Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 5 views

    Important!

    Uploaded by

    geronimojuarez179

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Important!

    Uploaded by

    geronimojuarez179
    5 views1 page

    Original Title

    012

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    5 views1 page

    Important!

    Uploaded by

    geronimojuarez179

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    Engine no.

    : 6642331

    Lubricate the entire camshaft and the


    bearing seats with engine oil before fitting
    the camshaft in the cylinder block.
    Fit the camshaft. Take care not to damage the cams and bearings.
    2. Lubricate the valve tappets with engine oil
    and fit them in the same places as before
    they were removed. Remember to
    lubricate the shells before fitting the
    pushrods. Tighten the screws.

    800f1c2e

    3. Fit the camshaft apertures. Tighten the screws.


    4. Fit the guide flange bolts.
    Now the camshaft axial clearance can be checked:

    z Fit the camshaft gear temporarily.


    z Measure the camshaft axial clearance using a dial gauge. The axial clearance should be
    between 0.05 - 0.35 mm.
    z If the clearance is outside the permitted range, renew the thrust washer.
    z Remove the camshaft gear.

    5. Remove all old sealing compound on the cylinder block and the sealing surface on the
    timing gear plate. Clean off any oil and grease from the sealing surfaces using an alcohol
    based cleaning agent.

    Important!

    Clean thoroughly, as the sealing surfaces


    must be completely free of grease.

    6. Apply sealant to the timing gear plate


    using nozzle 584 118. The sealant should
    be placed outside the milled grooves as
    illustrated. The diameter of the bead
    should be approximately 4 mm.

    2011-08-23 ?Scania CV 5 of 10

    You might also like