CM67 User Guide
CM67 User Guide
CM67 User Guide
happens to my heating system? How can I check that the CM67 is working?
system? See the troubleshooting guide below. If you need assistance after this, call your Heating Installer. The CM67 should only be opened or removed by a qualified
Yes. Please refer to your installer for more information. professional to prevent possible injury from electric shock. CM67
Programmable
Mon Tue Wed Thu Fri Sat Sun
Thermostat
What other accessories can I buy that work with Symptom Possible Cause Remedy
the CM67? Blank Display No batteries Check batteries are in the battery compartment and that the
paper tab has been pulled out
Honeywell provides other accessories and “Add-On” modules that can
be used with your CM67, ask your installer for details : Battery orientation Check that the batteries have been installed in the correct
orientation.
1. Automatic Time Setting (ATS) “Add-On” Module * Exhausted batteries Replace batteries
The CM67 has a built-in Automatic Summer/Winter Time Change What if I don’t want to use all 6 temperature
If you have a DAY OFF today and want to control the temperature using The symbol will remain on the display of the CM67 until it is either reset
feature that will automatically adjust the clock forward or backward by change times? Sunday’s program press twice. To cancel any DAY OFF setting, press or disabled by your installer. The CM67 and heating system will continue
one hour for ‘Daylight Saving Time’. This is carried out on the last Sunday
of March and October each year. Although the CM67 has up to 6 repeatedly until the symbol disappears. to operate as normal.
temperature / time changes available
If not required this may be disabled by moving the slider to OFF position per day (PROG 1 – 6), any unused
and pressing the +, - and INFO buttons together. settings may be deleted by holding
1 2 3 4 5 6
down the appropriate button (PROG
Press the TEMP button (18:tC 0) to disable or the TEMP
2 – 6) for 2 seconds.
(18:tC 1) to enable.
To reinstate any deleted setting hold down the button again for 2
Mover the slider to AUTO to resume normal operation. seconds.