Instructor: Dr. Imtiaz Hussain Complex Engineering Problem (10 Marks) CLO-1 and CLO-2
Consider that you have been given two sets of DC lamps which you need to connect in order to ensure lighting in a hall using the only available DC source of 𝑉𝑠 = 30𝑉. Every lamp in the first set (S1) has the ratings of 5 𝑉 and 1 𝑊 while the ratings of every lamp in the second set (S2) are 30 𝑉 and 10 𝑊. As evident from the ratings, the first set of lamps offers you a lot of savings in your electricity bill but are not very reliable while the second set of lamps do not offer that much savings but are extremely reliable. Now, you as an engineering student of semester 1 have been tasked to come up with a design that can offer both savings in electricity bill and ensures reliability as well. The following design requirements and constraints have been provided to you which you must consider in your design to be accepted. 1) There are 03 locations in the hall where lamps (quantity as per requirement) need to be installed and the following are the power requirements for each location: a) Minimum total wattage per location of 6 𝑊 is required as the primary setup. b) There must be a backup per location to ensure that minimum wattage requirement is met. The backup arrangement may have more than minimum wattage but only if the primary setup fails. 2) The only available set of lamps are S1 and S2 with ratings already shared above. 3) An automatic mechanism is required in the backup setup per location to automatically power the location in case of a failure in the primary setup. Choose a relevant device that can be used to activate backup setup only when there is a failure in primary setup.
Report Requirements
S. No. Requirements Submission Deadline
1 Show the detailed circuit diagram of the entire lighting system for the hall with three locations.
Detailed explanation of your proposed design commenting on your choice of components and the configuration in which you have 2 connected them.
Solve the circuit with primary setup only and identify the currents and voltages across each lamp. Show all your calculations using 18th Feb 2022 3 any of the analysis techniques studied in the course.
Solve the circuit with backup setup only and identify the currents and voltages across each lamp. Show all your calculations using 4 any of the analysis techniques studied in the course. PAKISTAN NAVY ENGINEERING COLLEGE – NUST SUBJECT: Linear Circuit Analysis (EE-111) Instructor: Dr. Imtiaz Hussain Complex Engineering Problem (10 Marks) CLO-1 and CLO-2
Mapped BT (Domain and
CLO No Description PLO Level) Illustrate the concepts of network laws and theorems used to formulate and solve circuit equations of DC resistive linear 1 1 C2 electrical circuits. 2 Apply the acquired knowledge to evaluate resistive and storage elements circuits. 1 C3
CEP Characteristics Mapping Justification
• Knowledge of fundamentals of linear circuit analysis to understand A. Cannot be resolved without in-depth engineering knowledge PLO-1 the problem statement and propose valid solution.
• Modeling of the detailed circuit using the analysis techniques
discussed in the course. B. Involve wide-ranging or conflicting technical, engineering and other issues. PLO-2 • Application of relevant circuit analysis techniques to solve for the required circuit parameters. • Selection of the relay circuit with its relevant energizing circuit
C. Have no obvious solution and require abstract thinking and originality in
analysis to formulate suitable models. ×
D. Involve infrequently encountered issues. ×
E. Outside problems encompassed by standards and codes of practice for professional engineering. × F. Involve diverse groups of stakeholders with widely varying needs. ×
G. High level problems including many component parts or sub-problems. ×
