SSC Je Syllabus Paper 1
SSC Je Syllabus Paper 1
SSC Je Syllabus Paper 1
Basic concepts, Circuit law, Magnetic Circuit, AC Fundamentals, Measurement and Measuring
instruments, Electrical Machines, Fractional Kilowatt Motors and single phase induction Motors,
Synchronous Machines, Generation, Transmission and Distribution, Estimation and Costing,
Utilization and Electrical Energy, Basic Electronics.
2) In Bipolar Junction transistors, the type of configuration which will give both voltage gain
and current gain is
A) CC B) CB
C) CE D) None
3) With the positive probe on an NPN base, an ohmmeter reading between the other
transistor terminals should be
A) Open B) Infinite
A) Collector-emitter B) Base-collector
C) Base-emitter D) Collector-base
C) it is an elemental
D) of the availability of nature oxide SiO
semiconductor
A) 10 B) 40
C) 80 D) 100
8) An arc blow is a welding defect that is countered with the help of carrying
9) During the resistance welding, ibe heat produced at the joint is proportional to
A) I2R B) Voltage
C) Current D) Volt-Ampere
10) An electric heater draws 3-5 A from a 110 V source. The resistance of the heating
element is approximately
A) 385 ? B) 38.5 ?
C) 3.1 ? D) 31 ?
A) steradian B) candela
C) lumen D) lux
12) A 200 V lamp takes a current of 1 A, it produces a total flux of 2,860 lumens. The
efficiency of the lamp is
A) 40 Hz B) 45 Hz
C) 48 Hz D) 50 Hz
A) 0.5? B) 1?
C) 1.5? D) 2?
15) The minimum area of cross-section of a three and half core cable should be
16) Ine aluminium conductor of size is used for a subcircuit in domestic wiring
A) 1/1.2 mm B) 1/1.4 mm
C) 1/1.8 mm D) 1/2.24 mm
A) 2.5 cm B) 3 cm
C) 4 cm D) 4.5 cm
18) In batton wiring the cables are carried on seasoned teak wood perfectly straight and well
varnished teak wood batton of thickness not less than
A) 1 cm B) 2 cm
C) 3 cm D) 4 cm
19) The permissible voltage drop from supply terminal to any point on the wiring system
should not exceed
20) For painful shock, what is the range of electric shock current at 50 Hz ?
A) 0-1 mA B) 0-3 mA
C) 3-5 mA D) 5-10 mA
A) increases by about
80% as that with ac B) decreases by about 80% as that with ac operation
operation
22) What is the maximum number of point of light, fan and socket-outlets that can be
connected in one sub-circuit ?
A) Four B) Six
C) Ten D) Twelve
23) An alternator is supplying a load of 300 kW at a power factor of 0-6 lagging. If the power
factor is raised to unity, how many more kW can alternator supply ?
A) 100 kW B) 150 kW
C) 200 kW D) 300 kW
24) If span length is doubled with no change in other factors, the sag of the line will become
26) A circuit breaker is rated as follows : 1500 A, 33 KV, 3 sec, 3-phase oil circuit breaker.
Determine the making current
A) 1.5 KA B) 35 KA
C) 89 KA D) 110 KA
27) If the power factor is high, then the consumer maximum RVA demand
A) increases B) decreases
29) The per phase DC armature resistance of an alternator is 0.5? The effective AC armature
resistance would be about
A) 0.25 ? B) 0.5 ?
C) 0.75 ? D) 1 ?
32) A salient-pole synchronous motor is operating at 1/4- full-load. If its field current is
suddenly switched off. it would
C) run at sub-synchronous
D) run at super-synchronous speed
speed
A) it is simplest to perform B) it gives regulation value higher than is actually found by
and compute direct loading
C) armature reaction is D) it gives regulation value lower than is actually found by
wholly magnetising direct loading
35) Each of the following statements regarding a shaded pole motor is true except
C) parabola throughout D) parabola up to frill load and a straight line at over load
A) increases
B) remains constant
proportionately
43) A short shunt compound generator supplies a load current of 100 A at 250 V. The
generator has the following winding resistances: shunt field = 130 ?. armature = 0.1? and
scries field = 0.1 ?. Find the emf generated if the brush drop is 1 V per brush
A) 50% B) 25%
C) 75% D) 57.7%
45) An eight pole wound rotor induction motor operating on 60 Hz supply is driven at 1800
rpm by a prime mover in the opposite direction of revolving magnetic field. The frequency of
rotor current is
A) 60 Hz B) 120 Hz
C) 180 Hz D) 200 Hz
47) The no load primary current I0. is about ____ of full load primary current of a transformer
A) 3-5% B) 15-30%
C) applied voltage is
D) transformer is not an efficient device
sinusoidal
49) The primary and secondary windings of a transformer arc wound on (he lop of each other
in order to reduce
50) The no load input power to a transformer is practically equal to ____ loss in the
transformer
A) Iron B) Copper
51) A Lissajous pattern on an oscilloscope has 5 horizontal tangencics and 2 vertical tan-
gencies. The frequency of the horizontal input is 100 Hz. The frequency of the vertical input
will be
A) 400 Hz B) 2500 Hz
C) 4000 Hz D) 5000 Hz
52) A dc voltmeter has a sensitivity of 1000 ?/volt When it measures half full scale in 100 V
range, the current through the voltmeter will
A) 100 mA B) 50 mA
C) 1 mA D) 0.5 mA
53) A 150 V moving iron voltmeter of accuracy class 10 reads 75 V when used in a circuit
under standard conditions. The maximum possible percentage error in the reading is
A) 0.5 B) 1.0
C) 2.0 D) 4.0
C) forcing a constant
current and measuring the
D) using an electrical bridge circuit
voltage across the
unknown resistance
57) Creeping in a single phase induction type energy meter may be due to
58) A CRO screen has ten divisions on the horizontal scale. If a voltage signal 5
sin(314t+45°) is examined with a line base setting of 5 msec/div, the number of cycle of
signal displayed on (he screen will be
59) The errors in current transformers can be reduced by designing them with
A) 400 Hz B) 2400 Hz
C) 2800 Hz D) 5200 Hz
C) VLIL D) Vph Iph
62) Three wattmeter method of power measure ment can be used to measure power in
63) When a series RL circuit is connected to a voltage source V at t = 0, the current passing
through the inductor L at t = 0+ is
A) V/R B) infinite
C) zero D) V/L
64) An RLC series circuit has R=10?, L= 2 H. What value of capacitance will make the circuit
critically damped ?
A) 0.02 F B) 0.08 F
C) 0.2 F D) 0.4 F
65) If in an RLC scries circuit, the frequency is below ihc resonant frequency, then
A) Xc - XL B) Xc < XL
66) To realise the full rated power of the lamps they are to be connected in
67) In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will
68) One sine wave has a period of 2 ms. another has a period of 5 ms. and other has a period
of 10 ms. Which sine wave is changing at a faster rate ?
C) All are at the same rate D) Sine wave with period of 10 msec
69) A bar of iron 1 cm2 in cross-section has 10-4wb of magnetic flux in it. If ?r=2000 what is
the magnetic field intensity in the bar?
C) 796x103AT/m D) 398xl04 AT/m
70) A current of 2 A passes through a coil of 350 turn wound on a ring of mean diameter 12
cm. The flux density established in the ring is l.4 wb/m 2. Find the value of relative
permeability of iron
A) 191 B) 600
72) The magnitude of AT required to establish a given value of flux in the airgap will be much
greater than that required for iron part of a magnetic circuit, because
73) If the co-efficient of coupling between two coils is increased, mutual inductance between
the coils
A) Wb/Atxm B) At/m
C) At/Wb D) Wb
75) When the current through the coil of an electromagnet reverses, the
A) direction of the
B) direction of the magnetic field remains unchanged
magnetic field reverses
A) 8 V B) 2 V
C) 0.5 V D) 50 V
78) The internal resistance of a voltage source is 10? and has 10 volts at its terminals. Find
the maximum power that can be transferred to the load
A) 0.25 W B) 25 W
C) 2.5 W D) 5W
C) group of interconnected
D) open terminal of an element
elements
82) If 750 ?A is flowing through 11 k? of resistance, what is the voltage drop across the
resistor ?
A) 8.25 V B) 82.5 V
C) 14.6 V D) 146 V
85) What is the Power consumed by the resistor of 20? connected across 100 V source?
A) 500 W B) 50 W
C) 100 W D) 300 W
86) How much energy is stored by a 100 mH inductance when a current of 1 A is flowing
through it ?
A) 0.5 J B) 0.05 J
C) 0.005 J D) 5.0 J
87) The rate of change of current in a 4 H inductor is 2 Amps/sec. Find the voltage across
inductor.
A) 8 V B) 0.8 V
C) 2 V D) 16 V
89) A primary cell has an c.m.f of 1.5 V. When short circuited, it gives a current of 3 internal
resistance of cell is
A) 4.5 ? B) 2 ?
C) 0.2 ? D) 0.5 ?
90) A resistor is connected across a 50 V source. The current in the resistor if the colour code
is red, orange, orange, silver is
A) 2 mA B) 2.2 mA
C) 214 mA D) 21.4 mA
91) If two capacitances C, and C2 are connected in parallel then the equivalent capacitance is
given by
A) C1C2 B) C1/C2
C) C1C2/C1 + C2 D) C1 + C2
C) Moment of inertia /
D) Actual length / Radius of gyration
Actual length
A) Pressure B) Temperature
C) Work D) Momentum
94) A triac is a
95) Which device changes the alternating e.m.f. generated by the D.C. Generator in its
armature coil to D.C
96) With which of the following, the intrinsic sesmi conductor Silicon be doped in order to
obtain p-type semi-conductor
A) Boron B) Phosphorus
97) The property of a matertial by which it can be rolled into sheets is called
A) Elasticity B) Plasticity
C) Ductility D) Malleability
98) A conductor of axial length 30 cms carries a current of 100 A and lies at right angle to a
magnetic field of strength 0.4 tesla. What is the force exerted on it
A) 10 N B) 12 N
C) 1.2 N D) 0
99) When an object is cut by a section plane, parallel to H.P. and perpendicular to V.P., then
the sectional view of the object is obtained in
A) 1 f B) 10 f
C) 0.1 f D) 0.01 f
Discuss on this RRB_SE_Green_Answer_key_2014
View Answer
2) The junction diode, formed from a metal-semiconductor junction rather than a p-n
junction, is known as
A) Schottky diode B) metal diode
C) Fleming diode D) Bose diode
3) the girders made up from separate structural steel plates by welding or riveting are
known us
A) web girders B) flange girders
C) plate girders D) rolled girders
Discuss on this RRB Se Exam 2014 Yellow Colour
View Answer
2) In orthographic projection, if the object lies between the observer and the plane of
projection, it is called
3) The energy of thermal radiation u emitted per unit time by a blackbody of surface area A
at temperature I T(in absolnte scale) is given by
u = ? AT4 (where ? = Stefan-Boltzmannconstant)
The above statement is
C) Wien's displacement
D) Prevost law
law
4) How many molecules of sulphur are present in 256 grams of sulphur (Sg)
5) The process by which absorption of radiation and emission of infrared radiation by gases in
a planet's atmosphere warm its lower atmosphere, is known as
6) If a gas is heated against a pressure, keeping the volume constant, then the work done
will be
A) Positive B) Negative
7) Which of the following methods is not used to improve fatigue strength of manufactured
products
C) size of the ion only D) charge on the ion and size of the ion