Material 1.4057 PDF
Material 1.4057 PDF
Material 1.4057 PDF
PROPERTIES:
Special-purpose hardenable steel used where particularly high mechanical properties are needed.
STANDARDS:
General requirements:
When reference to this MAT NO appears on FLS Drawing or FLS Parts List or in FLS Purchase Order the
data from the Primary Standard is used as acceptance criteria.
Specific deviations in requirements made in the FLS Parts List, the FLS Purchase Order or a FLS
Instruction always overrules this data sheet.
Alternatively accepted International Standards listed in this sheet may be used if the suppliers
documentation covers at least the documentation required in the Primary Listed Standard. This means that
supplementary tests in some cases will be necessary.
Primary Standard:
EN 10088-3 (1995), MATERIAL: X17CrNi 16-2, MATERIAL No.: 1.4057
Stainless steels - Part 3: Technical delivery conditions for semi-finished products, bars, rods, and sections
for general purpose.
CHEMICAL COMPOSITION:
% C max or % Si max or % Mn max or % P max or % S max or % N max or % Al min or
Dim. mm
range range range range range range range
0.14-0.23 1.0 1.0 0.04 0.03 - -
For products to be machined a controlled sulfur content of 0.015 to 0.030% is recommended
% Cr max % Mo max or % Ni max or % V max or % Nb max or % Ti max or % Cu min % Other max
Dim. mm
or range range range range range range or range or range
15.5-17.5 - 1.5-2.5 - - - -
DELIVERY CONDITIONS:
Unless otherwise agreed upon, this steel shall be delivered in the quenched and tempered condition..
Revisions:
Rev. No. Rev. Date Change Responsible
0,60 10-02-2002 Prepared & Approved changed AnJo
References to Alternative Standards added to supplier version
0,70 15-01-2004 Standards, chemical composition, and mechanical properties updated. AsK
Rev_no updated: An extra decimal place is added.
0,71 31-01-2005 Standards updated. AsK
1,0 08-06-2005 Rev. no. changed to 1,0 AsK