Inorganic Lab Exp 3 PDF

Linkage Isomers: Synthesis and Characterization of
[Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2
Divalent cobalt is more stable than trivalent cobalt for simple salts of cobalt, with only a
few salts of Co(III) known (e.g. CoF3). Formation of a coordination complex stabilizes a
higher oxidation state as evidenced by a number of octahedrally coordinated complexes. In
this experiment, you will prepare1, 2
two classical linkage isomer compounds,
[Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2.
1) One synthesis scheme of [Co(NH3)5Cl]Cl2 involves the following unbalanced equations
Co2+ + NH4+ + 1/2H2O2 → [Co(NH3)5(OH2)]3+
[Co(NH3)5(OH2)]3+ + 3HCl → [Co(NH3)5Cl]Cl2(s) + H2O + 3H+
2) Synthesis of [Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2 involves the following:
[Co(NH3)5Cl]2+ + H2O → [Co(NH3)5H2O]3+ + Cl-
[Co(NH3)5H2O]3+ + NO2- → [Co(NH3)5ONO]2+ + H2O
[Co(NH3)5ONO]2+ → [Co(NH3)5NO2]2+
Synthesis and Experimental Procedure:

All reactions should take place in a fume hood. Part I may be skipped if [Co(NH3)5Cl]Cl2 is
available from a previous experiment. Scale solvent and reagent amounts as needed.
Part I: chloropentaamminecobalt(III) chloride, [Co(NH3)5Cl]Cl2

Prepare a solution of 0.0935 mol ammonium chloride NH4Cl in 30 mL of concentrated
aqueous ammonia in a 250 mL Erlenmeyer flask. While stirring with magnetic stirbar,
slowly add 0.042 mol of cobalt(II) chloride hexahydrate. While continuously stirring,
slowly add 8 mL of a 30% H2O2 solution (CAUTION: H2O2 is a strong oxidizing agent
that can cause severe burns. Use gloves! Wash affected areas immediately with water!).
When evidence of further reaction has ceased, slowly add 30 mL of concentrated HCl. Heat
the solution using a hot plate. Maintain a temperature of about 85°C for about 20 minutes.
Do not allow the solution to boil. Cool the solution slightly and then place in an ice water
bath. Isolate the crystalline product by suction filtration. Wash the product with a small
amount of ice-cold water. The total volume of the wash should not exceed 15 mL. Wash
with 15 mL of cold 6M HCl. Dry in a drying oven for 20 minutes and then weigh the
product to determine the percent yield. Allow the sample to dry on the lab bench or drying
oven before collecting an IR and UV-Vis spectra. Discard the filtrate wash solution in the
appropriate “chloropentaamminecobalt(III) chloride” waste container in the fume hood.
Don’t tightly cap the waste bottle.
1
Part II: pentaamminenitritocobalt(III) chloride, [Co(NH3)5ONO]Cl2
Heat a solution (do not boil) of 8 mL of concentrated aqueous ammonia in 80 mL of water.
While heating and stirring, add 0.020 mol of ‘dry’ [Co(NH3)5Cl]Cl2 or 0.024 mol ‘wet’
[Co(NH3)5Cl]Cl2. Continue heating, below boiling point, and stirring until the product
dissolves. Add an additional small amount of 1:10 ammonia:water if needed. This may
take 15 minutes or more. If you observe the presence of a dark brown to black precipitate
of cobalt oxide, filter it off. Cool the solution, in an ice bath, to about 10 °C. Add 2 M HCl
slowly while keeping the solution cold until it is neutral as determined by litmus or pH
paper. Add 5.0 g of sodium nitrite followed by 5 mL of 6 M HCl. Cool the solution in an
ice bath for approximately an hour, then filter the precipitated salmon pink crystals of
[Co(NH3)5ONO]Cl2. Wash with 20 mL of icewater then 20 mL of 95% ethanol. Allow it
to dry on the lab bench for approximately one hour before collecting an IR and UV-Vis
spectrum. Do not dry in a drying oven. Discard the waste in the appropriate waste container
in the fume hood.
The product [Co(NH3)5ONO]Cl2 is not stable and will isomerize to [Co(NH3)5NO2]Cl2.

Ensure you have sufficient time in the laboratory session to collect the IR spectrum of the
product on the same day as the synthesis.
Pentaamminenitrocobalt(III) chloride, [Co(NH3)5NO2]Cl2
The product [Co(NH3)5ONO]Cl2 will isomerize in the solid state to [Co(NH3)5NO2]Cl2,

even at room temperature, given sufficient time.3 Dr. Fred Basolo, winner of the Priestley
Medal (the highest honor conferred by the American Chemical Society), reported on the
kinetics and mechanisms of these isomerism reactions in the first paper4 published by the
ACS journal Inorganic Chemistry.
Collect IR spectra over at least two laboratory periods. Compare the data over time and
show to the instructor.
Ensure UV-visible and IR spectra have been collected for each of the three products,
[Co(NH3)5Cl]Cl2, [Co(NH3)5ONO]Cl2, and [Co(NH3)5NO2]Cl2.
Retain your products in labeled sample bags.
If instructed, the isomerization may also be facilitated by heating. It is possible to use the
[Co(NH3)5ONO]Cl2 product before it is completely dry. Bring 20 mL of H2O to a boil and
add a few drops of NH4OH. Turn off heat and allow cooling for 4 minutes after boiling has
ceased. Add 2.0 g of [Co(NH3)5ONO]Cl2 to the solution. As this solution cools to room
temperature, add 20 mL of concentrated HCl. After cooling from solution,
[Co(NH3)5NO2]Cl2 will precipitate from solution. Filter the product from solution and wash
with small portions of a total of 10 mL 95% ethanol. Allow to dry under vacuum for
several minutes until dry and collect the IR spectrum and the UV-Vis spectrum.
2
References
1. Jolly, W. L. In The synthesis and characterization of inorganic compounds; Prentice-

Hall, Inc.: 1970;
2. Tanaka, J.; Suib, S. L. In Experimental methods in inorganic chemistry; Prentice-Hall,

Inc.: 1999;
3. R. B. Penland, T. J. Lane, J. V. Quagliano "Infrared Absorption Spectra of Inorganic

Coordination Complexes. VII. Structural Isomerism of Nitro- and
Nitritopentamminecobalt(III) Chlorides", J. Am. Chem. Soc. 78, 887 (1956).
4. F. Basolo, G. S. Hammaker "Synthesis and Isomerization of Nitritopentammine

Complexes of Rhodium(III), Iridium(III), and Platinum(IV)", Inorg. Chem. 1, 1 (1962).

Inorganic Lab Exp 3 PDF

Uploaded by

Copyright:

Available Formats

Inorganic Lab Exp 3 PDF

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Inorganic Lab Exp 3 PDF

Uploaded by

Copyright:

Available Formats

What compounds are synthesized in this experiment?

What compounds are synthesized in this experiment?

What is the difference between the linkage isomers [Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2?

What is the difference between the linkage isomers [Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2?

Linkage Isomers: Synthesis and Characterization of

[Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2

1) One synthesis scheme of [Co(NH3)5Cl]Cl2 involves the following unbalanced equations

Co2+ + NH4+ + 1/2H2O2 → [Co(NH3)5(OH2)]3+

[Co(NH3)5(OH2)]3+ + 3HCl → [Co(NH3)5Cl]Cl2(s) + H2O + 3H+

2) Synthesis of [Co(NH3)5ONO]Cl2 and [Co(NH3)5NO2]Cl2 involves the following:

[Co(NH3)5Cl]2+ + H2O → [Co(NH3)5H2O]3+ + Cl-

[Co(NH3)5H2O]3+ + NO2- → [Co(NH3)5ONO]2+ + H2O

Synthesis and Experimental Procedure:

Part I: chloropentaamminecobalt(III) chloride, [Co(NH3)5Cl]Cl2

The product [Co(NH3)5ONO]Cl2 is not stable and will isomerize to [Co(NH3)5NO2]Cl2.

Pentaamminenitrocobalt(III) chloride, [Co(NH3)5NO2]Cl2

The product [Co(NH3)5ONO]Cl2 will isomerize in the solid state to [Co(NH3)5NO2]Cl2,

Retain your products in labeled sample bags.

1. Jolly, W. L. In The synthesis and characterization of inorganic compounds; Prentice-

2. Tanaka, J.; Suib, S. L. In Experimental methods in inorganic chemistry; Prentice-Hall,

3. R. B. Penland, T. J. Lane, J. V. Quagliano "Infrared Absorption Spectra of Inorganic

4. F. Basolo, G. S. Hammaker "Synthesis and Isomerization of Nitritopentammine

You might also like