Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
3 views

????LAB3 Arduino 2

Uploaded by

sara28206
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
3 views

????LAB3 Arduino 2

Uploaded by

sara28206
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

LAB Arduino UNO

Manip1 :Traffic light


Start your experiment with one LED. The second manipulation will be figure 1 for the traffic
light.

Fig1 : Traffic light Tri colours

Components for circuit

• Arduino board
• A board
• USB cable
• 3 resistors of 220Ω
• Green LED
• Red LED
• Orange LED

Code Tricolor light


Light the three LEDs as follows: Orange ON for 1 second Red ON for 1 second Green ON for 1 second
Circuits :
- Red LED in pin 2 – Orange LED in pin 3 – Green LED in pin 4

const int Red = 2;


const int Orange = 3;
const int Green = 4;
// The code is executed on time
void setup()
{
// indicate that the LED pins are OUTPUT
pinMode(Red, OUTPUT);
pinMode(Orange, OUTPUT);
pinMode(Green, OUTPUT);
}

1
// The code is executed in loop
void loop()
{
digitalWrite(Orange, HIGH);
delay(1000);
digitalWrite(Orange, LOW);
digitalWrite(Red, HIGH);
delay(1000);
digitalWrite(Red, LOW);
digitalWrite(Green, HIGH);
delay(1000);
digitalWrite(Green, LOW);
}

Manip2 : Crossroads Lights


Programming - Run red/orange/green lights of crossroads

The tricolour lights operate as follows: red light illuminated for 4s, orange light illuminated for 1s and
green light illuminated for 4s. At the start and after an orange light, all lights are red for 1s. The cycle
must repeat indefinitely

Fig2 Crossroads Lights

You might also like