Operator's Manual Supplement: Access Control Module
Operator's Manual Supplement: Access Control Module
Operator's Manual Supplement: Access Control Module
ANSI/CSA
North America
South America
Asia
CE
Original Instructions
First Edition
Second Printing
Part No. 1277289GT
Operator's Manual Supplement First Edition • Second Printing
Introduction
Introduction
Manufacturer:
Important
Terex Global GmbH
Read, understand and obey these safety rules and Bleicheplatz 2
operating instructions before operating this Schaffhausen, 8200
machine. Only trained and authorized personnel Switzerland
shall be permitted to operate this machine. This
manual should be considered a permanent part of EU Authorized representative:
your machine and should remain with the machine Genie Industries B.V.
at all times. If you have any questions, contact us. Boekerman 5
4751 XK OUD GASTEL
Contact Us: The Netherlands
Internet: www.genielift.com UK Authorized representative:
E-mail: awp.techpub@terex.com Genie UK Limited
The Maltings
Wharf Road
Grantham
NG31 6BH
UK
Complies with:
ANSI A92
CSA B354
AS 1418.10
Introduction
Background
Access control modules are designed to restrict
access and functionality to unauthorized
operators. This is controlled by a keypad and/or
RFID-card reader. The restriction defers
depending of the type/model of the MEWP. When
authorized, the module will allow the operator to
Danger use all functionality of the machine until it is
deactivated form the key switch or E-stop on the
Failure to obey the instructions and lower controls.
safety rules in this manual and in Location
the operator's manual for this The ACM will be mounted, where possible, near
machine will result in death or the lower control panel with immediate visibility
and easy to reach. No plates or covers should be
serious injury. removed to access the ACM.
Mounting Locations on various models:
Note: These installation instructions apply to the
Genie models listed below: Telescopic and Articulating booms
All MEWP Models The ACM is located at the main polyester swing
chassis cover on the ground control box side:
ACM Safety
Read, understand and obey all warnings and
instructions provided with the ACM.
When the ACM is installed, this manual should be
considered a permanent part of the machine and
should remain with the machine at all times.
Symbol and Hazard Pictorials
Definitions
Read the supplement,
part number 1277289
1277289
Introduction
Introduction
Functionality IC machines
The ACM will disable some functionality of the The ACM can disable the engine start. When
machine when access is restricted. Depending on access denied, engine start will not function.
the type/model of the MEWP and the access mode
of the module these will be different. Do not use access keys: Engine start is always
enabled.
Auxiliary power will always be available
Use Access Keys: Engine start enabled after
Access control mode valid Code or RFID card.
The owner of the machine/ACM can set the Locked For everyone: Engine start is always
4 access control modes through a designated disabled.
website. Access to this website is solely restricted
Unlocked for everyone: Engine start is always
to the owner, which grants full responsibility to
enabled.
control and change this mode.
DC: Z30, Z34, Z45
The ACM can disable drive forward and reverse.
Do not use access keys: Drive function is always
enabled.
Use Access Keys: Drive functions enabled after
valid Code or RFID card.
Locked For everyone: Drive function is always
disabled.
Unlocked for everyone: Drive function is always
Do not use access keys enabled.
The module will behave as if there are no keys
assigned to it, even when there are keys assigned
for that module. The machine is always enabled.
Use access keys
The machine will be enabled after a valid code or
RFID card.
Locked for everyone
The machine is always disabled.
Unlocked for everyone
The machine is always enabled.
Operating Instructions
Operating Instructions
Red id cancel