U15
U15
U15
Passive Components
Dr. R. Ramaprabha (Sec A)
PASSIVE COMPONENTS
Passive components are those that
do not have gain or directionality.
Resistors
Capacitors
Inductors
Fabrication of
RESISTORS
Methods:
Diffused Resistor
Epitaxial Resistor
Pinched Resistor
Thin Film Resistor
Diffused Resistor:
Formed in one of the isolated regions of epitaxial layer
during base or emitter diffusion
Common to bipolar transistor fabrication
Resistance value depends upon the surface geometry (length, width)
and upon the diffused impurity profile.
Advantage:
No extra fabrication needed.
Economical
Disadvantage:
Small range of resistances only possible.
Diffused Resistor:
SHEET RESISTANCE, Rs
The sheet resistance is a measure of resistance of thin films that
have a uniform thickness.
Rs=
Resistivity
t Thickness
L LengthandWidth
Base Resistor:
R=
R = Rs
EPITAXIAL RESISTOR:
PINCHED RESISTOR:
Advantage:
Pinched resistors can give resistances of order of
mega-ohm in a reasonably small area
PINCHED RESISTOR:
Working:
No current can flow through n-type material due to the
diode at contact 2 in the reverse direction.
Only a small reverse saturation current can flow through
n-material.
So, by creating this n-type region, the effective
cross-sectional area for the conduction path has been
reduced and thus resistance between 1 and 2 increases.
Vapour thin film deposition techniques can be used for the fabrication
of this resistor.
A very thin metallic film usually of Nichrome (NiCr) of thickness less than
1 misvapourdepositedontheSiO2 layer.
The ohmic contacts are made using Al metallization.
Advantages:
Thin film resistors have lesser and smaller parasitic components and
hence their frequency behaviour is better.
The values of thin film resistors can be easily adjusted even after
fabrication by cutting a part of the resistor with a laser beam. (Laser Trimming)
Thin film resistors have low temperature co-efficient, thereby making
them more stable.
Fabrication of
CAPACITORS
Methods:
Junction Capacitor
MOS and thin film Capacitor
JUNCTION CAPACITOR
Equivalent circuit:
Fabrication of INDUCTORS
IC devices are essentially two dimensional as the depth dimension is usually
very small (1 ~ 10 m)comparedtothelateraldimensions.
IC inductors can be made in the form of a flat metallic thin film spirals by
successive deposition of conduction patterns.
Very small values of inductance of the order of nano-henry with low quality
factor can be only obtained.
For any reasonable inductance value,a three-dimensional coil structure is
needed to obtain a large number of turns.