Series 4SQ Stepper Motors 1.8°: Not Available For Sale in Europe
Series 4SQ Stepper Motors 1.8°: Not Available For Sale in Europe
Series 4SQ Stepper Motors 1.8°: Not Available For Sale in Europe
8°
Dimensions: mm/in
L/R
50 7.1
Wiring
45 6.4
Diagram
40 5.7
35 5.0
TORQUE (mN•m)
PULL OUT
30 4.2
OZ-IN
25 3.5
PULL IN
20 2.8
15 12.1
10 11.4
5 0.7
0 0
0 100 200 300 400 500 600 700 800 900 1000
SPEED (PPS)
Specifications
Part Number 4SQ - 120B34S
DC Operating Voltage 12 NOTE: Refer to page 7 for unipolar switching sequence
Res. per Winding Ω 5
Ind. per Winding mH 26 Catalog P/N Construction
Holding Torque mN•m/oz-in† 65/9.2
Example 1. Single Shaft Extension
Rotor Moment of Inertia g•m 2 1.9 x 10-3
Detent Torque mN•m/oz-in 8.5/01.2 4SQ 060 BA 34 S
Step Angle 1.8° Single Shaft Extension
Step Angle Tolerance† ±5% 34 mm/1.3 Length
Steps per Rev. 200
Aluminum End Bells
Max. Radial Load†† kg/lb 4/8.8
Max. Axial Load kg/lb 8/17.6 6 Volts
Max. Temp. Rise 55°C Basic Motor
Ambient Temp Range
Operating -20°C to +50°C Example 2. Double Shaft Extension
Storage -20°C to +60°C
Bearing Type Bal, Double Shielded 4SQ 120 BF 34 W
Insulation Res. at 500Vdc 50 megohms Double Shaft Extension
Dielectric Withstanding Voltage 500 Vac for 60 Sec 34 mm/1.3 Length
Weight g/oz 195/7 Steel End Bells
NOTE: Unless otherwise indicated all values shown are typical. Other windings available
on special order. Consult Thomson Airpax for availability of motors with 3.6° step angle. 12 Volts
†
Measured with 2 phases energized. ††
Measured at 10mm from mounting plate surface Basic Motor
For information or to place an order in North America: 1 (203) 271-6444 Asia: (65) 7474-888
The specifications in this publication are believed to be accurate and reliable. However, it is the responsibility of the
product user to determine the suitability of Thomson products for a specific application. While defective products will
be replaced without charge if promptly returned, no liability is assumed beyond such replacement.
26