Fuel Transfer Pump - Disassemble: Shutdown SIS
Fuel Transfer Pump - Disassemble: Shutdown SIS
Page 1 of 3
Shutdown SIS
Previous Screen
i01183553
Disassembly Procedure
Start By:
A. Remove the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump -
Remove".
NOTICE
NOTICE
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sis... 01-10-2019
416B Backhoe Loader 8ZK06000-11031 (MACHINE) POWERED BY 3054 Engine(... Page 2 of 3
Illustration 1 g00544796
1. Place an identification mark on each half of the fuel transfer pump for the assembly
procedure.
5. Remove the screws that hold the two halves of the fuel transfer pump together.
6. Rotate diaphragm assembly (5) at 90 degrees in order to remove the pull rod from link arm
(8) .
8. Remove stem seal (6), spring seat washer (7), and diaphragm spring (12) from the pull rod.
Note: Diaphragm assembly (5) and the pull rod are not serviced parts.
9. Use a suitable lever in order to remove valves (4) and seat washers (3). The valves are
peened in.
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sis... 01-10-2019
416B Backhoe Loader 8ZK06000-11031 (MACHINE) POWERED BY 3054 Engine(... Page 3 of 3
Note: Some of the metal that is peened may need to be removed in order to remove valves
(4) .
10. Hold rocker lever (11) in a vise and hit the body of the fuel transfer pump with a soft
hammer in order to release retainers (10). This will allow you to remove link arm (8) .
NOTICE
Do not damage the face on the body of the fuel transfer pump.
11. Remove the following items: rocker lever (11), pin (9), link arm (8) and the return spring.
Copyright 1993 - 2019 Caterpillar Inc. Tue Oct 1 14:33:57 UTC+0530 2019
All Rights Reserved.
Private Network For SIS Licensees.
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sis... 01-10-2019