Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
256 views

Function Generator

A function generator is a piece of electronic test equipment used to generate electrical waveforms, such as sine, square, triangle, sawtooth waves, and noise, either as single pulses or repetitively. These waveforms can be used to test and evaluate electronic components and circuits. Function generators operate by using a capacitor that is charged and discharged to produce the base waveform, which is then shaped into the desired output waveform through comparators, diodes, and other circuits. More advanced models can generate any arbitrary waveform through direct digital synthesis.

Uploaded by

Chimaraoke Ndubueze
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
256 views

Function Generator

A function generator is a piece of electronic test equipment used to generate electrical waveforms, such as sine, square, triangle, sawtooth waves, and noise, either as single pulses or repetitively. These waveforms can be used to test and evaluate electronic components and circuits. Function generators operate by using a capacitor that is charged and discharged to produce the base waveform, which is then shaped into the desired output waveform through comparators, diodes, and other circuits. More advanced models can generate any arbitrary waveform through direct digital synthesis.

Uploaded by

Chimaraoke Ndubueze
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Function generator

A function generator is a piece of electronic test equipment or software used to generate


electrical waveforms. These waveforms can be either repetitive or single-shot, in which
case some kind of triggering source is required (internal or external).

Function Generators are used in development, testing and repair of electronic equipment,
e.g. as a signal source to test amplifiers, or to introduce an error signal into a control loop.

Contents
[hide]

• 1 Explanation
• 2 Other meanings
• 3 See also

• 4 External links

[edit] Explanation

Analog function generators usually generate a triangle waveform as the basis for all of its
other outputs. The triangle is generated by repeatedly charging and discharging a
capacitor from a constant current source. This produces a linearly ascending or
descending voltage ramp. As the output voltage reaches upper and lower limits, the
charging and discharging is reversed using a comparator, producing the linear triangle
wave. By varying the current and the size of the capacitor, different frequencies may be
obtained. Sawtooth waves can be produced by charging the capacitor slowly, using a
current, but using a diode over the current source to discharge quickly - the polarity of the
diode changes the polarity of the resulting sawtooth, i.e. slow rise and fast fall, or fast rise
and slow fall.

A 50% duty cycle square wave is easily obtained by noting whether the capacitor is being
charged or discharged, which is reflected in the current switching comparator's output.
Other duty cycles (theoretically from 0% to 100%) can be obtained by using a
comparator and the sawtooth or triangle signal. Most function generators also contain a
non-linear diode shaping circuit that can convert the triangle wave into a reasonably
accurate sine wave. It does so by rounding off the hard corners of the triangle wave in a
process similar to clipping in audio systems.

A typical function generator can provide frequencies up to 20 MHz. RF generators for


higher frequencies are not function generators in the strict sense since they typically
produce pure or modulated sine signals only.

Function generators, like most signal generators, may also contain an attenuator, various
means of modulating the output waveform, and often the ability to automatically and
repetitively "sweep" the frequency of the output waveform (by means of a voltage-
controlled oscillator) between two operator-determined limits. This capability makes it
very easy to evaluate the frequency response of a given electronic circuit.

Some function generators can also generate white or pink noise.

More advanced function generators use Direct Digital Synthesis (DDS) to generate
waveforms. Arbitrary waveform generators use DDS to generate any waveform that can
be described by a table of amplitudes.

[edit] Other meanings

Another type of function generator is a sub-system that provides an output proportional to


some mathematical function of its input; for example, the output may be proportional to
the square root of the input. Such devices are used in feedback control systems and in
analog computers. A function generator IC named ICL8038 (which is also used as
Voltage Controlled Oscillator (VCO)) can be used to generate triangular wave, square
wave, saw-tooth wave or even, sine wave simultaneously. For maximum voltage rating of
36, more than 300kHz of frequency can be generated.

You might also like