Eminence
Eminence
Eminence
Mounting Information
Recommended Enclosure Volume
Sealed N/A
Vented N/A
Overall Diameter 12.25’’, 311.15mm
Baffle Hole Diameter 11.00’’, 279.40mm
Front Sealing Gasket fitted as standard
Rear Sealing Gasket fitted as standard
Mounting Holes Diameter .25’’, 6.35mm
Mounting Holes B.C.D. 11.72’’, 297.69mm
Depth 5.10’’, 129.54mm
Net Weight 7.80 lbs, 3.54 kg
Shipping Weight
Materials of Construction
Coil Construction Copper
Coil Former Nomex
Magnet Composition Ferrite
Motor Details Standard Core * Please inquire about alternative impedances.
Basket Material Steel ** Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
Cone Composition Full Molded Paper *** The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Cone Edge Composition Paper Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25” supplied microphone (software
Dust Cap Composition Zurette calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)