IS:1821-1987

UDc 621.882’2 - 472 : 006.78 IS0 273-1979

( Reaffirmed 1998 )
Indian Standard

DIMENSIONS FOR CLEARANCE HOLES FOR

( Third Revision )

( IS0 Title : Fasteners - Clearance Holes for Bolts and Screws )

National Foreword

This Indian Standard ( Third Revision ) which is identical with IS0 273-1979 ’ Fasteners -
Clearance holes for bolts and screws ’ issued by the International Organization for Standardization
( IS0 ), was adopted by the Indian Standards institution on the recommendation of the Bolts,
Nuts and Fasteners Accessories Sectional Committee and approval of the Mechanical Engineering
Division Council.

The original version of this standard was published In 1961 and revised in 1967 and 1982.
The present revision of the standard has been made by adoption of IS0 273-1979 to bring it in line
with IS0 standard.

ln the adopted standard certain terminology and conventions are not identical with those
used in Indian Standards; attention is specially drawn to the following:

Comma ( , ) has been used as a decimal marker while in Indian Standards, the current practice
is to use point ( * ) as the decimal marker.

Wherever the words ‘International Standard’ appear referring to this standard, they should be
read as ‘Indian Standard’.

I
1-
Adopted 7 January $387
I
63 September 1987, BIS 6r 2

BUREAU OF INDIAN STANDARDS

1 SCOPE AND FIELD OF APPLICATION

This international Standard specifies clearance hole diameters for general purpose applications. These values result from
bearing area calculations in connection with IS0 bolt and nut product standards.

NOTE ~~ Clearance holes for spec~ai appllcatlons should be selected on the basis of deslgc requrrenients
 IS : 1821- 1987
IS0 273 - 1979

2 DIMENSIONS

Dimensions in millimetrl

Clearance hole d ,,
Thread ___-.
diameter Series :
d
fine medium COWW

1 42 43 45 48
1.2 45 46 48 52
1.4 48 50 52 56
-.-__- ~. ~_._~~~__
1,6 1.7 1.8 / 2 52 54 56 62
I
1.8 2 ~ 2.1 ! 2,2 56 58 62 66
2 2.2 60 62 66 JO
~-- -
25 2.7 64 66 70 74
3 3.2 ! 68 JO 74 78
I
3.5 3.7 72 74 78 82
----
4 76 78 82 86
4.5 80
5 85
-___
6 90
7 7.4 I 7.6 8 95
, I
8 100
__-__
10 106
12 i3 110
14 15 115
-.
16 17 120
18 19 125
20 21 130
~.
22 23 140
24 25 150
27 28

30 31
33 34 36
36 37 39 42
39 40 42 45

The following tolerance fields are given for information only, for use where it is desirable to specify tolerances :
fine series : H12
medium series : H13
coarse series : H14

In cases where It is necessary to avoid interference between the edge of the hole and the underhead fillet of the bolt, a
chamfer is recommanded.