pH modifiers are often used to promote drug solubility/ stability in dosage forms, but predicting the extent and duration of internal pH modification is difficult. Here, a noninvasive technique is developed for the spatial and temporal... more
pH modifiers are often used to promote drug solubility/ stability in dosage forms, but predicting the extent and duration of internal pH modification is difficult. Here, a noninvasive technique is developed for the spatial and temporal mapping of pH in a hydrated pharmaceutical pellet, within a pH range appropriate for microenvironmental pH control by weak acids. Confocal dual excitation imaging (Ex 488/Ex 568) of pellets containing a single, soluble, pH-sensitive fluorophore with cross-validation from a pH microelectrode. The technique was used to investigate the changing pH distribution in hydrating pellets containing two weak acids of differing solubility. The algorithm developed provided pH measurements over the range pH 3.5-5.5 with a typical accuracy of 0.1 pH units and with excellent correlation with pH microelectrode measurements. The method showed how pellets containing 25%w/w tartaric acid exhibited a rapid but transient fall in internal pH, in contrast to a slower more pr...
The microbial activity within activated sludge floc is a key factor in the performance of the activated sludge process. In this study, the microenvironment of activated sludge flocs from two wastewater treatment plants (Mill Creek... more
The microbial activity within activated sludge floc is a key factor in the performance of the activated sludge process. In this study, the microenvironment of activated sludge flocs from two wastewater treatment plants (Mill Creek Wastewater Treatment Plant and Muddy Creek Wastewater Treatment Plant, with aeration tank influent CODs of 60-120 and 15-35 mg/L, respectively) were studied by using microelectrodes. Due to microbial oxygen utilization, the aerobic region in the activated sludge floc was limited to the surface layer (0.1-0.2mm) of the sludge aggregate at the Mill Creek plant. The presence of an anoxic zone inside the sludge floc under aerobic conditions was confirmed in this study. When the dissolved oxygen (DO) in the bulk liquid was higher than 4.0mg/L, the anoxic zone inside the activated sludge floc disappeared, which is helpful for biodegradation. At the Muddy Creek plant, with its lower wastewater pollutant concentrations, the redox potential and DO inside the sludge...
Cyclic voltammetry of the CuCl powder in a cavity microelectrode revealed direct electro-reduction in solid state in 1-butyl-3-methylimidazolium hexafluorophosphate. Potentiostatic electrolysis of the salt powder (attached to a current... more
Cyclic voltammetry of the CuCl powder in a cavity microelectrode revealed direct electro-reduction in solid state in 1-butyl-3-methylimidazolium hexafluorophosphate. Potentiostatic electrolysis of the salt powder (attached to a current collector) in the ionic liquid produced Cu ...
Aerobic biofilms were found to have a complex structure consisting of microbial cell clusters (discrete aggregates of densely packed cells) and interstitial voids. The oxygen distribution was strongly correlated with these strutures. The... more
We are reporting fabrication and characterization of electrochemical sucrose biosensor using ultra-microelectrode (UME) for the detection of heavy metal ions (Hg(II), Ag(I), Pb(II) and Cd(II)). The working UME, with 25 microm diameter,... more
We are reporting fabrication and characterization of electrochemical sucrose biosensor using ultra-microelectrode (UME) for the detection of heavy metal ions (Hg(II), Ag(I), Pb(II) and Cd(II)). The working UME, with 25 microm diameter, was modified with invertase (INV, EC: 3.2.1.26) and glucose oxidase (GOD, EC: 1.1.3.4) entrapped in agarose-guar gum. The hydrophilic character of the agarose-guar gum composite matrix was checked by water contact angle measurement. The atomic force microscopy (AFM) images of the membranes showed proper confinement of both the enzymes during co-immobilization. The dynamic range for sucrose biosensor was achieved in the range of 1 x 10(-10) to 1 x 10(-7)M with lower detection limit 1 x 10(-10)M at pH 5.5 with 9 cycles of reuse. The spectrophotometric and electrochemical studies showed linear relationship between concentration of heavy metal ions and degree of inhibition of invertase. The toxicity sequence for invertase using both methods was observed as Hg(2+)>Pb(2+)>Ag(+)>Cd(2+). The dynamic linear range for mercury using electrochemical biosensor was observed in the range of 5 x 10(-10) to 12.5 x 10(-10)M for sucrose. The lower detection limit for the fabricated biosensor was found to be 5 x 10(-10)M. The reliability of the electrochemical biosensor was conformed by testing the spike samples and the results were comparable with the conventional photometric DNSA method.
The combined use of a dual-UV detector, a fluorimetric one and of a multiple electrochemical (EC) detector equipped with a dual electrode, consisting of a conventional size 3 mm diameter glassy carbon electrode (GCE) and of a pair of 30... more
The combined use of a dual-UV detector, a fluorimetric one and of a multiple electrochemical (EC) detector equipped with a dual electrode, consisting of a conventional size 3 mm diameter glassy carbon electrode (GCE) and of a pair of 30 μm thick carbon microfibers, is proposed for the determination of 15 amino acids, two dipeptides and creatinine. This online coupling of the above detection modes could partially replace amino acid analysis by derivatization methods, since it solves problems concerning the direct detection of selected underivatized amino acids. Additionally, it was proved that the use of multiple-detection allows positive peak identification in a single chromatographic run, yields more information for free amino acids and solves in some cases the problem of chromatographic resolution. In order to optimize the detection conditions of the underivatized amino acids and related compounds by different detectors, their detection characteristics were determined by adequate preliminary experiments. The electro-oxidation characteristics of the underivatized compounds of interest were determined by hydrodynamic voltammetry using a flow cell with a macrodisc GCE and by ex-situ voltammetry using both a GCE of conventional size and a carbon fiber disk microelectrode. Important practical advantages of microfiber and microdisk electrodes with respect to macroelectrodes were demonstrated.
Oxygen transfer is for two reasons a major concern in scale-up and process control in industrial application of aerobic fungal solid-state fermentation (SSF): 1) heat production is proportional to oxygen uptake and it is well known that... more
Zn was electrochemically deposited onto square TiN electrodes with edge dimensions of 490μm and 40μm. These were fabricated by standard microfabrication techniques, which provide an extremely reproducible electrode for experimentation.... more
Zn was electrochemically deposited onto square TiN electrodes with edge dimensions of 490μm and 40μm. These were fabricated by standard microfabrication techniques, which provide an extremely reproducible electrode for experimentation. Reliable constant-potential electrodeposition of Zn on the TiN was performed at −1.2V, just below the Zn/Zn2+ redox potential. At more negative potentials, the hydrogen evolution reaction on TiN interfered with
A technological process for growing multi-walled carbon nanotubes (CNTs) on the platinum electrodes of devices used for bio-sensing and cell recording and stimulation is presented. In order to ensure the biocompatibility of the devices,... more
A technological process for growing multi-walled carbon nanotubes (CNTs) on the platinum electrodes of devices used for bio-sensing and cell recording and stimulation is presented. In order to ensure the biocompatibility of the devices, platinum instead of other materials like iron, cobalt or nickel was used as CNT catalyst. SEM and HRTEM characterization show growth of high density of vertically aligned multi-walled CNTs on the electrodes.
To optimise the conditions for recording stable membrane potentials, epithelial cells of short-circuited toad bladders were impaled via either their apical or basolateral membranes. Microeletrode impalements via the apical membrane were... more
To optimise the conditions for recording stable membrane potentials, epithelial cells of short-circuited toad bladders were impaled via either their apical or basolateral membranes. Microeletrode impalements via the apical membrane were affected by impalement damage and were typically biphasic, consisting of an initial sharp increase in apical membrane potential (V sc of around −26mV), followed by a rapid depolarization of V sc towards 0 mV in the next 10–20 s. To facilitate basolateral impalement two different methods for mounting bladders were tested. Both mounting methods yielded similar values for V sc and R a/R b (the ratio of apical to basolateral membrane resistance) of around −57 mV and 5, respectively, which were larger than those recorded via the apical membrane and consistent with potential measurements from other tight epithelial tissues. Of the two basolateral mounting methods tested, the agar method gave the most stable impalements, making it possible to use amiloride and Ba2+ to assess for impalement damage. In conclusion, basolateral impalements of agar-mounted toad bladders makes this traditionally difficult tissue amenable to microelectrode studies.
