Hydrogen Oxygen Steam Generator Integrating With Renewable Energy Resource For Electricity Generation
Hydrogen Oxygen Steam Generator Integrating With Renewable Energy Resource For Electricity Generation
Hydrogen Oxygen Steam Generator Integrating With Renewable Energy Resource For Electricity Generation
com
Abstract
Renewable hydrogen energy system produces oxygen as by product from water electrolysis process, the produced
oxygen is vented out to the surrounding and not utilized. Hydrogen combustion with a stoichiometric ratio of pure
oxygen produces steam at a very high temperature, Steam temperature can be controlled by injection of liquid water
into the combustion chamber. The main objectives of this study is to utilize the oxygen and hydrogen produced from
water electrolysis using renewable energy resource in H2/O2 steam generator to supply steam for a turbine drive an
electric generator, and to study the feasibility of using H2/O2 steam generator with a steam turbine unit to provide
electric power as a primary or a secondary source of energy.
2012
2012Published by Elsevier
The Authors. Ltd.by
Published Selection
Elsevierand/or
Ltd. peer-review under responsibility of Canadian Hydrogen and
Fuel Cell Association Open access under CC BY-NC-ND license.
Selection and/or peer-review under responsibility of Canadian Hydrogen and Fuel Cell Association
1. Introduction
Global warming effect as a result of green house gases emissions from fossil fuels consumption, and
the unease about availability and prices of fossil fuels as well as large increase in energy demands have
boosted the requirements for developing the renewable energy resources. [1] Nowadays the conventional
technology to generate electricity is steam power plant which is either using fossil or nuclear fuels, and
gas turbine power plant which is using fossil fuels.
1876-6102 2012 Published by Elsevier Ltd. Selection and/or peer-review under responsibility of Canadian Hydrogen and Fuel Cell Association.
Open access under CC BY-NC-ND license. doi:10.1016/j.egypro.2012.09.003
Saif A. Alabbadi / Energy Procedia 29 (2012) 12 20 13
In steam power plant the steam is generated by burning fuel to heat up water. The combustion of pure
hydrogen and pure oxygen in a stoichiometric ratio is exothermic reaction and produce steam at very high
temperature, water can be added to the reaction to reduce the steam temperature for the desired
application. Hydrogen oxygen steam generator technology was derived from hydrogen oxygen
combustion in rocket technology. Hydrogen and oxygen can be produced from water electrolysis process
using renewable energy resource (solar energy, wind energy) or a combination of both depends on the
weather availability.
Nomenclature
The working principle of H2/O2 steam generator is taken from the H2/O2 rocket combustion
technology. The combustion of pure hydrogen and pure oxygen in a stoichiometric mixture produce
superheated steam (H2O) with a temperature reach in flame zone around 3000 0C [2], as shown in the
chemical equation below, for every two moles of hydrogen react with one mole of oxygen in combustion
chamber produce steam at high temperature in range 1000-1500 0C. [3]
14 Saif A. Alabbadi / Energy Procedia 29 (2012) 12 20
This reaction is highly exothermic therefore, liquid water is added to the reaction to reduce the steam
temperature, so it can be utilized in a steam turbine. Steam generator is a device to burn stoichiometric
mixture of hydrogen and oxygen in combustion chamber to produce high temperature superheated steam
Figure 1 shows hydrogen oxygen steam generator device. The mixture of hydrogen and oxygen are
ignited in the ignition chamber, then the combustion takes place in the combustion chamber, the
temperature controlled in the combustion chamber by liquid water injection, after that the steam compose
at evaporation chamber. The steam generator efficiency is 100% since no emissions and no thermal
losses. [2] Table 1 shows some steam characteristics produced by the hydrogen oxygen steam generator
and steam from the conventional method.
Table 1: steam characteristics produced by the H2/O2 steam generator and steam by the conventional method. [3]
Typical method of hydrogen and oxygen production is steam reforming of natural gas, and cryogenic
air separation respectively. Using renewable energy resource (wind or solar) in water electrolysis process
to produce hydrogen and oxygen from electrolyser, either alkaline or proton exchange membrane (PEM)
is effective method of production from free source of energy. The advantages are high purity of hydrogen
and oxygen, no CO2 emissions because no fossil fuel used, and reduces the cost of production of the
hydrogen and oxygen since the energy resource is free. One mole of water produces one mole of
hydrogen and half mole of oxygen from water electrolysis process. Theoretically, every one liter of water
produces 1.24 Nm3 of hydrogen and 0.62 Nm3 but actually the water utilization is 25% higher. [5]
4. System design
Figure 2: shows a schematic diagram of the H2/O2 steam turbine power unit integrated with renewable energy resource.
From figure 2 the components are renewable energy resource (solar or wind or combination of both),
electrolyser (alkaline or PEM), including electrolyser auxiliary unit (water pumps, gas drier, and
deoxidizer), hydrogen compressor, oxygen compressor, hydrogen storage system, oxygen storage system,
hydrogen and oxygen supply system, hydrogen oxygen steam generator, steam turbine, electric generator,
condenser, and the water reservoir.
The renewable energy resource provide electric power for the hydrogen and oxygen production unit
(electrolyser, auxiliary unit, compressors, and the storage system) then the hydrogen and oxygen are
supplied to the H2/O2 steam generator for steam production. Turbine is fed by steam to produce work for
electricity generation. The exhaust steam is passed through condenser then to the main water reservoir.
The oxygen production is equal to half of the hydrogen production and the oxygen mass flow rate
16 Saif A. Alabbadi / Energy Procedia 29 (2012) 12 20
supplied to the steam generator is equal to half of the hydrogen mass flow rate. The water mass flow rate
supplied to the reservoir from the condenser is bigger than the mass flow rate needed to control the
temperature in the combustion chamber consequently water is fed to the electrolyser to produce hydrogen
and oxygen again. The system operates as a closed cycle.
The turbine mechanical power should be 834 kW to supply 750 kW electrical power. Steam turbine
isentropic efficiency is determined by the manufacturer based on the interior design of the turbine.
Typical isentropic efficiency ranging from 20-90%, isentropic efficiency has been assumed to be 65 %,
according to the power output and the isentropic efficiency. The turbine inlet temperature, pressure, mass
flow rate, and exhaust pressure have been assumed to meet the power output and isentropic efficiency of
the steam turbine using turbine steam consumption calculator version 2.2, (2007) from Wayne Jayes and
Harvey Wilson, (free software).
From the steam turbine parameters, the hydrogen oxygen steam generator must supply steam at
pressure 6 MPa, and temperature 450 0C with a steam mass flow rate 1.6 kg/s these are the design
conditions. The temperature of the combusting gases (hydrogen and oxygen) is controlled by the number
of moles of the liquid water injected in the combustion chamber. Control volume of the steam generator
shown in figure 3.
This equation shows the stoichiometric reaction of (Z) moles of hydrogen and (Z/2) moles of oxygen
with (X) moles of liquid water to produce 88.89 mole per second of steam. The (X) means number moles
of the liquid water to be injected in the combustion chamber to reach the desired steam temperature.
Saif A. Alabbadi / Energy Procedia 29 (2012) 12 20 17
Solve the combustion equation for 450 0C of adiabatic flame temperature to find the moles number of
liquid water injected in the combustion chamber. The adiabatic flame temperature rise will be very small
due to the pressure increase. [6]
burn 36.74 g/s of hydrogen with 293.92 g/s of oxygen and 1269.36 g/s of injected water liquid to
produce 1600 g/s of steam at 450 0C.
The steam pressure is determined by sizing the exit orifice diameter of the H2/O2 steam generator,
since the combusted gases follow the compressible flow. Critical flow (choked flow) of compressible gas
is defined that the flow result when the ratio of the back pressure to the chamber pressure is less than the
critical pressure ratio which is equal to 0.528 for the ideal gases, this also mean that the flow velocity at
the exit of the orifice is one Mach (sonic flow). The flow through the orifice is assumed to be isentropic,
adiabatic, and frictionless.
To/T = 1 + ((K-1)/2) M2
P = 0.54 Po ............................................................................................................................................(6)
T = 0.86 To ............................................................................................................................................(7)
Substitute equations 6 and 7 in equation 5, then the equation of the mass flow rate through the orifice
become
The flow velocity inside the combustion chamber is assumed to be zero, consequently the stagnation
pressure and temperature is the same as the static pressure and temperature. Substitute in the above
equation for the mass flow rate is 1.6 kg/s, pressure 6 MPa, and the temperature 723 K. The diameter
needed is 17 mm .
5. Conclusion
This study has been focused exclusively on the design of the hydrogen oxygen steam generator
connected to a steam turbine drive an electric generator to supply electrical power as a secondary or
primary source of energy. The work presented in this study leads to clear understanding for the working
principle of the hydrogen oxygen steam generator.
The hydrogen and oxygen are produced from water electrolysis using renewable energy resource. The
hydrogen oxygen steam generator design is defined by finding the steam exit temperature, pressure, and
the steam mass flow rate. These parameters were determined according to the turbine operation
conditions. The steam temperature can be controlled based on the moles number of the liquid water
injected inside the combustion chamber, and the steam pressure depends on the sizing of the exit orifice.
The thermal and overall efficiency can be enhanced only by increasing the inlet pressure, temperature,
turbine isentropic efficiency, and electric generator efficiency together and reduce the exit pressure from
the turbine, because that will reduce the steam consumption which means that will reduce the mass flow
rate of the hydrogen and oxygen entering the combustion chamber.
References
[1] JANON, A. (2009) Wind-Hydrogen Energy Systems for Remote Area Power Supply. Unpublished thesis (PhD).
Melbourne: Royal Melbourne Institute of Technology University.
[2] SHERIF, S.A. BARBIR, F. and VEZIROGLU, T. N (2005) Wind Energy and Hydrogen Economy- Review of the
Technology, Solar Energy, 78, 647-660
[3] MALYSHENKO, S. GRYZANOV, A. and FILATOV, N. (2004) High Pressure H2/O2 Steam Generators and Their
possible Applications, International Journal of Hydrogen Energy, 29, 589-596.
[4] HAIDN, O. J. et al (1998) Improved Combustion Efficiency of A H 2/O2 Steam generator fro Spinning Reserve
Applications, International Journal of Hydrogen Energy, 23, 491-497.
[5] BARBIR, F. (2005) PEM Electrolysis for Production of Hydrogen from Renewable Energy Resource, Solar Energy, 78,
661-669
[6] GLASSMAN, I. and YETTER, R. (2008) Combustion. 4th ed. Oxford: Elsevier.
20 Saif A. Alabbadi / Energy Procedia 29 (2012) 12 20
Bibliography
CENGEL, Y. A. and BOLES, M. A. (2006) Thermodynamics an Engineering Approach. 5th ed. New York: McGraw-Hill.
HAIDN, O. J. et al (1998) Improved Combustion Efficiency of A H 2/O2 Steam generator fro Spinning Reserve Applications,
International Journal of Hydrogen Energy, 23, 491-497.
MIDILLI, A. et al. (2005) On hydrogen and Hydrogen Energy Strategies Current Status and Needs, Renewable and
Sustainable Energy Reviews, 9, 255-271.
NEAGU, C et al. (2000) The Electrolysis of Water: An Actuation principles for MEMS with a Big Opportunity, Mechatronics,
10, 571-581.
SONNTAG, R. BORGNAKKE, C. and VAN WYLEN, G. (1998) Fundamentals of Thermodynamics. 5th ed. New York: John
Wiley and Sons.
STERNFELD, H. J. (1995) Capacity Control of Power Stations by H 2/O2 Rocket Combuster Technology, Acta Astronautica,
37, 11-19.