TCD 004 DS4
TCD 004 DS4
TCD 004 DS4
4. If WDT LED of DOC-200 PCB is still ON 10 sec after power has re-
input with DPC PCB Speed CPU operating normally, verify if Speed
CPU RETRY (at most 8 times) automatically resets Run CPU and
normally booting again.
1) If Run CPU has never been re-booted, there are possibly errors in
DOR-230(#1) PCB, DPC-1XX PCB, or PCB connecting status. So,
check PCB connecting connector(MA, VE) cables for connecting
status.
2) Try replacing DOR-230(#1) PCB.
3) Try replacing DPC-1XX PCB.
5. If WDT LED OFF in DOC-200 PCB has failed within 10 sec after
power OFF-ON 2~3 consecutive times,
1) Try replacing flash memory(U12, U13) in DOC-200 PCB.
2) If no correction occurs with Flash Memory replacement,
replace DOC-200 PCB.