Quantity Estimation of Storm Water Quantity Estimation of Storm Water
Quantity Estimation of Storm Water Quantity Estimation of Storm Water
Module 6:
Quantity Estimation of Storm Water
Lecture 6:
Quantity Estimation of Storm Water
1
Wastewater Management
1. Rational Method
2. Empirical formulae method
In both the above methods, the quantity of storm water is considered as function of intensity of
rainfall and coefficient of runoff.
Time of Concentration: The period after which the entire catchment area will start
contributing to the runoff is called as the time of concentration.
• The rainfall with duration lesser than the time of concentration will not produce
maximum discharge.
• The runoff may not be maximum, even when the duration of the rain is more than the
time of concentration. This is because in such case the intensity of rain reduces with
the increase in its duration.
2
Module – 6, Lecture Number - 06 M.M. Ghangrekar, IIT Kharagpur
• The runoff will be maximum, when the duration of rainfall is equal to the time of
concentration and is called as critical rainfall duration. The time of concentration is
equal to sum of inlet time and time of travel.
Time of concentration = Inlet time + time of travel
Inlet Time: The time required for the rain in falling on the most remote point of the tributary
area to flow across the ground surface along the natural drains or gutters up to inlet of sewer is
called inlet time (Figure 6.1). The inlet time ‘Ti’ can be estimated using relationships similar
to following. This coefficients will have different values for different catchments.
Ti = [ 0.885 L3/H]0.385
Where,
Ti = Time of inlet, time
L = Length of overland flow in Kilometer from critical point to mouth of drain
H = Total fall of level from the critical point to mouth of drain, meter
Time of Travel: The time required by the water to flow in the drain channel from the mouth to
the point under consideration or the point of concentration is called as time of travel.
Time of Travel (Tt) = Length of drain/ velocity in drain
Runoff Coefficient: The total precipitation falling on any area is dispersed as percolation,
evaporation, storage in ponds or reservoir and surface runoff. The runoff coefficient can be
defined as a fraction, which is multiplied with the quantity of total rainfall to determine the
3
Wastewater Management
quantity of rain water, which will reach the sewers. The runoff coefficient depends upon the
porosity of soil cover, wetness and ground cover. The overall runoff coefficient for the
catchment area can be worked out as follows:
The typical runoff coefficient for the different ground cover is provided in the Table 6.1.
4
=
Q 141.58
=
Q 148.35
C] Fuller’s formula
C.M 0.8
Q=
13.23
(Where, S- Slope of the are, M- drainage area in sq. km., A – drainage area in hect.)
These relationships between rainfall intensity and duration are developed based on long
experience in field (Figure 6.2). Under Indian conditions, intensity of rainfall in design is
usually in the range 12 mm/h to 20 mm/h. In general, the empirical relationship has the
following forms:
I = a/ (t + b) OR I = b / tn
5
Wastewater Management
6.4 Examples
1. Determine designed discharge for a combined system serving population of 50000 with
rate of water supply of 135 LPCD. The catchment area is 100 hectares and the average
coefficient of runoff is 0.60. The time of concentration for the design rainfall is 30 min
and the relation between intensity of rainfall and duration is I = 1000/(t + 20).
Solution
Estimation of sewage quantity
Considering 80% of the water supplied will result in wastewater generation,
the quantity of sanitary sewage = 50000 x 135 x 0.80 = 5400 m3/day = 0.0625 m3/sec
Considering peak factor of 2.5, the design discharge for sanitary sewage = 0.0625 x 2.5
= 0.156 m3/sec
Estimation of storm water discharge
Intensity of rainfall, I = 1000/(t + 20)
Therefore, I = 1000/(30 + 20) = 20 mm/h
Hence, storm water runoff, Q = C.I.A/360
= 0.6 x 20 x 100/(360) = 3.33 m3/sec
Therefore, design discharge for combined sewer = 3.33 + 0.156 = 3.49 m3/sec
2. The catchment area is of 300 hectares. The surface cover in the catchment can be
classified as given below:
Type of cover Coefficient of runoff Percentage
Roofs 0.90 15
Pavements and yards 0.80 15
Lawns and gardens 0.15 25
Roads 0.40 20
Open ground 0.10 15
Single family dwelling 0.50 10
Calculate the runoff coefficient and quantity of storm water runoff, if intensity of rainfall is
30 mm/h for rain with duration equal to time of concentration. If population density in the
area is 350 persons per hectare and rate of water supply is 200 LPCD, calculate design
discharge for separate system, partially separate system, and combined system.
Solution
Estimation of storm water discharge for storm water drain of separate system
6
Module – 6, Lecture Number - 06 M.M. Ghangrekar, IIT Kharagpur
= (0.15 x 0.90 + 0.15 x 0.80 + 0.25 x 0.15 + 0.20 x 0.4 + 0.15 x 0.1 + 0.10 x 0.5)
0.15 + 0.15 + 0.25 + 0.20 + 0.15 + 0.10
= 0.44
= 0.44 x 30 x 300/360
= 11 m3/sec
Quantity of sanitary sewage = 300 x 350 x 200 x 0.80 = 16800 m3/day = 0.194 m3/sec
Considering peak factor of 2, the design discharge for sanitary sewers = 0.194 x 2
= 0.389 m3/sec
Storm water discharge falling on roofs and paved courtyards will be added to the sanitary
sewer. This quantity can be estimated as:
Average coefficient of runoff = (0.90 x 45 + 0.80 x 45) / 90 = 0.85
Discharge = 0.85 x 30 x 90 / 360 = 6.375 m3/sec
Therefore total discharge in the sanitary sewer of partially separate system = 6.375 + 0.389 =
6.764 m3/sec and the discharge in storm water drains = 11 – 6.375 = 4.625 m3/sec
Questions
1. Explain the factors affecting the storm water discharge.
2. What is time of concentration? What is its role in determination of the storm water
runoff?
3. Explain critical rainfall duration. Why rainfall of this duration will generate maximum
runoff?
4. Write short notes on the estimation of storm water runoff.
5. What is coefficient of runoff?
6. A catchment is having total area of 60 hectares. The rainfall intensity relation with
duration for this catchment is given by the relation I = 100/(t+20), where I is in cm/h
and t is duration of rain in min. (A) Draw the graph of rainfall intensity relation with
duration at 10 min interval? (B) What will be the storm water runoff from this
catchment if the average imperviousness factor is 0.63, and time of concentration is 35
7
Wastewater Management
min? (C) If population density of the area is 350 persons per hectare and water
consumption is 170 LPCD, what will be the design discharge for separate system and
combined system?