Pico Product Brief PDF
Pico Product Brief PDF
Pico Product Brief PDF
www.raspberrypi.org
Overview
Raspberry Pi Pico pairs RP2040 with 2MB of Flash memory, and a power supply
chip supporting input voltages from 1.8-5.5V. It provides 26 GPIO pins, three of
which can function as analogue inputs, on 0.1”-pitch through-hole pads with
castellated edges. Raspberry Pi Pico is available as an individual unit, or in
600-unit reels for automated assembly.
2 Raspberry Pi Pico
Specification
Form factor: 21 mm × 51 mm
Peripherals: • 2 × UART
• 2 × SPI controllers
• 2 × I2C controllers
• 16 × PWM channels
•1
× USB 1.1 controller and PHY, with host and
device support
•8
× PIO state machines
3 Raspberry Pi Pico
Physical specifications
21
17.78
11.4
8
1.3 (typ)
2
2.54
1.6
48.26 51
1
2.1
5.7
2.4 1.6
4.8
1.61
3.8
WARNINGS
• Any external power supply used with Raspberry Pi Pico shall comply with relevant regulations and
standards applicable in the country of intended use.
• This product should be operated in a well-ventilated environment, and if used inside a case, the case
should not be covered.
• Whilst in use, this product should be placed on a stable, flat, non-conductive surface, and should not be
contacted by conductive items.
• The connection of incompatible devices to Raspberry Pi Pico may affect compliance, result in damage
to the unit, and invalidate the warranty.
• All accessories used with this product should comply with relevant standards for the country of use
and be marked accordingly to ensure that safety and performance requirements are met.
• The cables and connectors of all peripherals used with this product must have adequate insulation so
that relevant safety requirements are met.
SAFETY INSTRUCTIONS
To avoid malfunction or damage to this product, please observe the following:
• Do not expose to water or moisture, or place on a conductive surface whilst in operation.
• Do not expose to heat from any source; Raspberry Pi Pico is designed for reliable operation at normal
ambient temperatures.
• Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board
and connectors.
• Whilst it is powered, avoid handling the printed circuit board, or only handle it by the corners to minimise
the risk of electrostatic discharge damage.
4 Raspberry Pi Pico
5 Raspberry Pi Pico
Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi Foundation
www.raspberrypi.org