UL 873 12th Ed 16 Nov 2007 ED 8 31 2019

STANDARDS UPDATE NOTICE (SUN)
ISSUED: September 5, 2018
STANDARD INFORMATION
This SUN establishes the continuing certification and withdrawal of UL 60730-2-13A 1st Edition / UL 873 12th
Edition and introduces UL 60730-2-13 as the superseding standard.
Superseded Standard Number: UL 60730-2-13A & UL 873
Superseded Standard Name: Automatic Electrical Controls for Household and Similar Use; Part 2: Particular
Requirements for Humidity Sensing Controls, 1st Edition Dated February 5, 2002 & Temperature-Indicating and
-Regulating Equipment, 12th Edition Dated November 16, 2007
Superseding Standard Number: UL 60730-2-13
Superseding Standard Name: Automatic Electrical Controls for Household and Similar Use; Part 2: Particular
Requirements for Humidity Sensing Controls, 2nd Edition, Dated July 1, 2014
EFFECTIVE DATE OF NEW/REVISED REQUIREMENTS

Effective Date: No action is required for currently certified products to maintain certification.
This SUN is being presented to assist users of the standard to appreciate the significance of
the changes made to the standard that will apply should the product described be modified
after August 31, 2019.
IMPACT, OVERVIEW, AND ACTION REQUIRED

Impact Statement: A review of all Listing Reports is necessary to determine which products comply with
new/revised requirements and which products will require re-evaluation. NOTE: Effective immediately, this
revised standard will be exclusively used for evaluation of new products unless the Applicant requests in
writing that current requirements be used along with their understanding that their listings will be withdrawn
on Effective Date noted above, unless the product is found to comply with new/revised requirements.
Overview of Changes: UL 60730-2-13A 1st Edition / UL 873 12th Edition are being withdrawn by UL and
replaced by UL 60730-2-13, which is an adoption of the second edition of IEC 60730-2-13.
If the applicable requirements noted in the table are not described in your report(s), these requirements will
need to be confirmed as met and added to your report(s) such as markings, instructions, test results, etc. (as
required).
Client Action Required:
Information – To assist our Engineer with review of your Listing Reports, please submit technical information in
response to the new/revised paragraphs noted in the attached or explain why these new/revised requirements
do not apply to your product (s).
Current Listings Not Active? – Please immediately identify any current Listing Reports or products that are no
longer active and should be removed from our records. We will do this at no charge as long as Intertek is
notified in writing prior to the review of your reports.
SFT-ETL-OP-29c (December 15, 2017) Standards Update Notice KR/KM Page 1 of 4

STANDARD INFORMATION
CLAUSE VERDICT COMMENT

Additions to existing requirements are underlined and deletions are shown lined
out below.
17 Info Endurance
17.8 Info Test of automatic action at accelerated rate
New clause added;
Modification of 17.8.4.101 of the Part 2 by adding the following sentence to

the note:
17.8.4.101 DV
D2 In the USA, the values in clause AA.2 of Annex AA apply for the testing of
INDEPENDENTLY MOUNTED, FREE STANDING and cord-connected humidity
SENSING CONTROLS in Clause 17. Unless otherwise specified in the
appropriate equipment standard, the values in clause AA.2 also apply for
INTEGRATED and INCORPORATED CONTROLS.
Renamed:
23 INFO From: Radio interference suppression
To: Electromagnetic compatibility (EMC) requirements – emission
Renamed:
From: OPERATION with mains borne perturbations, magnetic, and
26 INFO
electromagnetic disturbances
To: Electromagnetic compatibility (EMC) requirements – immunity
Annex C Deleted
Annex D Deleted
Annex H Info Requirements for electronic controls
H.11 Info Constructional requirements
H.11.12 Controls using software
H.11.12.8 Replace the explanatory paragraph by the following:
Info
The values declared in Table 7.2, requirement 71, may be given in the
applicable appliance standard.
H.11.12.8.1 H.11.12.8.1 Add, at the end of this subclause, the following explanatory
paragraph:
Info
The values declared in Table 7.2, requirement 72, may be given in the
applicable appliance standard.
Page 2 of 4
For integrated and incorporated electronic controls, the tests of this clause
may be carried out under declared conditions if so requested by the
manufacturer.
Integrated and incorporated electronic humidity sensing controls are not

H23.1.2 Info
subjected to the tests of this subclause, as the results of these tests are
influenced by the incorporation of the humidity sensing control into the
equipment and the use of measures to control emissions used therein. They
may, however, be carried out under declared conditions if so requested by the
manufacturer.
H.26 Info Electromagnetic compatibility (EMC) requirements – immunity
After each test, one or more of the following criteria shall apply, as permitted
H.26.2
in Table H.26.101.
The humidity sensing control is subjected to each of the specified voltage test
cycles three times with 10 s intervals between each test cycle. For a humidity
H.26.5.4.3 sensing control declared under requirement 101 of Table 7.2, each test cycle is
performed three times when the control is in the declared condition and three
times when it is not.
For controls declared under requirement 101 of Table 7.2, three of the tests
are performed when the control is in the declared condition and two are
performed when it is not.
H.26.8.3.101DV D2 Modification of H.26.8.3.101 of the Part 2 by adding the

H.26.8.3.101
following clause:
H.26.8.3.101DV.1 For controls declared under item 101 of Table 7.2, the tests
are performed when the control is in the declared condition and when it is
not.
D2 Modification of H.26.9.3.101 of the Part 2 by adding the following
clause:
H.26.9.3.101DV
H.26.9.3.101DV.1 For controls declared under item 101 of Table 7.2, the tests
are performed when the control is in the declared condition and when it is
not.
D2 Modification of H.26.10.5.101 of the Part 2 by adding the following
clause:
H.26.10.5.101DV
H.26.10.5.101DV.1 For controls declared under item 101 of Table 7.2, the
tests are performed when the control is in the declared condition and when it
is not.
H.26.12 Radio-frequency electromagnetic field immunity
H.26.12.2 Immunity to conducted disturbances
Page 3 of 4
Test procedure
Addition:
H.26.12.2.2
For controls declared under requirement 101 of Table 7.2, sweeping is
performed when the control is in the declared position and when it is not.
Radiated electromagnetic fields immunity evaluation
Additional subclause:
H.26.12.3
H.26.12.3.101 For controls declared under requirement 101 of Table 7.2,
sweeping is performed when the control is in the declared condition and when
it is not.
H.26.12.4 Power frequency magnetic field immunity test
Test procedure
Addition:
H.26.12.4.3
For controls declared under requirement 101 of Table 7.2, the test shall be
performed when the control is in the declared condition and when it is not.
H.26.12.5 Evaluation of compliance
Addition:
H.26.12.5.2
See Table H.26.2.101 for compliance criteria.
Addition:
H.26.12.5.4
See Table H.26.2.101 for compliance criteria.
Annex AA Number of cycles
Minimum number of cycles for independently mounted and in-line cord
AA.2 Info
controls (applicable in Canada and the USA)
D2 Modification of this table by adding the following Note:
AA.2DV Note: In the U.S.A., these minimum number of cycles also apply for
INDEPENDENTLY MOUNTED, IN-LINE CORD, FREE-STANDING CONTROL,
INTEGRATED, and INCORPORATED HUMIDITYSENSING CONTROLS.
Manufacturing and Production Tests
Annex 13.DVE
This annex of Part 1 is applicable.
CUSTOMERS PLEASE NOTE: This Table and column “Verdict” can be used in
determining how your current or future production is or will be in compliance
with new/revised requirements.
Page 4 of 4

UL 873 12th Ed 16 Nov 2007 ED 8 31 2019

Uploaded by

Copyright:

Available Formats

UL 873 12th Ed 16 Nov 2007 ED 8 31 2019

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

UL 873 12th Ed 16 Nov 2007 ED 8 31 2019

Uploaded by

Copyright:

Available Formats

STANDARDS UPDATE NOTICE (SUN)

ISSUED: September 5, 2018

EFFECTIVE DATE OF NEW/REVISED REQUIREMENTS

IMPACT, OVERVIEW, AND ACTION REQUIRED

SFT-ETL-OP-29c (December 15, 2017) Standards Update Notice KR/KM Page 1 of 4

CLAUSE VERDICT COMMENT

Modification of 17.8.4.101 of the Part 2 by adding the following sentence to

Integrated and incorporated electronic humidity sensing controls are not

H.26.8.3.101DV D2 Modification of H.26.8.3.101 of the Part 2 by adding the

You might also like