General Requirements: When does a Piping system require CRN registration in
Alberta? 1. For a new pressure piping system fabricated in Alberta: • Fluid: It must contain an expansible fluid.1 • Design Pressure: Pressure must be greater than 103 kPa (15 PSI) • Volume: total internal capacity must be greater than 0.5 cubic metres (500 liters, 132 gallon US, 17.6 cu.ft) 2. For an addition or modification to a registered system: • When the enclosed volume to be added or modified is greater than 0.5 cubic metres. 3. For a pressure piping system fabricated outside of Alberta: • “Design registration is required for all pressure piping fabricated outside Alberta, regardless of its volume”.
Additional requirements: • Form AB-83 must be completed and kept by the owner/user for at least 5 years. • Form AB-81 must be completed by the contractor upon completion of the project and submitted to ABSA. • Skid units: o The CRN for a skid system is not transferable between jurisdictions, since it is still linked to one particular installation. o They must be registered in Alberta when they form part of a CRN- registered system (over 0.5 cubic metres), even when their own volume is less than 0.5 metres.
Exemptions: A piping system is exempt from registration when all of the following conditions are met: Size: Pipe nominal size is less than or equal to DN 50, and Pressure: Design Pressure is less than or equal to 1035 kPa (150 PSI), and Temperature: Design Temperature is between minus 29 degrees Celsius and 186 degrees Celsius (-20 < T < 366oF), and Fluid: fluid must be either air, nitrogen, argon, carbon dioxide, steam or hot water, and Code Compliance: is constructed to the applicable ASME Code, Please note that Section 35 of Regulation 49/2006 is still in force.2
Notes: 1. As an example of what this means: this statement excludes registration of a hydraulic system. 2. Section 35 in the Alberta Regulation 49/2006 touches on the owner’s duty to report to ABSA “any unsafe condition, accident, or fire that occurs with respect to that pressure equipment.”
Key Design Engineering Please be reminded that this information has been supplied 55 Northfield Dr. E, Suite 194 as a starting guide, for general information purposes only. Waterloo, ON N2K 3T6 Please contact Key Design Engineering with further Ph: 520-265-3657 questions. The information contained here can be found on http://www.keydesigneng.com/ various pages at www.absa.ca, by following the “Design Registration” link.
