Green International - UPDA Electrical

Question & Answer - 2

1. 100 resistors of 100 ohm each connected in parallel. What is the equivalent
resistance?
A. 100 ohm
B. 10 ohm
C. 1 ohm
D. 0.1 ohm

2. Permanent magnet has a relative permeability that is _________ magnetic

material:
A. Higher than
B. Lower than
C. Equal to
D. Not Equal to

3. The single-phase motor generally used with household ceiling fans is:
A. Split phase type
B. Capacitor start type
C. Permanent Capacitor type
D. None of the above

4. The voltage regulation of an alternator is ___________ for capacitive loads.

A. Positive
B. Negative
C. Zero
D. All of the above

CONTACT US:
6646 4941/3340 3359 1
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

5. For effective earthling, which of the following mixture is preferred for filling
around the earth electrode?
A. Lime-Sand mixture
B. Saw Dust – Sand mixture
C. Bone Meal mixture
D. Coal-Salt mixture

6. A series of fuel cells is connected to produce a no-load voltage of 230V at

a rated voltage of 300V, the cells provide 2.0MW to a DC-AC converter.
Assuming the cell van be modeled as a standard battery, what is the total
internal resistance of the fuel cells:
A. 0.0001
B. 0.003
C. 0.05
D. 3

7. A room with a floor area of 50ft x 30ft and a ceiling height of 10ft has
luminaries suspended 2ft from the ceiling. Assuming a working plane of 30in
and a required illumination level of 50fc, the net luminous flux (lumens) using
fixtures with a coefficient of utilization of 0.78 is most nearly:
A. 48000
B. 58000
C. 75000
D. 96000

CONTACT US:
6646 4941/3340 3359 2
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

8. The motor used in travelling crane is:

A. Ward Leonard Controlled DC Shunt Motor
B. Slip Ring AC Induction Motor
C. AC Split Motor
D. DC Differentially Compound Motor

9. A motor is equipped with an optical shaft encoder to measure motor speed.

The optical encoder provides 200 pulses per motor revolution. A
microcontroller equipped with a real-time interrupt (RTI) capability is used to
measure motor speed. The RTI interval is 32.768ms. The microcontroller
counts 372 pulses from the optical encoder in the RTI interval. The speed
(rpm) of the motor is:
A. 33
B. 568
C. 3276
D. 3400

10. Which one is the harmonic source in the following list?

A. Variable impedance loads
B. Saturable magnetic loads
C. Power electronic based loads
D. All of the above

CONTACT US:
6646 4941/3340 3359 3
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

11. The spinning reserve is the:

A. Generating capacity that is connected to the grid and ready to take the
load
B. Generating capacity that is available for service but not in operation
C. Generating capacity under maintenance
D. None of the above

12. Two resistances R1 and R2 give combined resistance of 4.5 ohms when in
series and 1 ohm when in parallel. The resistances are:
A. 3 ohms and 6 ohms
B. 3 ohms and 9 ohms
C. 1.5 ohms and 3 ohms
D. 1.5 ohms and 0.5 ohms

13. What is analysis technique to determine effect of multi-sources?

A. Kirchhoff Law
B. Shannon Law
C. Miller Law
D. Superposition

14. First line in Transmission is used for?

A. Ground
B. R-Phase
C. B-Phase
D. Neutral

CONTACT US:
6646 4941/3340 3359 4
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

15. Which circuit breaker in commonly used in the distribution level?

A. Air Circuit Breaker
B. Air Blast Circuit Breaker
C. SF6 Circuit Breaker
D. Tank Type Oil Circuit Breaker

16. A variable resistance R is connected across a source of voltage V, if the

value of the resistance R is gradually varied, the relationship between I and R
will be represented by which curve?

A. Figure A
B. Figure B
C. Figure C
D. Figure D

17. In 50hz induction machine, if the no load speed is 2900 RPM, the slip
frequency is:
A. 0.33 Hz
B. 0.67 Hz
C. 1.33 Hz
D. 1.67 Hz

CONTACT US:
6646 4941/3340 3359 5
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

18. In which of figure the relationship between voltage and current is in

accordance with Ohms Law:

A. Figure A
B. Figure B
C. Figure C
D. Figure D

19. Harmonic currents present in a power system may cause:

A. Excessive heating
B. Malfunctioning of the control and regulating circuits
C. Resonance
D. All of the above

20. Which one of the following is not correct based on Ohm’s Law?
A. Potential / Current = Constant
B. Current / Potential = Constant
C. Current = Potential x Resistance
D. Potential = Current x Resistance

CONTACT US:
6646 4941/3340 3359 6
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

21. The transfer function Y/R for the block diagram shown below is:

A. A is correct

B.

C.

D.

22. We have three resistance each of 1 Ohm. How many different values of
resistance can be obtained by different series-parallel combinations if all the
three resistance are to remain in the circuit?
A. 3
B. 4
C. 5
D. 6

CONTACT US:
6646 4941/3340 3359 7
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

23. The wind load LSi in Newton’s on an overhead line structure is calculated
using the following formula.
Lsi = 0.613v2 m/s KzGRF / CfAm2. What does the Kz term represents?
A. Force Coefficient
B. Guest Response Factor
C. Velocity Pressure Coefficient
D. Wind Speed

24. The resistance of 100W, 200V tamp is:

A. 100 ohms
B. 200 ohms
C. 400 ohms
D. 1600 ohms

25. For which of the following circuits elements is superposition valid?

A. Independent source
B. Dependent source
C. Charged capacitor
D. Inductor with IInitial not equal to zero

26. If fuse rate = 8 Ampere, what does mean?

A. It will not work if current is less than
B. It has a resistance of 8W
C. It will work only if current is 8A
D. It will melt if current exceeds 8A

CONTACT US:
6646 4941/3340 3359 8
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

27. Which one of the following is not describes ceramic?

A. Crystallizers
B. High Resistivity
C. High Conductivity
D. Insulator

28. The device used for measuring potential difference is known as:
A. Potentiometer
B. Ammeter
C. Galvanometer
D. Voltmeter

29. V = 50 Cos (40wt + 30) + 28.2 Cos (40wt + 30), R = 5, find P:

A. 1025
B. 660
C. 330
D. 550

30. Weak power system means:

A. Power system with high short circuit capability and low sensitivity to
harmonics
B. Power system with high short circuit capability and high sensitivity to
harmonics
C. Power system with low short circuit capability and low sensitivity to
harmonics
D. Power system with low short circuit capability and high sensitivity to
harmonics

CONTACT US:
6646 4941/3340 3359 9
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

31. In 50Hz induction machine, if the no load speed is 2900 rpm, the slip
frequency is:
A. 0.33 Hz
B. 0.67 Hz
C. 1.33 Hz
D. 1.67 Hz

32. To make sure that an instrument did not drift with time, we need to:
A. Heat it up
B. Change it
C. Calibrate it
D. Put it into higher position

33. When using the method of symmetrical components, which of the following
statements is most nearly correct:
A. The three zero sequence current phasor are equal in magnitude and
displaced by 1200.
B. The three positive sequence and the three negative sequence current
phase are all equals in magnitude, but have opposite phase.
C. In wye connected synchronous generator, the voltage drops through the
neutral grounding resistor, R is equal to √3 Io R, where I0 is the zero-
sequence current.
D. Positive sequence and negative sequence currents cannot pass through
the neutral grounding resistor in a wye-connected generator.

CONTACT US:
6646 4941/3340 3359 10
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

34. A circuit breaker is:

A. A current interrupting device
B. Power factor correcting device
C. Harmonics correcting device
D. All of the above

35. Which system will cause saturated currents?

A. 50 Hz transformer by rated MVA but 60 Hz
B. 3 Phase 50 Hz motor by Inverter of rated voltage but half of frequency

36. A battery which factor is least dependent for long self-discharge property:
A. concentration of electrolyte
B. temperature
C. long period
D. nominal voltage

37. A Wrist watch mercury cell has a capacity of 200 x 10 -3 AH. How many
months can the watch function without replacement if it draws 15 x 10 -6 A?
A. 9 months
B. 18 months
C. 24 months
D. 30 months

CONTACT US:
6646 4941/3340 3359 11
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

38. The system shown is stable for:

A. k >-2
B. – 3 < k <0
C. k <-2
D. – 3 < k <2

39. While machine in operation, the slip of the synchronous machine is:
A. High
B. Low
C. Zero
D. 1

40. In the 3-phase system, the neutral is:

A. Normal return path for the current
B. Abnormal return path for the current
C. A and B
D. None of the above

CONTACT US:
6646 4941/3340 3359 12
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

41. Which of the following Braking system is used in the induction motor?
A. Regenerative Braking
B. Plugging Braking
C. Dynamic Braking
D. All of the Above

42. Induction motor running at synchronous speed, the torque will be:
A. Low
B. High
C. 0

43. 3 Phase balanced system with Irms = 60A and 3rd harmonic phase current of
3A. What will be the neutral current?
A. 60 / √3
B. 60 √3
C. 9A

44. The motor used in travelling crane is:

A. Ward Leonard Controlled DC Shunt Motor
B. Slip Ring AC Induction Motor
C. AC Split Motor
D. DC Differentially Compound Motor

CONTACT US:
6646 4941/3340 3359 13
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

45. Which one of the following is not an insulating material?

A. Asbestos
B. Glass
C. Porcelain
D. Thermocoal
Asbestos. Glass, Thermocoal are insulating material whereas porcelain is
an insulator

46. If the rotor is in standstill position, what is slip?

A. Zero
B. One
C. Infinity
D. Any Slip

47. If the motor is running with very heavy load, suddenly the mechanical load
is reduced to zero, what will be the affect at the motor?
A. Motor will gain synchronous speed.
B. Motor will first move above synchronous speed and later stay just below
synchronous speed.
C. The power factor of motor will increase.
D. Motor will run at initial speed

CONTACT US:
6646 4941/3340 3359 14
TRAINING@GREENINTL.NET
 Green International - UPDA Electrical
Question & Answer - 2

48. 100 resistors of 100 ohm each are connected in parallel. Their equivalent
resistance will be:
A. 10000 ohms
B. 100 ohms
C. 1 ohm
D. 1/1000 ohms

49. Major factor to be considered while designing distribution system:

A. Efficiency
B. Voltage regulation
C. Power factor
D. Reliability

50. The self-discharge rate of a lead-acid battery is least dependent on which

of the following factors?
A. concentration (specific gravity) of electrolyte
B. age of battery
C. temperature
D. nominal voltage of battery

CONTACT US:
6646 4941/3340 3359 15
TRAINING@GREENINTL.NET