Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 7 views

    Ami 1

    Uploaded by

    shettymahi29
    AMI question paper

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Ami 1

    Uploaded by

    shettymahi29
    7 views3 pages
    AMI question paper

    Original Title

    AMI 1

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    AMI question paper

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    7 views3 pages

    Ami 1

    Uploaded by

    shettymahi29
    AMI question paper

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 3

    22391

    12223
    3 Hours / 70 Marks Seat No.

    Instructions – (1) All Questions are Compulsory.


    (2) Illustrate your answer with neat sketches wherever
    necessary.
    (3) Figures to the right indicate full marks.
    (4) Assume suitable data, if necessary.
    (5) Mobile Phone, Pager and any other Electronic
    Communication devices are not permissible in
    Examination Hall.

    Marks

    1. Attempt any FIVE of the following: 10


    a) Define following terms:
    i) Gain
    ii) Bandwidth
    b) Define following Op-Amp parameter :–
    i) Slew rate
    ii) CMRR
    c) State Barkhausen criteria of oscillation.
    d) Write the output voltage for following fixed regulator IC:
    i) 7805
    ii) 7912
    e) Define transducer. Give any two example of transducer.
    f) Compare amplifier and oscillator on the basis of :–
    i) Type of feedback used
    ii) Applications
    g) Define line regulation and load regulation.
    P.T.O.
    22391 [2]
    Marks
    2. Attempt any FOUR of the following: 12
    a) Explain working of single stage CE amplifier with neat circuit
    diagram.
    b) Compare open loop and closed loop configuration of Op-Amp
    (any four points).
    c) Explain the working of IC-555 as voltage controlled oscillator
    (VCO).
    d) Draw and explain working principle of LVDT.
    e) Explain principle of operation of Thermocouple.

    3. Attempt any FOUR of the following: 12


    a) Describe the basic integrator circuit by using Op-Amp.
    b) Compare Positive feedback and Negative feedback on the basis
    of :–
    i) Gain
    ii) Bandwidth
    iii) Stability.
    c) State and explain selection criteria of transducer.
    d) Explain the operation of single tuned amplifier with neat circuit
    diagram.
    e) Explain classification of amplifiers.

    4. Attempt any THREE of the following: 12


    a) Calculate output voltage (Vo) for inverting amplifier if
    R1 = 2KW, Rf = 120KW, Vcc = ±15V and Vin = 50 mv.
    b) Compare RC coupled, transformer coupled and direct coupled
    amplifier on the basis of :–
    i) Type of coupling
    ii) Gain
    iii) Frequency Response
    iv) Applications.
    22391 [3]
    Marks
    c) Draw and explain wein bridge oscillator by using Op-Amp
    IC-741.
    d) Draw pin diagram of IC-555 and explain function of each pin.
    e) Draw block diagram of Instrumentation system, describe function
    of each block.

    5. Attempt any THREE of the following: 12


    a) Explain Schmitt trigger circuit using Op-Amp.
    b) Draw neat circuit diagram of RC phase shift oscillator.
    Also calculate the frequency of sine wave generated by oscillator.
    If R = 8KW and C = 0.01 mf.
    c) Explain astable multivibrator by using IC-555 with circuit
    diagram and waveform.
    d) Draw and explain the working of Zero crossing detector using
    Op-Amp.
    e) Draw crystal oscillator circuit diagram. State advantages of
    crystal oscillator.

    6. Attempt any TWO of the following: 12


    a) Explain construction and working of sample and hold circuit
    using Op-Amp and state any two application of it.
    b) Draw neat circuit diagram of miller sweep generator and explain
    it with waveform.
    c) Draw the block diagram of Phase Lock Loop (PLL) and describe
    the function of each block.

    You might also like