Bpxe Anxbhg

Product Data Sheet
Castrol EDGE Professional V 0W-20

Fluid TITANIUM - Stronger Under Pressure
Description
Today’s engines continually push the boundaries of technology and engineering. They are smaller and ultra-efficient,
without sacrificing performance. Advanced engines challenge the oil with increased pressures. These intense
pressures cause friction, which can waste up to 10% of an engine’s performance.
Castrol EDGE Professional is micro-filtered and certified CO2 Neutral according to the highest global standard*. Its
patented Fluid TITANIUM transforms to be stronger under pressure and reduces friction for maximum engine
performance when you need it most.
Castrol EDGE Professional with Fluid TITANIUM: unlock the true performance of your engine.
* in accordance with the BSI PAS 2060 specification
Application
Castrol EDGE Professional V 0W-20 is an advanced full synthetic engine oil suitable for use in automotive petrol and
diesel engines where the manufacturer recommends an ACEA C5 0W-20 lubricant.
Castrol EDGE Professional V 0W-20 is approved for use in vehicles that require a Volvo VCC RBS0-2AE specification
0W-20 lubricant.
Please refer to your owner’s handbook.
Advantages
Castrol EDGE Professional V 0W-20 with Fluid TITANIUM is the natural choice for drivers who demand maximum engine
performance from today’s sophisticated vehicles requiring a high level of protection and higher performance oils.
Castrol EDGE Professional V 0W-20:
Transforms to be strongest when the pressure is highest, protecting your engine

Reduces power-robbing friction across all engine speeds and conditions
Independently tested at the highest standards for proven performance
Recommended by world-leading car manufacturers
Protects the engine for the entire drain interval even under extreme pressure
Delivers high levels of fuel efficiency and low temperature performance
Page: 1/2
Typical Characteristics
Name Method Units EDGE Professional V 0W-20
Density @ 15C, Relative ASTM D4052 g/ml 0.844
Viscosity, Kinematic 100C ASTM D445 mm²/s 8.8
Viscosity, Kinematic 40C ASTM D445 mm²/s 47
Viscosity Index ASTM D2270 None 172
Pour Point ASTM D97 °C -48
Flash Point, PMCC ASTM D93 °C 207
Ash, Sulphated ASTM D874 % wt 0.8
Viscosity, CCS -35C (0W) ASTM D5293 mPa.s (cP) 6000
Product Performance Claims

ACEA C5
Volvo VCC RBS0-2AE
Storage
All packages should be stored under cover. Where outside storage is unavoidable drums should be laid horizontally to
avoid the possible ingress of water and damage to drum markings. Products should not be stored above 60°C, exposed
to hot sun or freezing conditions.
Castrol EDGE Professional V 0W-20

14 Nov 2018
Castrol, the Castrol logo and related marks are trademarks of Castrol Limited, used under licence.
This data sheet and the information it contains is believed to be accurate as of the date of printing. However, to the extent that it is permissible by law to exclude
warranties and representations, no warranty or representation, express or implied, is made as to its accuracy or completeness. Data provided is based on
standard tests under laboratory conditions and is given as a guide only. Users are advised to ensure that they refer to the latest version of this data sheet. It is the
responsibility of the user to evaluate and use products safely, to assess suitability for the intended application and to comply with all applicable laws and
regulations. Material Safety Data Sheets are available for all our products and should be consulted for appropriate information regarding storage, safe handling,
and disposal of the product. Refer to the MSDS, available from our website for further information. No responsibility is taken by either Castrol Australia , BP plc or
its subsidiaries for any damage or injury resulting from abnormal use of the material, from any failure to adhere to recommendations, or from hazards inherent in
the nature of the material. All products, services and information supplied are provided under our standard conditions of sale. You should consult our local
representative if you require any further information.
Castrol Australia Pty Limited - ABN 87 008 459 407 – 132 McCredie Road, Guildford NSW 2161, Australia
Technical Advice Line 1300 557 998 Customer Service 1300 554 890
www.castrol.com.au www.msds.castrol.com.au
Page: 2/2

Bpxe Anxbhg

Uploaded by

Copyright:

Available Formats

Bpxe Anxbhg

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Bpxe Anxbhg

Uploaded by

Copyright:

Available Formats

Product Data Sheet

Castrol EDGE Professional V 0W-20

* in accordance with the BSI PAS 2060 specification

Please refer to your owner’s handbook.

Castrol EDGE Professional V 0W-20:

Transforms to be strongest when the pressure is highest, protecting your engine

Density @ 15C, Relative ASTM D4052 g/ml 0.844

Viscosity, Kinematic 100C ASTM D445 mm²/s 8.8

Viscosity, Kinematic 40C ASTM D445 mm²/s 47

Viscosity Index ASTM D2270 None 172

Pour Point ASTM D97 °C -48

Flash Point, PMCC ASTM D93 °C 207

Ash, Sulphated ASTM D874 % wt 0.8

Viscosity, CCS -35C (0W) ASTM D5293 mPa.s (cP) 6000

Product Performance Claims

Castrol EDGE Professional V 0W-20

You might also like