RAPID LEVEL

PATENTED LEVEL SWITCHES WITH

* The required length can be obtained simply by cutting the steel rod, using an
ordinary pipe cutter; or the switching point can be varied by using a float with
through hole allowing the required liquid control point to be modified whenever
BASE ULTRASONIC WELDING necessary.
* It can be used for dirty liquids, water, petroleum, cutting oils, and tolerates the
FIXING SCREWS SEAT presence of metal and ferrous particles, since the float does not hold a magnet and
is integral with the rod.
* One float can operate just one Reed (min. or max. level), or two Reeds (min. and
MAGNET SEAL empty and extra max. level) thus meeting the most complex needs.
* Total safety since the electrical part is completely separate in the tank side and
perfectly sealed with respect to the external side by means of ultrasonic welding.
* The nylon-glass body is very strong and very resistant with respect to chemicals,
BODY and is ideal as an insulating container for the Reed contacts.
* The Rapid Levels come standard with rods suitable for control of a max.
measurement of 500 or 1000mm. To obtain specific measurements, refer to the
UNION
table on the next page.
* They can be ordered already arranged for the control of predetermined
S/STEEL CONTROL ROD
measurements.
SILICONE SHEATH

THROUGH FLOAT
On request the float can be supplied with through hole
and therefore be positioned in the required position
without having to cut the rod (which can therefore
FLOAT be as long as the height of the tank). If necessary, the
liquid control point can be subsequently be modified
as required by simply moving the float. Available on
request with AISI 316 stop.

78
RAPID LEVEL
Rapid Level connection rod
cutting table.
(NB : Carry out the cutting measurement
with the rod in traction with respect to the
body)

B
L1

A
L

H1
A
L

H
L-L1 = 100 mm
A-B = 90 mm

H = 35 (L = 90 mm)
H = 45 (L = 100 mm)
H = 55 (L = 110 mm)
H = 60 (L = 120 - 500 mm)
H

H = 90 (L = 501 - 1000 mm)

79
RL/G1-F3 RAPID LEVEL” TYPE LEVEL SWITCH
WITH 1 FLOAT RL/G1-1”GAS

ADVANTAGES OF THE RANGE

15 31
Ø 55 Ø 50
1- These electromagnetic level gauges in Kits can be obtained
in the required length “L” simply by cutting the control rod with 1” GAS

80
an ordinary pipe cutter and press fitting the float in the cutting
place (see table for cutting).

35 2- The control rod can commutate the signal of 1 or 2 Reeds in

Ø 4,3 3- The float does not hold magnets, therefore the Level can also Ø 4,3
be used in the presence of dirty liquids or ferrous particles.

Maximum working pressure: 10Bar.

H
H

30
30

CONNECTION:
FIXING DIAGRAM Connector CE
EN 175301-803-A IP65 PG.9/11
+0,5

T
Ø 35 -0

Ø 43

1 2
M4
3

RL-F2 RL-F3

80
* INSTALLATION POSSIBLE ONLY FROM INSIDE BY REMOVING THE FLOAT AS IT DOES NOT PASS FROM THE PROCESS ATTACK

81