Design of Machine Elements Oct 2017
Design of Machine Elements Oct 2017
of Questions : 10]
SEAT No. :
P2496 [Total No. of Pages : 3
[5253] - 515
T.E (Automobile Engineering) (Semester - I)
DESIGN OF MACHINE ELEMENTS
(2015 Pattern)
Time :3 hours] [Max. Marks :70
Instructions to the candidates:
1) Answer any five questions.
2) Neat diagrams must be drawn wherever necessary.
3) A figure to the right indicates full marks.
4) Use of electronic pocket calculator is allowed.
5) Assume suitable data, if necessary.
Q1) a) What are the factors to be considered while designing a machine element?
[6]
b) Differentiate between rigid and flexible coupling. [4]
OR
Q2) a) A foot lever is 1m from the center of shaft to the point of application of
800N load, find
(i) diameter of shaft (ii) length of the key (iii) dimensions of rectangular
arm of the foot lever at 60mm from the center of the shaft, assuming
width of the arm as 3 times thickness. The allowable tensile strength may
be taken as 73Mpa and allowable shear stress as 70Mpa, Width of
key=l2mm and thickness of key=8mm. [6]
b) How do you classify keys? [4]
P.T.O.
QuestionKaka.com
OR
Q4) a) Prove that square key is strong in shear and crushing. [2]
b) Derive an expression for torque required to raise the load in power screws.
[8]
[5253]-515 2
QuestionKaka.com
Q9) A worm gear drive is to connect two shafts to transmit 10 KW. The
transmission ratio is 20:1 and worm shaft rotates at 1440 rpm. Design the gear
set. Assume single start square thread. Take σd=207 Mpa, for worm and
σd=82.4 Mpa, for worm wheel. Form factorY= π (0.154-0.912/Z). [16]
OR
Q10)2 shafts right angles to each other are connected by 20° full depth involute
teeth bevel gears. The velocity ratio is 3:1. The pinion transmits 37.5 KW at
750 rpm. Assume number of teeth on pinion is 20. Design the gear set. Take
σd=233.4 Mpa, BHN=200 for pinion and σd=172.6 Mpa, BHN=150 for gear.
Form factor Y= π (0.154-0.912/Ze), Cv =6.1/6.1+V [16]
M M M
[5253]-515 3
QuestionKaka.com