Air Brake (Road Vehicle)

Air brake (road vehicle)
Air brakes are used in trucks, buses, trailers, and semi-trailers. George Westinghouse first

developed air brakes for use in railway service. He patented a safer air brake on March 5, 1872.
Originally designed and built for use on railroad train application, air brakes remain the exclusive
systems in widespread use. Westinghouse made numerous alterations to improve his air
pressured brake invention, which led to various forms of the automatic brake and the subsequent
use on heavier road vehicles.
Compressed air brake system
Compressed air brake systems are typically used on heavy trucks and buses. The system
consists of service brakes, parking brakes, a control pedal, an engine-driven air compressor and
a compressed air storage tank. For the parking brake, there is a disc or drum brakearrangement
which is designed to be held in the 'applied' position by spring pressure. Air pressure must be
produced to release these "spring brake" parking brakes. For the service brakes (the ones used
while driving for slowing or stopping) to be applied, the brake pedal is pushed, routing the air
under pressure (approx 100-125psi) to the brake chamber, causing the brake to reduce wheel
rotation speed. Most types of truck air brakes are drum units, though there is an increasing trend
towards the use of disc brakes in this application. The air compressor draws filtered air from the
atmosphere and forces it into high-pressure reservoirs at around 120 PSI. Most heavy vehicles
have a gauge within the driver's view, indicating the availability of air pressure for safe vehicle
operation, often including warning tones or lights. Setting of the parking/emergency brake
releases the pressurized air pressure in the lines between the compressed air storage tank and
the brakes, thus actuating the (spring brake) parking braking hardware. An air pressure failure at
any point would apply full spring brake pressure immediately.
Design and function

A compressed air brake system is divided into a supply system and a control system. The supply
system compresses, stores and supplies high-pressure air to the control system as well as to
additional air operated auxiliary truck systems (gearbox shift control, clutch pedal air
assistance servo, etc.).
Supply system
" Over simplified" air brake diagram on a commercial road vehicle (does not show all air reservoirs and all
applicable air valves).
The air compressor is driven off of the engine either by crankshaft pulley via a belt or directly off

of the engine timing gears. It is lubricated and cooled by the engine lubrication and cooling
systems. Compressed air is first routed through a cooling coil and into an air dryer which removes
moisture and oil impurities and also may include a pressure regulator, safety valveand a smaller
purge reservoir. As an alternative to the air dryer, the supply system can be equipped with an anti
freeze device and oil separator. The compressed air is then stored in areservoir (also called a wet
tank) from which it is then distributed via a four way protection valve into the front and rear brake
circuit air reservoir, a parking brake reservoir and an auxiliary air supply distribution point. The
system also includes various check, pressure limiting, drain and safety valves.
Control system
The control system is further divided into two service brake circuits: the parking brake circuit and
the trailer brake circuit. This dual brake circuit is further split into front and rear wheel circuits
which receive compressed air from their individual reservoirs for added safety in case of an air
leak. The service brakes are applied by means of a brake pedal air valve which regulates both
circuits. The parking brake is the air operated spring brake type where its applied by spring force
in the spring brake cylinder and released by compressed air via hand control valve. The trailer
brake consists of a direct two line system: the supply line (marked red) and the separate control
or service line (marked blue). The supply line receives air from the prime mover park brake air
tank via a park brake relay valve and the control line is regulated via the trailer brake relay valve.
The operating signals for the relay are provided by the prime mover brake pedal air valve, trailer
service brake hand control (subject to a country's relevant heavy vehicle legislation) and the
prime mover park brake hand control.

Air Brake (Road Vehicle)

Uploaded by

Copyright:

Available Formats

Air Brake (Road Vehicle)

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Air Brake (Road Vehicle)

Uploaded by

Copyright:

Available Formats

Air brake (road vehicle)

Air brakes are used in trucks, buses, trailers, and semi-trailers. George Westinghouse first

Compressed air brake system

Design and function

The air compressor is driven off of the engine either by crankshaft pulley via a belt or directly off

You might also like