696-960 MHz

CX063X13x00
Single Band | Panel Antenna | X-Pol | 65° | 14.0 dBi | Variable Tilt

• Single band, X-Pol, variable tilt, panel antenna

• Part of Amphenol’s UNIVERSAL series of antennas featuring consistent form factors for future-proofing
• Patented internal RET actuator adds no additional length to the antenna
• Features an adjustable mounting bracket channel for custom mounting in any situation

Ordering Options Model Number

When ordering, replace “x” in the model number with one of the options listed below.

Manual Electrical Tilt CX063X13M00

Remote Electrical Tilt AISG v2.0 / 3GPP CX063X13G00

Mounting bracket kits and other accessories are ordered separately.

Electrical Characteristics 696-960 MHz

Frequency Bands 696-806 MHz 806-960 MHz

Polarization ±45°

Horizontal Beamwidth 72° 68°

Vertical Beamwidth 19.0° 16.0°

Gain 13.2 dBi 14.0 dBi

Electrical Downtilt 0-14°

Impedance 50Ω

VSWR < 1.5:1

Upper Sidelobe Suppression > 16 dB Typical

Front-to-Back Ratio > 30 dB

In-Band Isolation > 25 dB

IM3 (2x20W carrier) < -153 dBc

Input Power (2x) 500 W

Total Number of Connectors Antenna has 2 connectors located at the bottom

Connectors Type 7/16-DIN Female

Diplexed No

Lightning Protection Direct Ground

Operating Temperature -40° to +60° C (-40° to +140° F)

Mechanical Characteristics

Dimensions (Length x Width x Depth) 1298 x 305 x 180 mm 51.1 x 12.0 x 7.1 in

Weight without Mounting Brackets: MET 10.4 kg 23.0 lbs

Weight without Mounting Brackets: RET 10.7 kg 23.7 lbs

Survival Wind Speed 241 km/hr 150 mph

Front 480 N 108 lbf

Wind Loads
(160 km/hr or 100 mph)
Side 284 N 64 lbf

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

REV031419NA www.amphenol-antennas.com 1 of 3
 696-960 MHz

CX063X13x00
Single Band | Panel Antenna | X-Pol | 65° | 14.0 dBi | Variable Tilt

Electrical Downtilt Control

Electrical downtilt for each band can be controlled separately. Tilt indicator(s) are covered by removable transparent cap(s).

Manual Electrical Tilt (MET) Control A colored knob at the end of the tilt indicator allows change of the tilt without need of a tool. The knob color is
identical to the corresponding connector ring color. To access the knob, remove the cap by turning it counter-
clockwise. It is re-installed by opposite rotation. Do not remove the transparent cap(s) from the antenna.

Remote Electrical Tilt (RET) Control The remote control of the electrical tilt is managed by a Multi-Device Control Unit (MDCU) inserted in the bottom of the
antenna. A single module individually controls the tilt of each band (no need for daisy chain cables between the bands).
This module does not add any additional length to the antenna. For RET control, the transparent caps must be in place
and locked. The tilt angle indicators always remain visible and the antenna still has manual tilt control (manual override).
Do not remove the transparent cap(s) from the antenna.
Important Installation Instructionss In order to operate RET control, the transparent caps covering the tilt adjustment indicators must be engaged and
locked. Do not cut them from the antenna.
Do not install the antenna with the connectors facing upward.

Mounting Options Part Number Image Fits Pipe Diameter Weight

All mounting bracket kits are ordered separately unless otherwise indicated. Select from the options listed below.

2-Point Mounting Bracket Kit MKS09P01 50-115 mm 2.0-4.5 in 2.7 kg 6 lbs

2-Point Mounting & Downtilt Bracket Kit MKS09T01 50-115 mm 2.0-4.5 in 4.5 kg 10 lbs

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

REV031419NA www.amphenol-antennas.com 2 of 3
 696-960 MHz

CX063X13x00
Single Band | Panel Antenna | X-Pol | 65° | 14.0 dBi | Variable Tilt

Bottom View of Antenna Dimensions

Location of the MDCU

for RET Control

Tilt indicator covered by transparent cap.

Manual adjustment is accessed by removing the cap.
Knob color is the same as the connectors.

In order to operate RET control, the transparent cap covering the

tilt adjustment indicator must be engaged and locked. Do not
cut it from the antenna.

Quoted performance parameters are provided to offer typical, peak or range values only and may vary as a result of normal testing, manufacturing and operational conditions. Extreme
operational conditions and/or stress on structural supports is beyond our control. Such conditions may result in damage to this product. Improvements to products may be made without notice.

REV031419NA www.amphenol-antennas.com 3 of 3