Gprs Attach
Gprs Attach
Gprs Attach
- normal routing area updating to update the registration of the actual routing area of an MS in the network. This procedure is used by GPRS MSs in MS operation mode C and by GPRS MSs in MS operation modes A or B that are IMSI attached for GPRS and non-GPRS services if the network operates in network operation mode II or III; - combined routing area updating to update the registration of the actual routing and location area of an MS in the network. This procedure is used by GPRS MSs in MS operation modes A or B that are IMSI attached for GPRS and non-GPRS services provided that the network operates in network operation mode I; - periodic routing area updating. This procedure is used by GPRS MSs in MS operation mode C and by GPRS MSs in MS operation modes A or B that are IMSI attached for GPRS or for GPRS and non-GPRS services independent of the network operation mode; - IMSI attach for non-GPRS services when the MS is IMSI attached for GPRS services. This procedure is used by
GPRS MSs in MS operation modes A or B, if the network operates in network operation mode I; - in GSM, resuming GPRS services when the RR sublayer indicated a resumption failure after dedicated mode was left, see 3GPP TS 44.018 [84]; - in GSM, updating the network with the new MS Radio Access Capability IE when the content of the IE has changed. Normal or combined routing area updating procedure is used.; - UMTS to GSM and for GSM to UMTS intersystem change, see subclause 4.7.1.7; or - in UMTS, to re-synchronize the PMM mode of MS and network after RRC connection release with cause "Directed signalling connection re-establishment", see subclause 4.7.2.5. Subclause 4.7.5.1 describes the routing area updating procedures for updating the routing area only. The combined routing area updating procedure used to update both the routing and location area is described in subclause 4.7.5.2. The routing area updating procedure is always initiated by the MS. It is only invoked in state GMM-REGISTERED. To limit the number of subsequently rejected routing area update attempts, a routing area updating attempt counter is introduced. The routing area updating attempt counter shall be incremented as specified in subclause 4.7.5.1.5. Depending on the value of the routing area updating attempt counter, specific actions shall be performed. The routing area updating attempt counter shall be reset when: - a GPRS attach procedure is successfully completed; or - a routing area updating procedure is successfully completed; and additionally when the MS is in substate ATTEMPTING-TO-UPDATE: - a new routing area is entered; - expiry of timer T3302; or - at request from registration function. The mobile equipment shall contain a list of "forbidden location areas for roaming", as well as a list of "forbidden location areas for regional provision of service". The handling of these lists is described in subclause 4.4.1. The Mobile Equipment shall contain a list of "equivalent PLMNs". The handling of this list is described in subclause 4.4.1. In, GSM, user data transmission in the MS shall be suspended during the routing area updating procedure; user data reception shall be possible. User data transmission in the network shall be suspended during the routing area updating procedure, if a new P-TMSI is assigned. In UMTS, user data transmission and reception in the MS shall not be suspended during the routing area updating procedure. User data transmission in the network shall not be suspended during the routing area updating procedure. In UMTS, when a ROUTING AREA UPDATE REQUEST is received by the SGSN over a new PS signalling connection while there is an ongoing PS signalling connection (network is already in mode PMM-CONNECTED) for this UE, the network shall progress the routing area update procedure as normal and release the previous PS signalling connection when the routing area update procedure has been accepted by the network.
3GPP TS aa.bbb vX.Y.Z (YYYY-MM) CR page 5 CR page 5
NOTE: The re-establishment of the radio bearers of active PDP contexts is done as described in subclause "Service Request procedure". The network informs the MS about the support of specific features, such as LCS-MOLR, in the Network feature support Information Element. The information is either explicitly given by sending the Network feature support IE or implicitly by not sending it. The handling in the network is described in subclause 9.4.15.11. The MS may use the indication to inform the user about the availability of the appropriate services and it shall not request that services that have not been indicated as not available.
Message type: ATTACH ACCEPT Significance: dual Direction: network to MS Table 9.4.2/3GPP TS 24.008: ATTACH ACCEPT message content
IEI Information Element Type/Reference Presence Format Length Protocol discriminator Protocol discriminator 10.2 M V 1/2 Skip indicator Skip indicator 10.3.1 M V 1/2 Attach accept message identity Message type 10.4 MV1 Attach result Attach result 10.5.5.1 M V 1/2 Force to standby Force to standby 10.5.5.7 M V 1/2 Periodic RA update timer GPRS Timer 10.5.7.3 MV1 Radio priority for SMS Radio priority 10.5.7.2 M V 1/2 Spare half octet Spare half octet 10.5.1.8 M V 1/2 Routing area identification Routing area identification 10.5.5.15 MV6 19 P-TMSI signature P-TMSI signature 10.5.5.8 O TV 4 17 Negotiated READY timer value GPRS Timer 10.5.7.3 O TV 2 18 Allocated P-TMSI Mobile identity 10.5.1.4 O TLV 7 23 MS identity Mobile identity 10.5.1.4 O TLV 7-10 25 GMM cause GMM cause 10.5.5.14 O TV 2 2A T3302 value GPRS Timer 2 10.5.7.4 O TLV 3 8C Cell Notification Cell Notification 10.5.5.21 OT1 4A Equivalent PLMNs PLMN List 10.5.1.13 O TLV 5-17 B- Network feature support Network feature support 10.5.5.23 O TV 1 3GPP TS aa.bbb vX.Y.Z (YYYY-MM) CR page 6
CR page 6
9.4.2.4 MS identity
This IE may be included to assign or unassign a TMSI to an MS in case of a combined GPRS attach.
10.5.5.15 MV6 19 P-TMSI signature P-TMSI signature 10.5.5.8 O TV 4 18 Allocated P-TMSI Mobile identity 10.5.1.4 O TLV 7 23 MS identity Mobile identity 10.5.1.4 O TLV 7-10 26 List of Receive N-PDU Numbers Receive N-PDU Number list 10.5.5.11 O TLV 4 - 19 17 Negotiated READY timer value GPRS Timer 10.5.7.3 O TV 2 25 GMM cause GMM cause 10.5.5.14 O TV 2 2A T3302 value GPRS Timer 2 10.5.7.4 O TLV 3 8C Cell Notification Cell Notification 10.5.5.21 OT1 4A Equivalent PLMNs PLMN List 10.5.1.13 O TLV 5-17 32 PDP context status PDP context status 10.5.7.1 O TLV 4 B- Network feature support Network feature support 10.5.5.23 O TV 1
9.4.15.3 MS identity
This IE may be included to assign or unassign a TMSI to a MS in case of a combined routing area updating procedure.
The Equivalent PLMNs information element is included if the network wants to inform the mobile station of equivalent PLMNs.