This panel describes various switches and functions on the radio monitor. The monitor switch can be used to temporarily open the squelch and listen to the operating frequency, or set the squelch threshold level by rotating the tuning dial while holding the switch. The function switch enables secondary functions of other switches when held. The band switch is used to select the operating band and can transfer the displayed frequency to the VFO in memory mode.
This panel describes various switches and functions on the radio monitor. The monitor switch can be used to temporarily open the squelch and listen to the operating frequency, or set the squelch threshold level by rotating the tuning dial while holding the switch. The function switch enables secondary functions of other switches when held. The band switch is used to select the operating band and can transfer the displayed frequency to the VFO in memory mode.
This panel describes various switches and functions on the radio monitor. The monitor switch can be used to temporarily open the squelch and listen to the operating frequency, or set the squelch threshold level by rotating the tuning dial while holding the switch. The function switch enables secondary functions of other switches when held. The band switch is used to select the operating band and can transfer the displayed frequency to the VFO in memory mode.
■ Panel description w MONITOR SWITCH [SQL] (pgs. 10, 27)
➥Push and hold to temporarily open the squelch and monitor the operating frequency. (default behaviour) ➥While pushing, rotate the tuning dial to set the squelch !1 threshold level. q ➥Push [FUNC] + [SQL] to toggle the attenuator circuit ON !0 and OFF. Function display e FUNCTION SWITCH [FUNC] (p. 4) While pushing this switch, other switches and tuning dial perform secondary functions. w o • “Push [FUNC] + a switch” means “while pushing the [FUNC] switch, push the switch.” i e r BAND SWITCH [BAND] u ➥Push to select the operating band (VHF, UHF, etc.).(p.6) r •Broadcast band, HF band, 50 MHz band, VHF avionics band, y 144 MHz band, 300 MHz band, 400 MHz band, 800 MHz t band and 1200 MHz band can be selected. •While pushing this switch, rotating [DIAL] also selects the op- erating band. ➥Transfers the displayed frequency to the VFO in mem- SPEAKER ory mode. (p. 6) ➥Push [FUNC] + [BAND] to enter the scan edge set mode in VFO mode. (p. 17) q ANTENNA CONNECTOR (p.1) ➥Push [FUNC] + [BAND] to enter the bank scan set mode Connects the supplied antenna. in memory mode. (p. 16) •An optional AD-92SMA is available for connecting an antenna with a BNC connector. 2