Animesh Kashyap PPT On Plastic Road
Animesh Kashyap PPT On Plastic Road
CIVIL ENGINEERING
By
ANIMESH KASHYAP
ENROLL NO. – 17UCE115
SECTION - II
SEMESTER - VII
CONTENT
INTRODUCTION
NEED OF STUDY
PLASTIC ROAD
MATERIAL USED
METHOD OF MIXING
ADVANTAGES
DISADVANTAGES
plastic waste is increasing due to
increase in population, urbanization and
development
Plastics can be divided in to two major
categories: thermoset and
thermoplastics.
The disposal of waste plastic has
become a serious problem globally due
to their non-biodegradability.
Plasticroads mainly use plastic carry
bags, disposable cups and bottles that are
collected from garbage dumps.
1. DRY PROCESS
2. WET PROCESS
DRY PROCESS
Plastics waste like bags, bottles etc are cut into a size
between
2.36 mm to 4.75mm using shredding machine.
The aggregate mix is heated to 1700C. and then it is
transferred to mixing chamber.
Similarly the bitumen is to be heated up to a maximum of
1600C.
At the mixing chamber, the shredded plastics waste is added
over the hot aggregate.
The plastics waste coated
aggregate is mixed with hot
bitumen.
WET PROCESS
Waste plastics by direct mixing with hot
bitumen at 160°C.
Mechanical stirrer is needed.
Since the wet process require a lot of
investment and bigger plants so not
commonly used.
ADVANTAGES:
1) The load withstanding property increases.
2) Better resistance towards rain water and cold weather.
3) No stripping and no potholes.
4) Increase binding and better bonding of the mix.
5) No leaching of plastics.
6)For 1km road, 1 ton of plastic (10 lakh carry bags) is
used and 1 ton of bitumen is saved.