Digital Switchgear - Ethernet Connectivity Release

June, 2020 – Rev01
Digital Switchgear - Smart Device Integration

Modbus TCP motor controller M10x-TCP and Modbus RTU to TCP converter MS572 release
1TGD050009
Digital Switchgear- Smart Device Integration
Release Content
ABB Ability™ cloud based solutions, e.g.
Enable the ethernet network on switchgear level ABB Ability Asset Health for electrical systems
Process
Control
M10x Ethernet integration release System
CMES Edge device with
ABB Ability CMES Profibus DP,
- M10x-TCP – M10x motor controller with Modbus TCP Modbus RTU/TCP
interface EM01
Digital Gateway
- New M10x firmware 3.5
Modbus TCP
- MCUSetup 5.6 parametering software
Modbus TCP
Modbus RTU
Generic Modbus RTU device integration release
- MS572 generic Modbus RTU to TCP type converter

MS572
- New configuration tool MConfig-G 1.0 TMS Modbus RTU to M10x- TCP
Power
Temperature
meter TCP converter Motor controller
Monitoring System
June 2, 2020 Slide 2

Release Content
M10x-TCP – M10x motor controller with Modbus TCP interface
M10x device enhanced with Modbus TCP interface for

Ethernet communication
• One M10x-TCP supports up to 4 Modbus TCP masters
• Direct communication between M10x-TCP and DCS
by Modbus TCP in addition to Digital GW / CMES supported
• Dual Ethernet interfaces for ring , star, line topologies
• Support of MRP protocol and redundancy through ring
structure
• Parameterization from the MD21 panel
(i.e. IP address settings and display)
• Fully integrated solution into LVS Digital platform and CMES
condition monitoring system with optional cloud
application(*)
(*) Full integration into LVS Digital planned for Q3/2020

Release Content
M10x-TCP – M10x motor controller with Modbus TCP interface
M10x device enhanced with Modbus TCP interface for

Ethernet communication
• Modbus TCP interface EM01 segregated from M10x
device (in module) and installed in cable compartment
for easy Ethernet installation
• Ensures that Ethernet communication remains active
in ring or line topologies even if multiple modules
are disconnected
• Compact design and easy DIN rail installation
W x H x D = 92 mm X 26 mm X 57 mm

Release Content
ABB Ability™ cloud based solutions, e.g.
M10x-TCP - redundant communication concept ABB Ability Asset Health for electrical systems
(MyRemoteCare)
• Ring Ethernet network or star topology to M10x-TCP interface

CMES Edge device with
EM01 and direct redundant communication to DCS controllers Process
ABB Ability CMES
Control
System
Digital
• Digital Gateway used for integration into LVS Digital platform Gateway
and CMES condition monitoring system
Modbus TCP
withdrawable
• Option to integrate into cloud application module with
M10x-TCP
EM01
Modbus TCP
EM01
EM01
EM01
Release Content
M10x-TCP Release – new hardware/ order codes
Variants of M10x-TCP with MD21 panel
Description Kit Content Order Code
M101-TCP / MD21 M101-M with EM01 interface, incl. MD21 panel, cable 1TNA920611R2101
(24VDC) TA201, 24VDC
(110VAC) TA201, 110VAC
(240VAC) TA201, 240VAC
(110VAC) TA201, 110VAC
(240VAC) TA201, 240VAC

Release Content
M10x-TCP Release – new hardware/ order codes
Variants of M10x-TCP with MD31 panel
Description Kit Content Order Code
(110VAC) TA201, 110VAC
(240VAC) TA201, 240VAC
(110VAC) TA201, 110VAC
(240VAC) TA201, 240VAC

Release Content
M10x Release – Firmware and Tool
M10x-M firmware 3.5 – New features and functions:

• Support of Modbus TCP relevant features
• Additional measurement values:

• Current L1/2/3 in Ampere
• Reactive Power / Apparent Power
• Reactive Energy / Apparent Energy
• All values accessible also via Modbus communication interface
• Parameterizing tool MCUSetup 5.6 is released to

support configuration of above features
• Detailed M10x release content is available in the

product release note “1TNE912014”

Release Content
M10x Release – Documentation
Along with the release, the relevant documents are updated:
• Smart MCC with M10x product brochure

• M10x-TCP User Guide
• M10x User Guide
• M10x-M Modbus RTU Implementation manual
All documents/tools available in ABB Intranet library and M10x

support database

Release Content
Modbus RTU-TCP converter MS572 MRP Switch
A generic Modbus RTU-TCP converter to provide a cost-effective

Ethernet network integration of devices with serial Modbus RTU
communication into digital solution. M10x-TCP
• MS572 support up to 4 Modbus TCP master

• Dual Ethernet interfaces for ring, tree, line topologies M10x-TCP
RTU device 31
• Support MRP protocol and redundancy through ring structure
• Support up to 31 Modbus RTU slaves at RS485 port
• Generic converter for any RTU devices integrated in low
ACS 880 with TCP RTU device 2 (e.g.
voltage digital platform, e.g. soft-starters, power meters etc. interface Power meter)
• Simplified network structure and cabling
• Solution allows integration of RTU devices into LVS Digital
MS572
platform and CMES condition monitoring system with RTU device 1 (e.g
Modbus Datacard of
optional cloud application(*) TMS)
June 2, 2020 Slide 10 (*) integration supported since LVS Digital Release 2.0/0 – for details ref. to LVS Digital Release Note 1TGD050004
Release Content
Modbus RTU-TCP Converter MS572
The configuration tool - MConfig-G 1.0
Easy connectivity to devices:

• Straight or cross standard min. Cat5 cable
• Connect to either of the Ethernet ports on MS572
• Connect to the network switch

Release Content
• Compact design
W x H x D=92mm X 26mm X 57mm
F
E
• Easy DIN rail installation
• Curving surface for easy wiring connections
1TNA706111R0042 Installed in cable way

Application example - Temperature supervision
TMS in conventional LV switchgear (i.e. as retrofit) TMS with LVS Digital in MCC application
CMES Edge with CMES Edge with

Web browser Web browser
ABB Ability CMES ABB Ability CMES
Digital Gateway Digital Gateway
MS572 MS572-
Modbus RTU to Modbus RTU to
TCP converter TCP converter
Temp. Temp.
Multimeter Circuit breaker Multimeter Circuit breaker M10x-TCP
monitoring monitoring
i.e. M4M i.e. Emax 2 i.e. M4M i.e. Emax 2

Release Content
Along with the release, the relevant documents are updated:
• LVS Digital - MS572 converter User Manual
All documents/tools available in ABB Intranet library and LV

Support database.

Digital Switchgear - Ethernet Connectivity Release

Uploaded by

Copyright:

Available Formats

Digital Switchgear - Ethernet Connectivity Release

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Digital Switchgear - Ethernet Connectivity Release

Uploaded by

Copyright:

Available Formats

June, 2020 – Rev01

Digital Switchgear - Smart Device Integration

- MS572 generic Modbus RTU to TCP type converter

June 2, 2020 Slide 2

M10x-TCP – M10x motor controller with Modbus TCP interface

M10x device enhanced with Modbus TCP interface for

(*) Full integration into LVS Digital planned for Q3/2020

M10x-TCP – M10x motor controller with Modbus TCP interface

M10x device enhanced with Modbus TCP interface for

June 2, 2020 Slide 4

• Ring Ethernet network or star topology to M10x-TCP interface

M10x-TCP Release – new hardware/ order codes

Variants of M10x-TCP with MD21 panel

Description Kit Content Order Code

June 2, 2020 Slide 6

M10x-TCP Release – new hardware/ order codes

Variants of M10x-TCP with MD31 panel

Description Kit Content Order Code

June 2, 2020 Slide 7

M10x Release – Firmware and Tool

M10x-M firmware 3.5 – New features and functions:

• Additional measurement values:

• Parameterizing tool MCUSetup 5.6 is released to

• Detailed M10x release content is available in the

June 2, 2020 Slide 8

M10x Release – Documentation

Along with the release, the relevant documents are updated:

• Smart MCC with M10x product brochure

All documents/tools available in ABB Intranet library and M10x

June 2, 2020 Slide 9

Modbus RTU-TCP converter MS572 MRP Switch

A generic Modbus RTU-TCP converter to provide a cost-effective

• MS572 support up to 4 Modbus TCP master

Modbus RTU-TCP Converter MS572

The configuration tool - MConfig-G 1.0

Easy connectivity to devices:

June 2, 2020 Slide 11

Modbus RTU-TCP Converter MS572

1TNA706111R0042 Installed in cable way

June 2, 2020 Slide 12

CMES Edge with CMES Edge with

Digital Gateway Digital Gateway

June 2, 2020 Slide 13

Modbus RTU-TCP Converter MS572

Along with the release, the relevant documents are updated:

• LVS Digital - MS572 converter User Manual

All documents/tools available in ABB Intranet library and LV

June 2, 2020 Slide 14

You might also like