Sodium Sulfate Decahydrate MSDS: Section 1: Chemical Product and Company Identification
Sodium Sulfate Decahydrate MSDS: Section 1: Chemical Product and Company Identification
Sodium Sulfate Decahydrate MSDS: Section 1: Chemical Product and Company Identification
0 0
Fire
2 0
Re a c t iv it y 0
P e rs o n a l J
P ro t e c t io n
Toxicological Data on Ingredients: Sodium sulfate decahydrate LD50: Not available. LC50: Not available.
Potential Acute Health Effects: Hazardous in case of skin contact (permeator), of eye contact (irritant), of ingestion, of
inhalation.
Potential Chronic Health Effects:
CARCINOGENIC EFFECTS: Not available. MUTAGENIC EFFECTS: Not available. TERATOGENIC EFFECTS: Not available.
DEVELOPMENTAL TOXICITY: Not available. Repeated or prolonged exposure is not known to aggravate medical condition.
Eye Contact:
Check for and remove any contact lenses. Immediately flush eyes with running water for at least 15 minutes, keeping eyelids
open. Cold water may be used. Do not use an eye ointment. Seek medical attention.
Skin Contact:
p. 1
After contact with skin, wash immediately with plenty of water. Gently and thoroughly wash the contaminated skin with running
water and non-abrasive soap. Be particularly careful to clean folds, crevices, creases and groin. Since the product can readily
penetrate the protective epidermal layer and cause rashes or eczema, a good hand cream should be used after washing
affected areas. Seek medical attention.
Serious Skin Contact:
Wash with a disinfectant soap and cover the contaminated skin with an anti-bacterial cream. Seek medical attention.
Inhalation: Allow the victim to rest in a well ventilated area. Seek immediate medical attention.
Serious Inhalation: Not available.
Ingestion:
Do not induce vomiting. Loosen tight clothing such as a collar, tie, belt or waistband. If the victim is not breathing, perform
mouth-to-mouth resuscitation. Seek immediate medical attention.
Serious Ingestion: Not available.
Small Spill:
Use appropriate tools to put the spilled solid in a convenient waste disposal container. Finish cleaning by spreading water on
the contaminated surface and dispose of according to local and regional authority requirements.
Large Spill:
If the product is in its solid form: Use a shovel to put the material into a convenient waste disposal container. If the product is
in its liquid form: Absorb with an inert material and put the spilled material in an appropriate waste disposal. Finish cleaning by
spreading water on the contaminated surface and allow to evacuate through the sanitary system.
Precautions:
Do not breathe dust. Wear suitable protective clothing In case of insufficient ventilation, wear suitable respiratory equipment If
you feel unwell, seek medical attention and show the label when possible. Avoid contact with skin and eyes Keep away from
incompatibles such as acids.
Storage:
p. 2
No specific storage is required. Use shelves or cabinets sturdy enough to bear the weight of the chemicals. Be sure that it is
not necessary to strain to reach materials, and that shelves are not overloaded.
Engineering Controls:
Use process enclosures, local exhaust ventilation, or other engineering controls to keep airborne levels below recommended
exposure limits. If user operations generate dust, fume or mist, use ventilation to keep exposure to airborne contaminants
below the exposure limit.
Personal Protection: Splash goggles. Lab coat. Gloves.
Personal Protection in Case of a Large Spill:
Splash goggles. Full suit. Boots. Gloves. Suggested protective clothing might not be sufficient; consult a specialist BEFORE
handling this product.
Exposure Limits: Not available.
p. 3
Incompatibility with various substances: Reactive with acids.
Corrosivity: Non-corrosive in presence of glass.
Special Remarks on Reactivity: Not available.
Special Remarks on Corrosivity: Not available.
Polymerization: No.
Waste Disposal:
Federal and State Regulations: TSCA 8(b) inventory: Sodium sulfate decahydrate
Other Regulations: Not available..
p. 4
Other Classifications:
WHMIS (Canada): Not controlled under WHMIS (Canada).
DSCL (EEC): R36- Irritating to eyes.
HMIS (U.S.A.):
Health Hazard: 2
Fire Hazard: 0
Reactivity: 0
Personal Protection: j
National Fire Protection Association (U.S.A.):
Health: 2
Flammability: 0
Reactivity: 0
Specific hazard:
Protective Equipment:
Gloves. Lab coat. Not applicable. Splash goggles.
References:
-Hawley, G.G.. The Condensed Chemical Dictionary, 11e ed., New York N.Y., Van Nostrand Reinold, 1987. -The Sigma-
Aldrich Library of Chemical Safety Data, Edition II.
Other Special Considerations: Not available.
Created: 10/10/2005 08:28 PM
Last Updated: 05/21/2013 12:00 PM
The information above is believed to be accurate and represents the best information currently available to us. However, we
make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and we assume
no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for
their particular purposes. In no event shall ScienceLab.com be liable for any claims, losses, or damages of any third party or for
lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if ScienceLab.com
has been advised of the possibility of such damages.
p. 5