Accelerator Control System: Section
Accelerator Control System: Section
Accelerator Control System: Section
SECTION
ACC
ACC
CONTENTS
PRECAUTION ............................................... 2
PRECAUTIONS ................................................... 2
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" ................................................................... 2
ACC-1
PRECAUTIONS
< PRECAUTION >
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000010287580
The Supplemental Restraint System such as AIR BAG and SEAT BELT PRE-TENSIONER, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SR and SB section of
this Service Manual.
WARNING:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
ACC-2
INFOID:0000000009758117
ACC
JPBIA5259GB
1.
B.
Locating pin
2.
A.
Locating hook
INFOID:0000000009758118
REMOVAL
1.
2.
3.
Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
Disconnect the harness connector From the accelerator pedal assembly.
Loosen bolts and remove accelerator pedal assembly.
CAUTION:
Do not disassemble accelerator pedal assembly.
Do not remove accelerator pedal position sensor from accelerator pedal assembly.
Do not drop or impact the accelerator pedal assembly.
Do not expose the accelerator pedal assembly to water.
INSTALLATION
Inspection
INFOID:0000000009758119
ACC-3
ALBIA0798ZZ
For the electrical inspection of accelerator pedal position sensor. Refer to EC-138, "Work Procedure".
CAUTION:
Whenever the harness connector of accelerator pedal position sensor is disconnected, perform
ACCELERATOR PEDAL RELEASED POSITION LEARNING. Refer to EC-138, "Work Procedure".
The accelerator pedal should return smoothly to the fully raised position.
ACC-4
INFOID:0000000009758120
ACC
Unit: mm (in)
ALBIA0168GB
ACC-5