Calibration Certificate: Page 1 / 1
Calibration Certificate: Page 1 / 1
Calibration Certificate: Page 1 / 1
1 Using a master field indicator to find out the + 0 to 20 Gauss Gauss meter facing the 0% Gauss meter facing the
magnetic polarity of the coil. Red dot of the coil at 2 Red dot of the coil at 2
feet showed pointer on feet showed pointer on
the positive reading. the positive reading.
2 Checking the magnetic field strength of the coil >3 lines of indication on All lines are visible at 9" 0% All lines are visible at 9"
with the aid of a bermeal castrol strip and strip distance away from the distance away from the
magnetic iron powder. center of the coil center of the coil
Remarks : This equipment is a non-adjustable testing device. This equipment is assigned in DSI.
Statement Of Traceability :
All standards used for calibration/verification are traceable to National Institute of Standards and Technology (N.I.S.T.) or other international/national standards. Its
calibration is carried out by either an ISO/IEC 17025: 2005 accredited calibration laboratory, or have been derived from accepted values/physical constants, or have
been derived by ratio/documented calibration techniques. All calibration performed are in compliance with SIGS Operating Procedures Manual, OPM Tier - II (ISO
9001: 2008)
This certified that the above mentioned measuring / test ( with the above mentioned serial number ) has been calibrated and is found to be acceptable for use in
measurement / verification of product dimensions to verify product conformance to drawings / specifications / customer requirements and national / international
standards / specs.
page 1 / 1