Professional Documents
Culture Documents
Gsti 9105
Gsti 9105
Built-in intelligent microprocessor, the detector has strong ability of analysis and judgment. The detector automatically carries out system adjustment, compensation and variation of ambient data. Secure and speedy communication through the on board processor enables the detector to make its own decision, resulting in greater automation. The sensor and the panels utilized fuzzy logic providing an almost limitless cause and effect scenarios The detector is ideally suited to historical buildings, warehouses, large storages, shopping malls, leisure centres, exhibition halls, hotel lobbies, printing houses, clothing factories, museums and prisons, as well as places where slight smoke particles or corrosive gas exist. Technical Specifications Standards: BS EN54 Part-12 Approvals: LPCB, CE Protection Rating: IP20* Operating Voltage Power Voltage: 24Vdc (10%) Loop Voltage: 24Vdc Operating Current Standby current: 12mA Alarm current: 22mA Length of Optical Pathway: 8-100meter Monitoring width: 14m Monitoring Area: 1400m Operating Temperature: -10C to +50C Field Programmable Sensitivity: 2 levels Relative humidity: 95% Application: Indoor use Material and Colour: ABS, Gray Wiring: 1 pair -24Vdc, 1pair- loop Dimensions:206mmX95mmX95mm
Indication of Detector Status Commission: Green LED and Yellow LED are lit or flash in a sequence. Normal monitoring state: Red LED flashes periodically (with loop connected) Fire: Red LED constantly illuminates, and Yellow LED turns off. The fire signal has to be reset by the controller Fault: Yellow LED constantly illuminates.
Wiring and Connection Connect the wires to the required terminal according to the wiring diagram. The D1, D2 is for 24VDC power supply. The Z1, Z2 for loop. For conventional system K11,K12 for Fire output-normally open and K21,K22 for Fault output-normally close. The cable must be fire rated and the size depends on the distance and application. The minimum size gauge 1.0mm
For addressable Connection
I9105R
K22 K21 K12 K11 Z2 Z1 + D2 D1 +
24 VDC
LOOP IN
LOOP OUT
I9105R
K22 K21 K12 K11 Z2 Z1 + D2 D1 +
Mounting the Detector The Intelligent beam detector should be installed in compliance with all local codes having a jurisdiction in your area or NFPA 72 National Fire Alarm Code, NFPA 70 National Electrical Code, BS 5389 and EN54. The detector can be mounted in 2 ways: the installed onto standard two gang electrical box, or directly by drilling the holes and fixing with plugs.
470 Resistor 4.7K
24 VDC
Zone input
Selection of compatible Control Panels Compatible with all GST Intelligent Fire Alarm Panels GST200-2, GST5000, GST IFP8 Ordering Information:
Part No I-9105R Description Intelligent Reflector Beam Detector Weight /Kg 1.3 Pack Qty per Box 10