Professional Documents
Culture Documents
P I F 3000 PSI B A: Recharging Nstructions OR Ladder Ccumulators
P I F 3000 PSI B A: Recharging Nstructions OR Ladder Ccumulators
1. Remove the protective cap and the seal cap. 2. Close the bleed valve on the charging and gauging 3. Install Charging and Gauging Assembly on the 4. Remove the seal cap from the gas charging tank
assembly.Retract the T-handle on the air chuck by accumulator by screwing the air chuck to the gas valve and connect the swivel connector on the hose
turning counter clockwise direction. valve and tighten sufficiently to prevent any leakage. assembly. Hand tighten sufficiently to prevent leakage.
Turn the T-handle on the air chuck clockwise to
depress the valve core. Connect the hose to the
nitrogen bottle regulator.
5. Open the regulator valve on the nitrogen bottle carefully to let nitrogen flow at a slow rate into the accumulator. Proceed to charge until the accumulator reaches desired precharge pressure. Close the regulator and let the
nitrogen stabilize and obtain gauge reading. Adjust the pressure if necessary.
6. Retract the T handle on the air chuck by turning 7. Open the bleed valve to bleed of nitrogen in the 8. Check for leakage through the valve core by soap 9. Replace the valve seal cap and the protective cap.
counter clockwise to close the valve core. hose. Disconnect the charging assembly from the solution or snoop. If the core is leaking, then retighten
accumulator and the gas bottle. the valve core to 4 in-lb torque. If leakage persists then
replace the valve adapter.
10. Check precharge pressure once in the first week of operation, and then every six months during normal working or every month during high cycling or high temperature condition.
1. Remove the protective cap and the seal cap. 2. Close the bleed valve on the charging and gauging 3. Install Charging and Gauging Assembly on the 4. Remove the seal cap from the gas charging tank
assembly. Retract the T-handle on the air chuck by accumulator by screwing the charging block directly valve and connect the swivel connector on the hose
turning counter clockwise direction. on to the bladder valve stem. Hand tighten sufficiently assembly. Hand tighten sufficiently to prevent
to prevent any leakage. Turn the T-handle on the block leakage.
clockwise to depress the valve core. Connect the
hose to the nitrogen bottle regulator.
5. Open the regulator valve on the nitrogen bottle carefully to let nitrogen flow at a slow rate into the accumulator. Proceed to charge until the accumulator reaches desired precharge pressure. Close the regulator and let the
nitrogen stabilize and obtain gauge reading. Adjust the pressure if necessary.
6. Retract the T handle on the block by turning counter 7. Open the bleed valve to bleed off nitrogen in the 8. Check for leakage through the valve core by soap 9. Replace the valve seal cap and the valve guard.
clockwise to close the valve core. hose. Disconnect the charging assembly from the solution or snoop. If the core is leaking, then retighten
accumulator and the gas bottle. the valve core to 4 in-lb torque. If leakage persists
then replace the valve adapter.
10. Check precharge pressure once in the first week of operation, and then every six months during normal working or every month during high cycling or high temperature condition.
11505 West Little York Houston, Texas 77041 Tel: (713) 937-8900 Fax: (713) 937-0438
copyright 1997 OilAir Hydraulics, Inc. Printed in USA Bulletin #MM3-97
OLAER GROUP COMPANY