Professional Documents
Culture Documents
Manufacturing Technology Lab-II Viva Questions
Manufacturing Technology Lab-II Viva Questions
Viva Questions
4) Which of the following parameters govern the value of shear angle in continuous chip formation
a) becomes longer c) becomes smaller and finally does not form at all
a) 0 c) 20
b) 10 d) -10
9) In ASA system if the tool nomenclature is 8-6-5-5-10-15-2 mm then the side rake angle will
be (in degrees)
a) 5 c) 8
b) 6 d) 10
10) Relief angle on high speed steel tools usually vary from (in degress)
a) 0-3 c) 10-20
b 3-10 d) 20-30
11) cemented carbide tools are generally poor in shear
a)yes b)no
12) Back rake angle of a single point cutting tool is the angle by which the face of the tool is
inclined towards back
a) agree b) disagree
13) The part of the tool on which cutting edge is formed is called nose
a) right b) wrong
15) The angle between shear plane and____________ is called shear angle
a) true b) false
17) If the shear angle is large and the chip tool contact is low, then the tool life will be more
a) true b) false
19) The parameter which completely defines the chip formation in a metal cutting process
20) An important geometrical quantity in the cutting of metals which can be used as a criterion
a)right b)wrong
22) The cutting fluid mostly used for machining alloy steel is
a) water c) dry
a) 2 c) 5
b) 4 d) 7
roots
a) shaping b) casting
c) forming d) hobbing
a) shapping c)hobbing
b) milling d) burnishing
a) shearing c) a and b
38) The cutting speed is maximum while machining--------------------------- with a high speed steel
tool
b) mild steel
c) brass
39) Hard and tough materials like cast iron should be turned at
a) made by cold pressing of aluminium c) brittle and have low bending strength
oxide powder
d) all of these
b) available in the form of tips
a) toughness c) Elasticity
a) wattmeter c) hydrometer
b)Dynamometer d) pyrometer
48) For machining a mild steel work piece using carbide tool the maximum material will be
a) 50 c) 175
b 100 d) 275
49) For machining a mild steel work piece by a high speed steel tool, the average cutting speed is
-------( m/min)
a)10 c)22
b)15 d)30
50) For machining a cast iron work piece by a high speed steel tool, the average cutting speed is
-------( m/min)
a)10 c)22
b)15 d)30
Answer
1)c 2)a 3)d 4)d 5)c 6)a 7)a 8)c 9)b 10)d 11)a 12)a 13)b 14)c 15)a 16)a 17)a 18)d 19)c
20)c 21)a 22)d 23)a 24)d 25)c 26)d 27)a 28)c 29)a 30)b 31)d 32)d 33)b 34)b 35)c 36)d
37)a 38)d 39)a 40)d 41)d 42)c 43)d 44)d 45)d 46)d 47)b 48)b 49)d 50)c