(NMease wite you o ollenent Nunbe) tnrollment No.

End-Term Examinatlon- ONLINE MODE

(CBCS) (sUBJECTIVE TYPE)
D.Tech. (ECE), 9" Semester
(December,2021)
Subject Code: MC 203 Subject: Slgnal &Systems
Tlne : 1Hour 15 nmlnutes
Maxlmum Marks : 30
Note: Q, 1is compulsory. Attenpt any one questlon from the rest.
Q.1
(5*3=15)
(a) Forthe following systems, determlne whether or not the
(1) Stable system ls
(2) Causal
(3)Llnear
(4) Memory less

T\x(n)] X(n - no)

(0) T|x(n)] 3e(1)

(b)Conslder a sequence x(n)

x(n) 4-n 0Sns 4

0
otherwise
Find its discrete time Fourler
Transform X(e/W)
(c) Draw and explain the
phenomenon for different convergence
of
values of 'N'. Fourler Serles of square wave by llustrating the Gibbs

Q.2
(a) Find out the convolution of the (7.5+7.5= 15)
following two signals by using Graphlcal Method:
x(n)= (1,2,3, 1) h(n) = (1,2,2, -1)
(b) Determine the
z-transform and the ROC of the following slgnals:
(1) x(n) =n a" u(n)
(2) x(n) = (-1)"+1 u(n - 1)

Q.3
(a) What are
Dirlchler's conditlons? Dlscuss speclal cases of (7.5+7.5= 15)
Dirichlet's conditlons. Explain such cases with graphical functlons which vlolet different
(b) Explaln the
spectrum of sampled signals
represerntatlon of these functlons.
Involved. Also, explaln the procedure for glven In figure below and the
Itssamples by using excat reconstruction of the technlques
Interpolation. orlginal signal rom
 ANAAA
0

Declaration of the Paper Setter(s)

Thave followed these instructions provided by the examination division for end-term examination,
December 2021 for paper setting with best of my knowledge
a. No direct questions such as definitions, comparisons, diagrams etc has been given where the
student can use the book/ online resources directly to answer the question and
b. Ensured that each and every question is verified and

c. Ensured that the paper covers entire syllabus as intimated to the students, all the
un- ambiguous, discussed with other teachers who are teaching the same questions are
subject in the
department and other departments related to the coverage of the syllabus, difficulty level etc. and
followed university noms for setting up the question paper.
Name of the Paper Setter: Dr. RichaYadav
Email ld: richayadav@igdtuw.ac.in
Mobile No: 9711518602
Declaration of the departmental Moderation Committee
The above paper is moderated and followed above
Name of the HoD: Prof. Nidhi Goel
guidelines
Name of the faculty teaching the same subject: NA
Name of the other faculty: NA
(Please write your Enrollment Number) Enrollment No.

End-TermExamination
(CBCS)(SUBJECTIVE TYPE) (OffLine)
Course Name:<B.TECH AI&ML>, Semester:<3rd>
(November-December, 2023)
Subject Code : BAM 201 Subject: Database Management Systems
Time :3 Hours Maximum Marks :60
Note:Q. 1is compulsory. Attempt one question each from the Units I, I, III &IV.
Q1 (4*5-20)
(a)"Weak entities always observe total participation in a relationship." Comment on
the statement with a suitable example.
(b)What is the difference between Natural Join and Total Outer Join? Explain with an
example.
(c)What do you mean by dependency preserving decomposition and lossless join
property? Explain with relevant examples.
(d)What are thedifferent integrity constraints in a database model? Give examples.
UNIT-I
Q2 Draw the system architecture of Database Management System. (10)
Explain each component in detail.
Construct an ER diagram to model an online book store which (10)
maintainsdata of different books, customers, suppliers and publishers.
Clearly indicate the entities, attributes, relationships & key constraints.
UNIT-I|
Q4 Consider the following relations (10)
Employee(empname, street, city)
Works (empname, companyname, salary)
Company (companyname, city)
Manages (empname, manager)
Write the following queries using SQL.
i) Find the names of allemployees who live in the same city
as the company for which they work.
ii Find the names of all employees who do not work for
Central Bank.
iii) Find the names of all employees who earn more than every
employee of State Bank.
Q5 Explain various rules to map agiven ER diagram to a relational database
schema. Explain with the help of a suitable example. (10)
UNIT-II|
Q6 Decompose the following relation into 3NF
R= (A, B, C, D, E)with aset of functional (10)
F= (A>BC, CD-’E, B->D, E>A)
dependencies F as follows:
Q7
Consider the relation R= (A, B, C, D, E, F, G, I,J} and the
functional dependencies F={{AB->C), (A->DE), H,(B->F}, set of (10)
What is the candidate key of R? (F->GH}, (D->U}}.
Decompose Rinto 2NF &3NF relations.
Q8 UNIT-IV
List down the various
concerns that arise whenproperties
of transactions and what
are the (10)
Q9 transactions
Explain the concept of concurrency run simultaneously in
DBMS.
control using locking mechanisms. (10)
(Please write your Enrollment Number) Enrollment No.
End-Term Examination- ONLINE MODE
CBCs(SUBJECTIVE TYPE)
B.TECH, ECE Illrd SEM
(DEC, 2021)
(SET A)
Subject Code: BEC 205 |Subject: Network Analysis and Synthesis
Time:1 Hour 15 minutes Maximum Marks:30
Note: Q. 1 is compulsory. Attempt any one question from the rest.

Q1
(5*3=15)
(a) What is the objective of using network theorems? What is the advantage of using laplace
transform in analysis of electric networks?
(b) Define network function. Is transfer function also a network function? If TF = Z(s), identify input
and output function corresponding to above T.F.
(c) For the network shown below, write down the f-cut set matrix and obtain the network
equilibrium equation in matrix from using KCL.

Q2
(a) State and explain Thevenin's theorem. For the (7.5+7.5= 15)
network shown below, sketch Thevenin's
eguivalent at b-b' and obtain current in load resistance R = 2 ohms

(b) A tWo terminal network

consists of a coil having an inductance L, and
bya capacitor C. The poles and
zeros of a driving point impedance resistance R shunted
are given by function of this network
pi and p2=(-0.5)tj(V3/2), zero zË = -1
If Z(s)|s= jo = -1, determine R, Land
C.

Q3
(a) How is aphysicalInetwork | (7.5+7.5= 15)
realized by consideringthe driving point admittance function.
Discuss.
O] DIscuss transient and steady state response in case of an R-L series circuit energized by ad.c.
otdge sSource, t volts. A 12Vdc source is disconnected in the figure shown below at t = 0. Show
the wave shape of inductor current and the voltage across the inductor for all times.
(Please write your Enrollment Number) Enrollment No.

End-Term Examination- ONLINE MODE

CBCs (SUBJECTIVE TYPE)
B.TECH, ECE llrd SEM
(DEC, 2021)
(SET B)
Subject Code: BEC205 Subject: Network Analysis and Synthesis
Time: 1 Hour 15 minutes
Maximum Marks:30
Note: Q. 1 is compulsory. Attempt any one question from the rest.

Q1
(5*3=15)
(a) Differentiate analysis and synthesis and specify their importance with relevant expression.
(b) Aseries RL circuit has R= 10 KOQ, l= 10 mH and C = 1uf. Find the transfer function of the circuit.

(c) Find the value of the constant Kin the circuit shown below such that the
power dissipated in the
2-2 resistor does not exceed 50-W.

6A 22

Q2
(a) A (7.5+7.5= 15)
voltage pulse of width b and magnitude 10V is applied at t = 0 to a series RC circuit
of aresistor R = 10 and a capacitor C= 0.26 F. Find the consisting
current i(t). Assume zero charge across the
capacitor before the application of the voltage pulse.
(b) For the network shown below, draw the oriented graph,
select a
fundamental cut-set matrix. Determine the node equations and fine suitable
tree and obtain the
v.

Q3
(a) Find the first and (7.5+7.5= 15)
function
second Cauer forms of LC networks for the given driving polnt p
Z(s) =(s + 10s² +9)/(s+4s)
 voltage across the terminals A and B.
(b)With the help of superposition theorem, find the

NAS
(Please write your Enrollment Number) Enrollment No.

End-Term Examination (Regular &Reappear)

(CBCS)(SUBJECTIVE TYPE)(OffLine)
Course Name:<B.Tech ECE>, Semester:<3>
(November-December, 2023)
Subject Code: BEC 203 Subject: Signals & Systems
Time :3 Hours Maximum Marks :60
NoterQ. 1is compulsory. Attempt one question each from the Units I, II, II &IV.
Q1
(2.5*8=20)
a Difference between Static and Dynamic.
(b) What do youmean by Superposition principle ?Explain it with example.
(c) Check whether the signals are periodic or aperiodic-:
Sin 30 7t
II. Sinzt u(t)
(d) Explain the property Time shifting with example.
(e) Explain the difference between Linear and Non-Linear phase.
(f Describe the properties of LTI system.
Explain the properties of ROC.
(h What do you mean by Aliasing?

UNIT-I
Q2 State the Differences with example-:
a) Even and Odd signals (10)
b) Continuous time signal and
Q3 discrete time signals
Draw the waveforms of the following
a) X(t)=ut-2)
signals-: (10)
b) Xa(t)=u(t+3)
c) Xs(t)=u(-2t+1)
d) Xalt)=u(-t)
e) Xs(t)=u(t)-2u(t-1) +u(t-3)
UNIT-|
Q4
Describe the properties of periodic signals in detail
Q5 Find the Fourier transform of the
signal g(t) defined by (10)
e(t)=tet ult) (10)
Q6 UNIT-II
Explain the terms-:
a) Group Delay
b) Phase Delay (10)
07
What do you mean by All Pass
system? Explain it with suitable
Q8
Explain the terms-: UNIT-IV diagrams. (10)
a) Sampling
b) Interpolation (10)
Determine theLaplace transform of-:
X(t)= -eu(-t)+eu-t)
(10)