Is 8422-3 - 1977 - 1
Is 8422-3 - 1977 - 1
UDC 621.43-242.
3
IS : 8422 ( Part 111)- 1977
t First Reorint AUGUST 1986 1 I\ -.rr.“-~
ma..Qx-_. .aM,
aa‘
I
( Reaffirmed 2000 )
hldian Standard
Is1
1I SPECIFICATION
PART III KEYSTONE
FOR PISTON RINGS FOR IC ENGINES
RINGS FROM 82 UP TO 200 mm
NOMINAL DIAMETER
T-RINGS 15”
1. Scope -Specifies the dimensions, tolerances, tangential loads and other details of T-rings
(keystone rings 15”) from 82 up to 200 mm nominal diameter for internal combustion engines.
2. Dimensions and Tolerances-Shall be as given in Table 1 read with Fig. 1.
DETAIL A
SHOWING CHAMFERING OF
INTERNAL EDGES (KI)
All dimensions in millimetres.
FIG. 1 DIMENSIONS FOR T-RINGS 15’
3. Designation -Shall include:
a) Type of ring,
b) Nominal diameter do,
c) Axial width hr,
d) Number of this standard,
e) Material symbol,
f) Manufacturing process,
g) Whether inside edges chamfered ( KI ), and
h) Type of coating.
Example:
A keystone ring 15” (T-ring ) of a nominal diameter dt - 90 mm, axial width h, = 2’5 mm,
made of S. G. iron (A6), with inside chamfered edges (KI) and coated with tin all over
(SN ) shall be designated as:
T-Ring QO x 2’5 IS : 8422 (Part III ) A6 KI SN
4. General Requirements- Shall be as given in IS : 5791-1977 ’ Technical supply conditions for
piston rings for IC engines (first revision ) ‘.
5. Marking - The rings which are to be fitted in a particular direction shall be marked with the word
’ TOP ’ on the top sides of the rings. For other markings reference should be made to IS : 5791-1977.
5.1 ISI Cerfification Marking - Details available with the Indian Standards Institution.
Adopted 4 May 1977 @ October 1977, ISI Gr 2
I I
INDIAN STANDARDS INSTITUTION
MANAK BHAVAN, 9 BAHADUR SHAH ZAFAR MARG
NEW DELHI 110002
