Refrigerating Capacity
L/kg65.39
L/s12.0
(d) Refrigerating capacity with heat exchanger At 1, ν = 70.2751 L/kg
Refrigerating Capacity
L/s12.0
L/kg70.2751
L/s12.0

Ref Math

Uploaded by

Copyright:

Available Formats

Ref Math

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Ref Math

Uploaded by

Copyright:

Available Formats

10-1. A Carnot refrigeration cycle absorbs heat at -12 C and rejects it at 40 C.

(a) Calculate the coefficient

(a) Coefficient of performance = T1 / (T2 - T1

10-2. If in a standard vapor-compression cycle using refrigerant 2 the evaporating temperature is -5 C

At pont 1, Table A-6, -5 C, h1 = 403.496 kJ/kg s1 = 1.75928 kJ/kg.K

At point 2, 30 C condensing temperature, constant entropy, Table A-7.

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

Page 2 of 10 h2 = 429.438 kJ/kg

At point 3, Table A-6, 30 C h3 = 236.664 kJ/kg

(a) Work of compression = h2 - h1

(b) Refrigerating effect = h1 - h4

(d) Coefficient of performance h eperformancoftCoefficien

Coefficient of performance = 6.43 - - - Ans.

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

At 2, 42 C condensing temperature, constant entropy, Table A-7.

(a) Volume flow of refrigerant = wν g

(b) Power required by compressor = w(h2 - h1)

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

For Dry Compression:

At 2, 30 C Condensing Temperature, constant entropy, Fig. A-1.

Coefficient of performance = 4.19

For Wet Compression:

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

At 2, 30 C condensing temperature, saturated, Table A-3.

Coefficient of performance = 4.53 Ans. 4.53 wet versus 4.19 dry.

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

At 2, 35 C, constant entropy, Table A-7.

For expansion engine:

At b, constant entropy, Table A-2

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

Net Work = (hb - ha ) - (hc - hd

(a) Percent Saving

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

Coefficient of performance of two system:

Coefficient of performance of each system

)h(hw)h(hw COP if COP1 = COP2 then:

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

(a) Without heat exchanger At 1,6, -10 C, Table A-6.

At 2, 30 C, constant entropy, Table A-7 h eperformancoftcoefficien

coefficient of performance = 5.46Ans.

At 1, -10 C evaporator temperature, 5 C, Table A-7

At 2, 30 C, constant entropy, Table A-7

h eperformancoftcoefficien coefficient of performance = 5.38 . . . Ans.

CHAPTER 10 - THE VAPOR-COMPRESSION CYCLE

(c) Refrigerating capacity without heat exchanger At 1, ν = 65.39 L/kg

(d) Refrigerating capacity with heat exchanger At 1, ν = 70.2751 L/kg

You might also like