Chips Manual

®
Hi.
Good call on picking up the Outdoor
Tech® CHIPS®, universal wireless helmet
audio. Your experience of the universe
will soon be enhanced wirelessly. This
manual exists to help make sure that
you use them correctly, so you’re
definitely going to want to relax for a hot
second and look through this.
Kisses,
ANATOMY
Right ear button LED light

Left ear button Microphone
Charge port/3.5 mm
ANATOMY (CONTINUED)
Press till song skips
Siri / Voice Activation Press & hold until you

LEFT + RIGHT hear voice prompt
FUNCTION VOICE PROMPT

Power On “Power On”
Power Off “Power Off”
Enter Pairing Mode “Pairing”
Successful Pairing “Connected”
Answer “Answer”
Reject “Reject”
Hang Up “Call Terminated”

POWER UP
For best results, fully charge your CHIPS® using the sup-
plied 3.5 mm to USB charging cable before use.
You can manage/check your CHIPS® batter by the fuel

gage that appears on your smartphone,
The indicator light located on the right ear piece will

flash red to indicate a low battery.
Once the CHIPS® are plugged into the micro-USB, the in-
dicator light will turn red. It will turn off once the CHIPS
are completely charged.
NOTE: It takes 2.5 hours to give your CHIPS® a full

charge.
PAIRING
To pair the CHIPS® with a Bluetooth-enabled

device:
Prior to using the OT CHIPS® for the first time, you will
have to pair them with a Bluetooth-enabled device.
The pairing procedure may vary for different devices.
Please refer to your device’s user manual for further
information. The general pairing procedure is as
follows:
1.) Place the OT CHIPS® and Bluetooth-enabled
device no more than 3 feet apart.
2.) Hold the right ear button down until the LED
flashes red and blue alternately. The voice
prompt will state “Pairing”
3.) Activate your device’s Bluetooth function and
set your device search for Bluetooth devices
within range. Select “ODT CHIPS” from
the list of devices shown.
4.) According to the indication, enter password or
Use pairing code: 00007.
5.) If prompted by your device to connect, select
“Yes” (this will vary among devices)
6.) After successfully connecting, the blue LED will
flash twice or three times every 4 seconds. The
voice prompt will state “Connected.”
If your Bluetooth device disconnects from the

CHIPS the voice prompt will state “Your headset
is disconnected.”
TALK
The built-in microphone means that the CHIPS® can be

used wirelessly.
*NOTE: The built-in microphone only works when

connected via Bluetooth.
The following are tips on how to use your CHIPS® to

speak on the telephone:
Answer a call............. Press right ear button

End a call................... Press right ear button
Decline a call............. Press and hold the right ear
button for two seconds
Make a call................ Use your phone to dial as usual
Listen & talk through the CHIPS®
Mute/cancel mute
during a call.............. Press the right ear button twice
Transfer conversation
to mobile phone or
headset during call.. Press and hold right ear button for
2 seconds
Volume up during a
call.......................... Double press the left ear button
Volume down during
a call........................ Press left ear button
Voice Activation....... Press and hold both left and right
ear buttons simultaneously.
Release and speak when you hear
the voice prompt.
SPECS
Battery life............ 10 hours of play time / 200

hours of standby
*Battery life varies subject to different

playing circumstances, such as music type
and volume.
Bluetooth Version.... V4.0

Bluetooth Profiles.... A2DP, AVRCP
Operating distance.. 32 feet
Charging input......... DC5.0V/90~130mA
Dimensions.............. 51x14.5mm
Weight...................... 60g
Battery capacity...... 240mAH
FAQ
Why is the red LED flashing twice every 20

seconds?
The battery is low. Recharge it.
Why is the red LED off when charging?

A. Make sure the connection between the charging
cable and the CHIPS® is tight.
B. If the CHIPS® haven’t been used in awhile, the
light may not come on immediately. Charge the
battery for at least 30 minutes.
Why can’t I pair my CHIPS®?

A. Your Bluetooth device and the CHIPS® must both
be in pairing mode.
B. Your CHIPS® should not be paired to any other
devices.
Why do I have Bluetooth signal loss/dropout/un-

clear conversations?
A. Move your device closer to your CHIPS®.
B. Make sure your CHIPS® are charged up.
C. Turn off your CHIPS® and device, then power up
and reconnect.
Why can’t the CHIPS® hear my voice during a call?

A. Make sure the CHIPS® are on.
B. Make sure the volume is not too low or muted.
C. Make sure the CHIPS® are properly connected
with your device.
D. Make sure the CHIPS® are within range of your
device.
CARE & MAINTENANCE
-Keep the CHIPS® dry

-Keep the CHIPS® away from direct sunlight or hot
places. High temperatures will shorten the life
of electronic devices, destroy the battery or
distort certain plastic parts.
-Do not try to disassemble the CHIPS®.
-Do not let the CHIPS® fall onto the floor or other
hard surfaces. The internal circuit board may get
damaged.
-Do not use intensive chemical products or
detergent to clean the product.
-Do not scratch the surface with sharp things.
PUT THE CHIPS IN YOUR HELMET
1. Drop the CHIPS® into the slots inside your

helmet liner.
2. Rock out, make calls, and, you know, ski

and snowboard and whatnot.
JACK IT IN
The included 3.5mm cord allows you to rock

out when the CHIPS® are out of power.
Plug the end with the microphone and control

wheel into the CHIPS®, and into your preferred
music playing robotic device. Then proceed
to rock out.
*The microphone on the CHIPS® will not

function when you’re playing music through
the 3.5 mm jack. Instead, you’ll be able to use
the inline mic on the 3.5mm cord.
DON’T BE SO ANTISOCIAL
Facebook.com/outdoortech
Twitter & Instagram: @outdoortech
Questions, comments, complaints, secret desires,

or just to say what’s up: email info@outdoortech.com
K bye.
outdoortech.com
U.S. Des. Pat. No. D704,676 S.

Chips Manual

Uploaded by

Copyright:

Available Formats

Chips Manual

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Chips Manual

Uploaded by

Copyright:

Available Formats

®

Right ear button LED light

Press till song skips

Siri / Voice Activation Press & hold until you

FUNCTION VOICE PROMPT

Power Off “Power Off”

Enter Pairing Mode “Pairing”

Successful Pairing “Connected”

Hang Up “Call Terminated”

You can manage/check your CHIPS® batter by the fuel

The indicator light located on the right ear piece will

NOTE: It takes 2.5 hours to give your CHIPS® a full

To pair the CHIPS® with a Bluetooth-enabled

If your Bluetooth device disconnects from the

The built-in microphone means that the CHIPS® can be

*NOTE: The built-in microphone only works when

The following are tips on how to use your CHIPS® to

Answer a call............. Press right ear button

Battery life............ 10 hours of play time / 200

*Battery life varies subject to different

Bluetooth Version.... V4.0

Why is the red LED flashing twice every 20

Why is the red LED off when charging?

Why can’t I pair my CHIPS®?

Why do I have Bluetooth signal loss/dropout/un-

Why can’t the CHIPS® hear my voice during a call?

-Keep the CHIPS® dry

1. Drop the CHIPS® into the slots inside your

2. Rock out, make calls, and, you know, ski

The included 3.5mm cord allows you to rock

Plug the end with the microphone and control

*The microphone on the CHIPS® will not

Questions, comments, complaints, secret desires,

U.S. Des. Pat. No. D704,676 S.

You might also like