The document warns dealers that the programming software PROSYD should not be used on their lifting platforms because it allows all parameters and parts of the program to be changed, which could result in serious injury or damage if done by unqualified personnel. Only qualified BISON-PALFINGER staff are approved to program the equipment using this software to ensure version control and prevent unintended changes from overwriting important safety aspects of the program.
The document warns dealers that the programming software PROSYD should not be used on their lifting platforms because it allows all parameters and parts of the program to be changed, which could result in serious injury or damage if done by unqualified personnel. Only qualified BISON-PALFINGER staff are approved to program the equipment using this software to ensure version control and prevent unintended changes from overwriting important safety aspects of the program.
The document warns dealers that the programming software PROSYD should not be used on their lifting platforms because it allows all parameters and parts of the program to be changed, which could result in serious injury or damage if done by unqualified personnel. Only qualified BISON-PALFINGER staff are approved to program the equipment using this software to ensure version control and prevent unintended changes from overwriting important safety aspects of the program.
The document warns dealers that the programming software PROSYD should not be used on their lifting platforms because it allows all parameters and parts of the program to be changed, which could result in serious injury or damage if done by unqualified personnel. Only qualified BISON-PALFINGER staff are approved to program the equipment using this software to ensure version control and prevent unintended changes from overwriting important safety aspects of the program.
Product: INFORMATION LP-01/2006 page: 1/1 To all general dealers
PROSYD FOR DIGSY OUTDOOR
Use of the programming Software „PROSYD“
As a producer of hydraulic lifting platforms we are aware of the possibility, that you as a dealer might have the software PROSYD to be able to adjust Intercontrol electronic systems.
We want to inform you, that the use of this Software is not allowed on our machines because of the following reasons:
• The software “PROSYD“ is the programming software for the SPS control DIGSY OUTDOOR. All parameters and/or parts of the program can be changed when using this software. • Unqualified interference into the device/system can result in serious body injury or damage to property. • For this reason, only qualified personnel of BISON-PALFINGER GmbH is allowed to carry out programming works with this software.
Reasons When BISON-PALFINGER staff carries out programming work, the current program version of the equipment will be saved by the factory. This cannot be done, if third persons modify the program. With following interferences into the device/system by BISON-PALFINGER, not stored changes are overwritten; this may result in serious physical injuries or damage to property again.
ATTENTION
• This Information only applies to the software „PROSYD“.
• The software ”PROSYD-SERVICE“ (ACCESS PA17T and PA20T) can still be used.
