Installation Instructions for 2m Stainless Steel Mast - SIM Series
Mast Detail (ERICO Part # TCEC253) Copper Tape
(ERICO Part # PDCUC) Tape Fasteners
ERICO INTERCEPTOR SI SIM28A2
(ERICO® Part # SI25i, SI40i or SI60i 2 Typical Conductor Connection - Not to Scale 1 - Bonding Clamp (ERICO Part # TMCSS) SIMBASE2840 Detail "B" Stainless Steel Mast 4 HOLES, 0.43 [ 11mm] (ERICO Part # SIM28A2)
Stainless Steel Cable Tie
(ERICO Part # CABTIESS) TMCSS Mast Clamp Installing contractor to
7.87 [200mm] 6.77 [170mm] Three every 3.3FT [1M] field adjust and insure a secure bond on highest SIM series mast Stainless Steel Mast Base (ERICO Part # SIMBASE2840) Refer to Detail "B" Downconductor Base secured to roof
1 - Not to Scale
2 - Detail "A" Lightning Event Counter (ERICO Part # LECIV)
Two downconductors Downconductor
are required Lightning Event Counter ERICO® CADWELD® Connection Refer to installation manual or mechanical connection for alternate locations For complete (ERICO Part # LECIV) Ground Inspection Well grounding system refer to Detail "A" Minimum 2/0 (50 mm ) Conductor 2 Crow's Foot (3 x 20 FT [6.1M] length) Enclosed in GEM material
Minimum 5/8" x 8' [16mm x 2.4M] long
ground rod in four locations Suggested three radial grounding system for each downconductor:
The grounding system shown in the detail is a suggested layout. Each radial consists of a trench approximately 1.5FT [.45M] deep. The conductor is laid in the trench and is connected to ground rods. The conductor in each trench is encased in GEM material. Ground rods must extend 10FT [3M] below ground level. Note: This is one of several alternative installation methods. Refer to ERICO instruction print IP79157 for more details. ERICO is not responsible for field installation of lightning protection systems. The installation integrity of each system should be approved and stamped by a structural professional engineer. WARNING: 1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from your ERICO customer service representative. 2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 3. All instructions must be completely followed to ensure proper and safe installation and performance. 4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property damage, serious bodily injury and death.
SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
