Mild Steel Bend
Mild Steel Bend
1. FOR LEGEND, ABBREVIATIONS AND GENERAL NOTES, SEE DWG NO:. SYA / STD / 001. 2. ALL DIMENSIONS ARE IN mm UNLESS OTHERWISE STATED. 3. THICKNESS OF TAPER AND BENDS SEE SCHEDULE OF STEEL PIPES/. FITTINGS THICKNESS. 4. FID REFERS TO FINISHED INTERNAL DIAMETER AFTER LINING. 5. MS PIPE SPECIAL ARE DESIGN IN ACCORDANCE TO BS EN 534:1990 6. ALL FLANGE ARE DESIGN TO PN 16 PRESSURE.
C L L
Y S
Y P O
B A
R
S A
E R T
R E S
D E V
H G I
REV. DESCRIPTION 1 ALL PIPES, BENDS AND TAPERS BELOW 600 DIA. TO BE USED FLANGE JOINT
SYABAS
PROJECT :
DRAWING TITLE :
DETAILS OF MILD STEEL PIPES, BENDS AND CONCENTRIC TAPERS DRAWN BY : SHAIFUL CHECKED : HS SCALE : NTS
DRAWING NO :
NOTE :
1. FOR LEGEND, ABBREVIATIONS AND GENERAL NOTES, SEE DWG. NO: SYA/STD/001. 2. ALL DIMENSIONS ARE IN mm UNLESS OTHERWISE STATED. 3. O.D REFERS TO OUTER DIAMETER. 4. THICKNESS OF TEE AND BENDS SEE SCHEDULE OF STEEL PIPES/ FITTINGS THICKNESS.
C L L
Y S
Y P O
B A
R
S A
E R T
R E S
D E V
H G I
REV. 1
SYABAS
PROJECT :
DRAWING TITLE :
NOTE :
1. FOR LEGEND, ABBREVIATION AND GENERAL NOTES, SEE DWG NO:. SYA/STD/001. 2. ALL DIMENSIONS ARE IN mm UNLESS OTHERWISE STATED. 3. THE OUTSIDE DIAMETER OF PIPE SHALL MEAN THE EXTERNAL DIAMETER OF STEEL PIPE BEFORE COATING.
C L L
Y S
Y P O
B A
R
S A
E R T
R E S
D E V
H G I
REV.
DESCRIPTION
DATE
SYABAS
PROJECT :
DRAWING TITLE :
NOTE :
1. FOR LEGEND, ABBREVIATION AND GENERAL NOTES, SEE DWG NO:. SYA/STD/001. 2. ALL DIMENSIONS ARE IN mm UNLESS OTHERWISE STATED. 3. THE OUTSIDE DIAMETER OF PIPE SHALL MEAN THE EXTERNAL DIAMETER OF STEEL PIPE BEFORE COATING.
C L L
Y S
Y P O
B A
R
S A
E R T
R E S
D E V
H G I
REV.
DESCRIPTION
DATE
S YABAS
PROJECT :
DRAWING TITLE :
NOTE :
1. FOR LEGEND, ABBREVIATION AND GENERAL NOTES, SEE DWG NO. SYA/STD/001. 2. ALL DIMENSIONS ARE IN mm UNLESS OTHERWISE STATED. 3. MASS CONCRETE GRADE 20/25. 2 4. ALLOWABLE BEARING PRESSURE = 75 KN/M. 5. TEST PRESSURE FOR THRUST BLOCKS IS BASED ON 100m HEAD OF WATER. 6. DIMENSIONS OF THRUST BLOCKS TO BE INCREASED IF ACTUAL BEARING PRESSURE IS FOUND TO BE LESS THAN 75 KN/M. 7. DIMENSIONS 'A' OF THRUST BLOCK TO BE ADJUSTED BY THE S.O. IF NECESSARY TO SUIT TRENCH WIDTH.
2
C L L
Y S
Y P O
B A
R
S A
E R T
R E S
D E V
H G I
REV.
DESCRIPTION
DATE
SYABAS
PROJECT :
DRAWING TITLE :