Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Model CB 15-100 HP Boilers: Table A6-22. Maximum Gas Consumption (CFH) For Natural Gas and Propane Vapor

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

Model CB 15-100 HP Boilers

Table A6-22. Maximum Gas Consumption (CFH) for Natural Gas and Propane Vapor
TYPE OF GAS AND HEAT CONTENT
BOILER
HP NATURAL GAS PROPANE GAS
1000 (Btu/cu-ft) 2550 (Btu/cu-ft)
15 625 245
20 835 330
25 1045 410
30 1255 490
40 1675 655
50 2095 820
60 2510 985
70 2930 1150
80 3350 1315
100 4185 1640
NOTES:
BHP followed by “A” designates hot water boilers
furnished in a smaller vessel size with additional tubes in
upper portion of vessel.

Table A6-23. Gas Pilot Data


Min. Required Gas
Connection (inches) Max. Permissible Gas
BHP Pressure (Up to 700)
NPT Pressure (psig)
Inches WC
50-100 1/2 4 5

Manufactured 500 Natural 1000 Btu/ Propane


BHP
Btu/Cu. Ft Cu. Ft 2500 Btu/Cu Ft
50-100 120 60 25

Approximate Gas Usage:


1. Multiply the CFH rate by 0.007 to obtain the number of cu. ft of gas used in 25 sec.
(Length of (1) light off).
2. Multiply the number of cu. ft/light (item 1) by the estimated number of lights/hour or
per day to obtain the approximate usage in cu. ft/hour or cu. ft/day.
A
MODEL CB
BOILER CONNECTION LOCATION
HP SIZE (IN.) DIMENSION
(NPT) “A” (IN.) BOILER
15, 20 1-1/4 65-1/2 FRONT

30 1-1/2 68
40, 50A 1-1/2 68
50 2 74
PLAN VIEW
60, 70, 80 2 74
100A, 100 2 74
NOTE: BHP followed by “A” designates hot water
boiler furnished in a smaller vessel size with
additional tubes in upper portion of vessel.

Figure A6-7. Standard Gas Train Connection Size and Location

Section A6-23 Rev. 07-10


Model CB 15-100 HP Boilers

This figure illustrates the basic gas valve arrangement on Cleaver-Brooks Model CB
Boiler and shows the contractor’s connection point. The valves and controls between the
contractor connection point and the gas main in the street are representative of a typical
installation. Actual requirements may vary depending on local codes or local gas
company requirements which should be investigated prior to preparation of specifications
and prior to construction.

A. Utilities service valve.


B. Utilities service regulator.
C. Gas meter.
D. Piping from meter to boiler.
The size of the gas line from the meter to the gas pressure regulator at the boiler can be
very important if gas pressures are marginal. The gas line sizing is dependent on:
1. Gas pressure at outlet of gas meter (C)
2. Rate of gas flow required, CFH
3. Length of pipe run (D)
4. Pressure required at contractor connection point.
The local gas utility will advise the pressure that is available at the outlet of their meter.

Figure A6-8. Typical Gas Piping Layout

Section A6-24 Rev. 07-10


Model CB 15-100 HP Boilers

4 5 6
1

PILOT GAS LINE

FLOW

8 9
10
2 7
3 11

Gas To
Supply Burner
MAIN GAS LINE

INS UL FM CSD-1
ITEM DESCRIPTION
BOILER HP 15-20 30-50 60-100 15-20 30-100 15-20 30-50 60-100
1 Pilot Shut Off Cock x x x x x x x x
2 Manual Shut Off Valve x x x x x x x x
3 Manual Shut Off Valve x x x x x x x x
4 Pilot Pressure Regulator x x x x x x x x
5 Pilot Pressure Gauge x x x x x x x x
6 Gas Pilot Valve x x x x x x x x
7 High Gas Pressure Switch x x x x
8 Low Gas Pressure Switch x x x x
9 Main Gas Valve with POC x x x x x x x x
10 Main Gas Regulator x x x x x x x x
11 Butterfly Valve x x x x x

Figure A6-9. Model CB Gas Train Components

Section A6-25 Rev. 07-10


Model CB 15-100 HP Boilers

 
CONTRACTOR
BOILER CONNECTIONS
FRONT  
  
BOILER BASE FRAME

A RIGHT HAND SIDE VIEW

MODEL CB
RECOMMENDED OIL LINEA SIZES
SUPPLY AND (STANDARD PIPE)
BOILER HP RETURN CONN DIM. A (IN.)
SIZES (IN.) (IN.)
(NPT) STORAGE TANK TO BOILER PUMP TO RETURN LINE
OR PUMP CONNECT BOILER TO TANK
15, 20 3/4 8-1/4 3/4 NONE 3/4
30, 40 3/4 8-1/4 3/4 NONE 3/4
50, 60 3/4 11-1/2 3/4 1 3/4
70, 80 3/4 11-1/2 3/4 1 3/4
100 3/4 11-1/2 1 1 1
NOTE: See No. 2 Oil Line Sizing Instruction for systems with other conditions.
A. For suction line condition with a maximum of 10 Feet of lift and a total of 100 equivalent feet of suction line.
B. This table is based on a single boiler installation.

Figure A6-10. No. 2 Oil Connection Size, Location and Recommended Line Sizes

BOILER  
FRONT   
 

 
B
PLAN VIEW
A

RECOMMENDED OIL LINE SIZES


SUPPLY RETURN
(STANDARD PIPE)
CONNECTION CONNECTION
(IN.)
BOILER HP
STORAGE
SIZE (IN.) SIZE (IN.) PUMP TO RETURN LINE
A (IN.) B (IN.) TANK TO
(NPT) (NPT) BOILER TO TANK
PUMP
50, 60, 70, 80, 100 1-1/4 27-3/4 3/4 19-3/4 2 1-1/4 1-1/4
NOTES:
1. All dimensions in inches.
2. For suction lines with a maximum of 10 feet of lift and a total of 100 equivalent feet of suction line.
3. This table is based on a single boiler installation.

Figure A6-11. No. 6 Oil Connection Size, Location and Recommended Line Sizes, Model CB Boiler

Section A6-26 Rev. 07-10


Model CB 15-100 HP Boilers

Figure A6-12. No. 2 Oil Piping, Single Boiler Installation, Remote Oil Pump

Figure A6-13. No. 2 Oil Piping, Multiple Boiler Installation, Remote Oil Pumps

Section A6-27 Rev. 07-10

You might also like