F
F
90 m
below the ground surface. Beneath the sand layer is a 1.8 m clay layer. Beneath the clay layer is a hard
pan. The water table is at a depth of 1.8 m below the ground surface.
1. Compute the stress increase at the center of the clay layer assume that the pressure beneath the
footing is spread at an angle of 2 vertical to 1 horizontal.
a. 36.55 kPa b. 21.18 c. 25.51 d. 30.18
2. Determine the size of footing B so that the settlement in the clay layer is the same beneath
footings A and B. Footing A is 1.5 m square.
a. 3.24 m b. 4.18 c. 3.78 d. 4.77
SITUATION 2: A concrete pile having a diameter of 0.30 m is to be driven into a loose sand having a unit
weight of 20 kN/ cu m. The pile has a length of 12 m. Coefficient of friction between the sand and pile
is 0.4. Bearing capacity factor Nq = 80. The shaft lateral pressure factor K is equal to 0.90. Allowable
load of the pile is 170 kN.
SITUATION 3: A 7 m deep braced cut in sand is shown in the figure. In the plan the struts are placed at a
spacing of 2 m center to center. Using Peck’s empirical pressure diagram,
SITUATION 4: A retaining wall 7 m high is supporting a horizontal backfill having a dry unit weight of
1570 kg/m3. The cohesionless soil has an angle of fricrion of 34° and a void ration of 0.68.
11. Compute the Rankine active force on the wall if water logging occurs at a depth of 3 m from the
ground surface.
a. 172 kN b. 166 c. 184 d. 153
12. Compute the location of the resultant active force from the bottom.
a. 1.88 m b. 1.95 c. 2.02 d. 2.18
SITUATION 5: A cantilever sheet pile is 8.2 m long with a depth of embedment of 3.2 m. Angle of friction
of the soil supported by the sheet pile is 34° and has a unit weight of 1.91 g/cc. There is water table
below the base of the sheet pile. Use γwater = 9.81 kN/m3.
15. Compute the theoretical passive force that must be mobilized to ensure stability.
a. 477.9 kN/m b. 505.8 c. 488.3 d. 456.9
SITUATION 6: In the soil profile shown, the clay layer is normally consolidated and the ground water
location maybe assumed to remain constant. The raft foundation is 15 m x 15 m with a uniform loading of
192 kPa.
16. Compute the initial effective stress at the midpoint location of clay layer.
a. 142.47 kPa b. 161.85 c. 196.03 d. 207.10
20. He proposed a method based on pressuremeter tests from which the load-settlement diagrams of
foundations can be derived.
a. Meyerhof b. Boussinesq c. Briaud d. Westergaard
21. A vertical cut is to be made through a soil mass. The soil to be cut has the following properties:
a. 18 kPa b. 12 c. 48 d. 26
22. These consists of four equal sized thin steel plates welded to a steel torque.
a. Sieve b. Pressuremeter c. Sand cone d. Shear vane
SITUATION 7: A cantilevered retaining wall was originally designed with a base width of 3 m but it was
actually constructed with a base width of 1.8 m. The original design incorporated a factor of safety of 2
and ignored passive pressure.
25. Compute the location of the resultant lateral force from the bottom of the wall footing.
a. 1.47 m b. 1.77 c. 1.96 d. 2.13
26. Compute the new factor of safety against overturning moment about the toe.
a. 1.25 b. 1.37 c. 1.50 d. 1.63
SITUATION 8: A concrete pile 12 m long having cross section of 0.30 m x 0.30 m is fully embedded into a
layer of sand assuming C = 0. Frictional resistance of pile at working condition is 200 kN and 100 kN is
the point load capacity at working condition. Allowable working load is 340 kN.
28. Compute the settlement caused by the load transmitted along the pile shaft.
a. 0.577 mm b. 0.601 c. 0.389 d. 0.638
29. A square column foundation has to carry a gross allowable load of 1805 kN , FS = 3 ,d f = 1.5 m, γ
= 15.9 kN/m^3, ϕ = 34° , and c = 0. Compute the width of the footing.
a. 3 m b. 4.5 c. 2 d. 1.75
31. At what minimum height H will the clay layer not have any effect on the ultimate bearing capacity
of the foundation?
a. 10 m b. 11 c. 12 d. 13
SITUATION 10: A mat foundation having dimensions of 100 x 32 ft carries a total weight of structure plus
live load of 5200 tons. The mat foundation is supported by sand underneath. Unit weight of sand is 125
pcf. The N value from the standard penetration test is equal to 18 with a correction factor C n = 0.62. If
the base of the footing is 8 ft below the ground level,
32. Compute the overburden pressure 8 ft below the ground in tons per sq ft.
a. 0.48 b. 0.56 c. 0.61 d. 0.68
33. Find the allowable net soil pressure. Hint: use Pallow = 0.22N.
a. 4.74 tons/ft^2 b. 4.90 c. 3.64 d. 3.96
34. Determine the factor of safety against bearing capacity failure. Note: Because the differential
settlement of a mat foundation are less than those of an individual footing foundation designed
for the same soil pressure, it is reasonable soil pressures approximately two times as great as
that allowed for individual footings maybe used because it does not lead to detrimental
differential settlements.
a. 7.71 b. 5.57 c. 6.15 d. 6.92
SITUATION 11: A soil profile shown in the figure. A uniformly distributed load of 50 kPa is applied at
the ground surface. The clay is normally consolidated.
37. Compute the secondary settlement 8 years after the completion of primary consolidation settlement.
Time for completion of primary settlement is two years. Assume that secondary compression index is
0.025.
a. 24 mm b. 48 c. 52 d. 35
38. For timber piles, the Class A types have the minimum diameter of its butt of:
a. 305 mm b. 330 c. 320 d. 356
39. A vertical retaining wall 4 m high with a cohesionless horizontal soil backfill with a unit weight
of 15.5 kN/m^3 , angle of internal friction = 30° , angle of friction between soil and the wall is
15°. Compute the active earth pressure coefficient for static condition.
a. 0.2866 b. 0.3014 c. 0.3255 d. 0.3656
41. It is the slope of the normal consolidation line in a plot of void ratio against the natural
logarithm of mean effective stress.
a. Plasticity index b. Consolidation index c. Liquidity index d. Compression index
SITUATION 13: From the figure shown, the soil has a unit weight of 17 kN/m^3 and undrained shear strength
of cu = 20 kPa. The slope makes an angle of 60° with the horizontal. Assume stability number m = 0.185.
45. Compute the angle that the failure plane makes with the horizontal if BC = 8 m.
a. 28.59° b. 31.56° c. 34.55° d. 38.13°
46. A retaining wall 6 m high is supporting a horizontal backfill having dry unit weight of 1600 kg
/m^3. The cohesionless soil has an angle of friction of 32° and a void ratio of 0.68. Compute the
Rankine active force of the wall.
a. 91.55 kN b. 64.07 c. 78.55 d. 86.76
47. A 0.3 x 0.3 concrete pile is driven into a clayey soil having a unconfined strength of 110 kPa.
The pile has a length of 10 m. Unit weight of clay is 18 kN/m^3. Compute the ultimate frictional
capacity using alpha method with α = 0.50.
a. 210 kN b. 350 c. 270 d. 400
SITUATION 14: The footing shown carries a column load of 136,400 kg on a column section 60 x 60 cm.
neglecting the weight of the footing.
50. Compute the pile load on lowermost left corner (pile 7).
a. -178.85 kg b. -212.56 c. -252.60 d. -318.41